Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability. Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory. | |
A. | Both A and R are correct and R is correct explanation of A [Correct Answer] |
B. | Both A and R are correct but R is not correct explanation of A [Wrong Answer] |
C. | A is correct but R is wrong [Wrong Answer] |
D. | R is correct but A is wrong [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above
⇒ Permeability is analogous to
resistivity
retentivity
conductivity
coercivity
⇒ The distance of a direct broadcasting satellite from earth's surface is about
1000 km
10000 km
36000 km
55000 km
⇒
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ The scale of a dynamometer is linear when used as
ammeter
voltmeter
wattmeter
both (a) and (c)
⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4
⇒ When a binary adder is used as BCD adder, the sum is
correct when it is < 9
correct when it is > 9
correct when it is < 16
none of these
⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease
⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f^{2}
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink
⇒ The fetching, decoding and executing of an instruction is broken down into several time intervals. Each of these intervals, involving one or more clock periods, is called a
instruction cycle
machine cycle
process cycle
none of the above
⇒ In fi
the collector currents of T_{1} and T_{2} are equal
the collector current of T_{1} is more than that of T_{2}
the collector current of T_{1} is double that of T_{2}
the collector currents of T_{2} is more than that of T_{1}
⇒ Computer communication networks have
star configuration
tree configuration
loop/mesh configuration
All of the above
⇒ For a stable system
both phase and gain margin are negative
both phase and gain margin are positive
phase margin is positive but gain margin is negative
gain margin is positive but phase margin is negative
⇒ A mod-2 counter followed by a mod 5 is same as
mod-7 counter
A decade counter
mod-3 counter
none
⇒
A-1, B-2, C-3, D-4
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-4, B-1, C-2, D-3
⇒ In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of
1 H
2 H
3 H
4 H
⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)
⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point
⇒ μ_{0} = 8.85 x 10^{-12}F/m.
TRUE
FALSE
⇒ The message carrying efficiency is best in
AM
FM
AM-SC
Phase modulation
⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8
⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected
⇒ The following program starts at location 0
20 H
02 H
00 H
FFH
⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω
⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit
⇒ Consider the frequency modulated signal 10 cos (2p x 10^{5}t + 5 sin (2p x 1500t) + 7.5 sin (2p x 1000t) with carrier frequency of 10^{5}Hz. The modulation index is
12.5
10
7.5
5
⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter
⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω
⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)
⇒ Which of the following are the non-linear application of op-amp?
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4
⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above
⇒ Permeability is analogous to
resistivity
retentivity
conductivity
coercivity
⇒ The distance of a direct broadcasting satellite from earth's surface is about
1000 km
10000 km
36000 km
55000 km
⇒
Assertion (A): Manufacturer's quote h parameters of transistor
Reason (R): h parameters of a transistor are easiest to measure
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct
⇒ The scale of a dynamometer is linear when used as
ammeter
voltmeter
wattmeter
both (a) and (c)
⇒ The output resistance of a microphone is 20 ohms. It is to feed a line of impedance 320 ohms. To ensure maximum power transfer, the turn ratio of transformer is
16
256
2
4
⇒ When a binary adder is used as BCD adder, the sum is
correct when it is < 9
correct when it is > 9
correct when it is < 16
none of these
⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease
⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f^{2}
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink
⇒ The fetching, decoding and executing of an instruction is broken down into several time intervals. Each of these intervals, involving one or more clock periods, is called a
instruction cycle
machine cycle
process cycle
none of the above
⇒ In fi
the collector currents of T_{1} and T_{2} are equal
the collector current of T_{1} is more than that of T_{2}
the collector current of T_{1} is double that of T_{2}
the collector currents of T_{2} is more than that of T_{1}
⇒ Computer communication networks have
star configuration
tree configuration
loop/mesh configuration
All of the above
⇒ For a stable system
both phase and gain margin are negative
both phase and gain margin are positive
phase margin is positive but gain margin is negative
gain margin is positive but phase margin is negative
⇒ A mod-2 counter followed by a mod 5 is same as
mod-7 counter
A decade counter
mod-3 counter
none
⇒
Match the following:
List I (Laws of Boolean) | List II (Relation algebra) | ||
---|---|---|---|
A. | Distributive law | 1. | x + x = x |
B. | DeMorgans law | 2. | x(y + z) = xy + xz |
C. | Idempotent law | 3. | (x) = x |
D. | Involution law | 4. | (x + y) = xy |
A-1, B-2, C-3, D-4
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-4, B-1, C-2, D-3
⇒ In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of
1 H
2 H
3 H
4 H
⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)
⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point
⇒ μ_{0} = 8.85 x 10^{-12}F/m.
TRUE
FALSE
⇒ The message carrying efficiency is best in
AM
FM
AM-SC
Phase modulation
⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8
⇒ A channel has a SNR of 7 and BW 4 kHz. Keeping the channel capacity (BPS) same, the BW is reduced to accommodate more channels. The SNR
decreases
increases
remains same
partially affected
⇒ The following program starts at location 0
20 H
02 H
00 H
FFH
⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω
⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit
⇒ Consider the frequency modulated signal 10 cos (2p x 10^{5}t + 5 sin (2p x 1500t) + 7.5 sin (2p x 1000t) with carrier frequency of 10^{5}Hz. The modulation index is
12.5
10
7.5
5
⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter
⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω
⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)
⇒ Which of the following are the non-linear application of op-amp?
- Current-to-voltage converter
- Comparator
- Peak detector
- Limiter
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4