Question is ⇒ Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Correct Answer]
C.	A is true, R is false [Wrong Answer]
D.	A is false, R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒

Match the following:

	List I		List II
A.	Darlington amplifier	1.	A circuit using pnp and npn transistors
B.	CB amplifier	2.	A CS amplifier driving a CG amplifier
C.	Cascade amplifier	3.	A circuit with over-all voltage gain close to 1 and very large input impedance
D.	Complementary symmetry amplifier	4.	A circuit with low input impedance

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ Given that the band gap of cadmium sulphide is 2.5 eV, the maximum photon wavelength, for e^--hole pair generation will be
5400 mm
540 mm
5400 Å
540 Å

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ The process of entering data into ROM is called
writing
burning
decoding
registering

⇒ If the functions w, x, y, z are as foll
w = z x = z
w = z, x = y
w = y
w = y = z

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase-shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ Secondary emission occurs in
diode
triode
tetrode
pentode

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ The efficiency of a horn speaker is about
0.1
0.4
0.6
0.8

⇒ The V-i relation for a varistor is
i = kvⁿ
v = kiⁿ
i = kv³
v = ki³

⇒ The equivalent circuit shown in figure is
CE
CB
CC
None of the above

⇒ Which has the highest power dissipation per gate?
ECL
TTL
CMOS
PMOS

⇒ If u is input, y is output and a, b are constants, the system y = au + b
is linear
is nonlinear
may be linear or nonlinear dependig on values of a and b
may be linear or nonlinear depending on value of u

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ As per Matthiessen's rule, the total resistivity r of a conductor can be written as r = r_i + aT, where r_i and a are constants and T is absolute temperature. At very low temperatures
aT = 0
aT > r_i
aT ∼ r_i
aT < r_i

⇒ A single phase semiconverter is supplying RLE load and has a freewheeling diode across the load. The firing angle is a. The freewheeling diode conducts for
a° in each half cycle
(p - a)° in each cycle
a° in one full cycle
(p + a)° in each half cycle

⇒ The slope of log magnitude asymptote changes by - 40 dB/ decade at a certain frequency and the error between asymptote and actual curve is - 6 dB. This means that
a double pole is present
a pair of complex conjugate poles is present
either a double pole or a pair of complex conjugate poles is present
either a pole or zero at that frequency is present

⇒ Pulse modulation is often used in
microwave band
FL band
telegraphy
telephony

⇒ To avoid creep in an energy meter
two shading bands are put on shunt magnet
two shading bands are put on series magnet
two holes are cut in the disc on opposite sides of spindle
the potential coil is made of very thin wire

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ In intrinsic semiconductors, the number of free electrons is equal to the number of mobile holes.
TRUE
FALSE

⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ Consider the following statements about diamagnetic material and diamagnetism.

The materials have negative magnetic susceptibility.
At very low temperature diamagnetic materials.

Which of the statements given above is/are correct?
1 only
2 only
Both 1 and 2
neither 1 nor 2

⇒ For an m-derived filter, attenuation is infinite when f = f_∞.
TRUE
FALSE