Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): In active region of CE output characteristics of BJT, collector current is nearly constant. Reason (R): Base current in CE connection is very small. | |
A. | Both A and R are true and R is correct explanation of A [Correct Answer] |
B. | Both A and R are true but R is not a correct explanation of A [Wrong Answer] |
C. | A is true but R is false [Wrong Answer] |
D. | A is false but R is true [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^{-128} each
2^{-28} and 2^{-127}
2^{-127} and 2^{-128}
2^{-127}each
⇒ Consider the following two statements about the internal conditions in an n-channel MOSFET operating in the active re
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, but S2 is not a reason for S1
Both S1 and S2 are true, and S2 is a reason for S1
⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE
⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE
⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_{R} = 1V, R = 1 MΩ and R_{f} = 10KΩ
0.99 V
0.9 V
0.1 V
0
⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C
⇒ A capacitor stores 0.15C at 5 V. Its capacitance is
0.75 F
0.75 μF
0.03 F
0.03 μF
⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above
⇒ In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
equal
different
equal or different
different but sometimes equal
⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers
⇒ The scale of a dynamometer is linear when used as
ammeter
voltmeter
wattmeter
both (a) and (c)
⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above
⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems
⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above
⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle
⇒ In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
total transmitted power, bandwidth
bandwidth, bandwidth
bandwidth, total transmitted power
total transmitted power, sideband power
⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above
⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these
⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK
⇒ With I_{s} disconnected I = - 1, when I_{s} = b is connected, the value of I will be
0.0833333333333333
-1 A
0.0416666666666667
0.125
⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A
⇒ The modulation of effective base width by collector voltage is known as Early effect, hence reverse collector voltage
increases both a and β
decrease both a and β
increase a but decrease β
decrease a but increase β
⇒ In 8085 the data is stored in the stack on
First in First Out basis
Last in First Out basis
First in Last Out basis
Last in Last Out basis
⇒ For a series resonant circuit at low frequency impedance is __________ and at high frequency circuit impedance is __________ .
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive
⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W
⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)
⇒ The material used in RTD is
linear
aluminium
silver
platinum
⇒ The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a
thermocouple
transducer
chopper
rectifier
⇒ When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
ac saturation and ac cut off points
ac operating and ac cut off points
ac saturation and ac operating points
none of the above
⇒ In the network shown in figure, the voltage drops across R_{2} and R_{3} are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0is 9 A and directed away from node 0is 9 A but directed of current cannot be foundis impossible to be found}
⇒ For 8 bit representation the minimum positive and minimum negative numbers are
2^{-128} each
2^{-28} and 2^{-127}
2^{-127} and 2^{-128}
2^{-127}each
⇒ Consider the following two statements about the internal conditions in an n-channel MOSFET operating in the active re
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, but S2 is not a reason for S1
Both S1 and S2 are true, and S2 is a reason for S1
⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE
⇒ If a complex voltage wave is applied to a pure inductance, the resulting current wave is much smoother than the voltage wave.
TRUE
FALSE
⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_{R} = 1V, R = 1 MΩ and R_{f} = 10KΩ
0.99 V
0.9 V
0.1 V
0
⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C
⇒ A capacitor stores 0.15C at 5 V. Its capacitance is
0.75 F
0.75 μF
0.03 F
0.03 μF
⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above
⇒ In a single phase full wave regulator, the firing angles in the positive and negative half cycles are generally
equal
different
equal or different
different but sometimes equal
⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers
⇒ The scale of a dynamometer is linear when used as
ammeter
voltmeter
wattmeter
both (a) and (c)
⇒ For maximum transfer of power, internal resistance of the source should be
equal to load resistance
less than the load resistance
greater than the load resistance
none of the above
⇒ Principle of superposition is applicable to
linear systems only
nonlinear systems only
both linear and non linear system
linear systems and some nonlinear systems
⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above
⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle
⇒ In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
total transmitted power, bandwidth
bandwidth, bandwidth
bandwidth, total transmitted power
total transmitted power, sideband power
⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above
⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these
⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK
⇒ With I_{s} disconnected I = - 1, when I_{s} = b is connected, the value of I will be
0.0833333333333333
-1 A
0.0416666666666667
0.125
⇒ Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than
50 A
37.5 A
25 A
40 A
⇒ The modulation of effective base width by collector voltage is known as Early effect, hence reverse collector voltage
increases both a and β
decrease both a and β
increase a but decrease β
decrease a but increase β
⇒ In 8085 the data is stored in the stack on
First in First Out basis
Last in First Out basis
First in Last Out basis
Last in Last Out basis
⇒ For a series resonant circuit at low frequency impedance is __________ and at high frequency circuit impedance is __________ .
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive
⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88 W
7.3 W
73 W
⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)
⇒ The material used in RTD is
linear
aluminium
silver
platinum
⇒ The D'Arsonval- movement can be converted into audio frequency ac ammeter by adding a
thermocouple
transducer
chopper
rectifier
⇒ When the ac input signal is very large the instantaneous operating point CE amplifier moves all the way between
ac saturation and ac cut off points
ac operating and ac cut off points
ac saturation and ac operating points
none of the above
⇒ In the network shown in figure, the voltage drops across R_{2} and R_{3} are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0is 9 A and directed away from node 0is 9 A but directed of current cannot be foundis impossible to be found}