Question is ⇒ Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect themReason (R): VOH, VOL, VIH and VIL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. VIL and VIH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect themReason (R): VOH, VOL, VIH and VIL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. VIL and VIH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Even if TTL gates and CMOS gates used in a realization have the same power supply of + 5 V, suitable circuit is needed to interconnect them Reason (R): V_OH, V_OL, V_IH and V_IL of a TTL gave are respectively 2.4, 0.4, 2 and 0.8 V respectively. If supply voltage is + 5 V. V_IL and V_IH for CMOS gate for the supply voltage of + 5 V are 1.5 V and 3.5 V respectively.
A.	Both A and R are correct and R is correct explanation of A [Correct Answer]
B.	Both A and R are correct but R is not correct explanation of A [Wrong Answer]
C.	A is true, R is false [Wrong Answer]
D.	A is false, R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Vividh Bharati programme is transmitted in
short wave
medium frequency
very high frequency
all of the above

⇒ The input impedance of short-circuited line of length l where l < λ/4
inductive
capacitive
resistive
none of the above

⇒ In CE connection, the leakage current of a transistor is about
10 x 10^-9 A
5 x 10^-6 A
200 x 10^-6 A
5 x 10^-3 A

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒ Which of the following are the non-linear application of op-amp?

Current-to-voltage converter
Comparator
Peak detector
Limiter

Select the correct answer from the codes given below:
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ The storage capacity of audio CD is 540 Mb per side.
TRUE
FALSE

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒ A plot of modulation index vs carrier amplitude yields a
horizontal line
vertical line
parabola
hyperbola

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ The bridge is balanced when the value of R is
50 Ω
100 Ω
200 Ω
250 Ω

⇒ Which device changes serial data to parallel data?
Counter
Multiplexer
Demultiplexer
Flip flop

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ Two numbers are 131 ± 5 and 629 ± 3. The sum of the numbers with range of doubt is
760 ± 8
760 ± 2
760 + 8
760 - 8

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒ An electron in the conduction band
has higher energy than the electron in the valence band
has lower energy than the electron in the valence band
loses its charge easily
jumps to the top of the crystal

⇒ A circuit said to be lumped when physical dimensions of all the component are __________ .
greater compared with wavelength of electromagnetic signal
small compared with wavelength electromagnetic signal
negligible compared with wavelength of electromagnetic signal
equal compared with wavelength of electromagnetic signal

⇒ State variable formulation is very suitable for computer solution.
TRUE
FALSE

⇒ In a four variable Karnaugh map, eight adjacent cells give a
two variable term
single variable term
three variable term
four variable term

⇒ Consider the following program in Pascal 2
2.6
2.63
26.3

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ For a parallel two wire line with both conductors touching each other, the characteristic impedance is about
300 Ω
200 Ω
80 Ω
24 Ω

⇒ In a series RLC high Q circuit the current peaks at a frequency.
equal to the resonant frequency
greater than the resonant frequency
less than the resonant frequency
none

⇒ Epitaxial growth is used in ICs
because it produces low parasitic capacitance
because it yields back to back isolating pn junction
to grow single crystal n doped silicon on a single crystal p type substrate
to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒

Assertion (A): In C arithmetic operations are pemiissible on ints, floats and chars.

Reason (R): In C every arithmetic operator must be written explicitly.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Ac signals are given to both inverting and non-inverting terminals of an op-amp. When will the output maximum
when the phase difference between the inputs is 0°
when the phase difference between the inputs in 90°
when the phase difference between the inputs is 180°
when the phase difference between the inputs is 0 or 180°

⇒ A system is said to be marginal stable if
poles lies on Real axis
zero lies on Real axis
poles lies on Imaginary axis
zeros lies on origin