Question is ⇒ Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.Reason (R): For a type of system velocity error is zero., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct but R is wrong, (D) R is correct but A is wrong, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.Reason (R): For a type of system velocity error is zero., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is correct but R is wrong, (D) R is correct but A is wrong, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input. Reason (R): For a type of system velocity error is zero.
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Correct Answer]
C.	A is correct but R is wrong [Wrong Answer]
D.	R is correct but A is wrong [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The minimum number of NAND gates required to implement the Boolean function A +AB + ABC is equal to
0
1
4
7

⇒ In metals the thermal conductivity K and electrical conductivity σ are related as (K/σT) = L, L is known as
Lattice constant
Lorentz number
Lanevin function
Larmor number

⇒ In equally tampered scale, frequency of each tone equals the frequency of lower adjacent tone multiplied by
(2)^1/7
(2)^1/12
(2)^1/6
(2)^1/5

⇒ The function shown in the fig
impulse function
signum function
unit step function
none of the above

⇒ Which memory does not require programming equipment?
RAM
EPROM
EEPROM
UVPROM

⇒ An increase in ambient temperature means that maximum power rating of transistor
will increase
will decrease
may increase or decrease
may increase or remain the same

⇒ The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.
TRUE
FALSE

⇒ The energy of constant amplitude complex valued exponential sequence is ...
A²
∞
1
0

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ For an P-N-P transistor in normal operation its junction are biased as
emitter base : reverse, collector base : forward
emitter base : forward, collector base : reverse
emitter base : forward, collector base : forward
emitter base : reverse, collector base : reverse

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒ Figure shows a chopper feeding RLE load, The free wheeling diode conducts w
thyristor is on
thyristor is off
both when thyristor is on and thyristor is off
partly when thyristor is off and partly when thyristor is on

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ Complex pole in z-plane is as shown below. This is the pole diagram for ________
Decaying sinusoidal sequence
Growing sinusoidal sequence
Decaying non sinusoidal sequence
Growing non sinusoidal sequence

⇒ A carrier wave carries information.
TRUE
FALSE

⇒ Harmonic distortion analyser
measures amplitude of each harmonic
measures rms value of fundamental frequency component
measures rms value of all harmonics except fundamental frequency
displays rms value of each harmonic on screen of CRO

⇒ A logarithmic amplifier has diode in the feedback path.
TRUE
FALSE

⇒ Consider the following statements about a good power supply:

The a.c. ripple should be high
S_v, (Voltage stability factor) should be low
S_T, (Temperature stability factor) should be low

Which of the above statements are correct?
1, 2 and 3
2 only
3 only
2 and 3 only

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒

Assertion (A): The Laplace transform of a ramp is 1/s².

Reason (R): The integral of a unit step function gives an impulse function.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
0.6
0.25
4
0.36

⇒ Class A and class B chopper
operate in first quadrant
operate in second quadrant
class A chopper operates in first quadrant while class B operates in second quadrant
may operate in either first or second quadrant

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ In cellphone communication base antennas are connected to other base antennas in
line of sight communication
ionospheric propagation
ground wave propagation
medium wave propagation

⇒ FM broadcast lies in which band?
HF
SHF
UHF
VHF

⇒ For an R-C impedance function, the residues at all poles are
real
imaginary
real and positive
positive

⇒

Match the following:

	List I		List II
A.	Poles and zeros of lie an real axis driving point LC network	1.	lie an real axis
B.	Canonic LC network has	2.	a zero
C.	The number of Canonic networks for the given driving point function	3.	minimum number of elements
D.	The first critical frequency nearest the origin for RL driving point impedance	4.	four
		5.	minimum number of elements
		6.	alternate
		7.	either a pole or zero
		8.	three

A-1, B-5, C-8, D-7
A-6, B-5, C-3, D-2
A-1, B-5, C-4, D-2
A-1, B-3, C-4, D-7