Question is ⇒ Assertion (A): Damping in a vibration galvanometer is small.Reason (R): Vibration galvanometer is a PMMC instrument., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true R is false, (D) A is false R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Damping in a vibration galvanometer is small.Reason (R): Vibration galvanometer is a PMMC instrument., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true R is false, (D) A is false R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Damping in a vibration galvanometer is small. Reason (R): Vibration galvanometer is a PMMC instrument.
A.	Both A and R are true and R is correct explanation of A [Wrong Answer]
B.	Both A and R are true but R is not correct explanation of A [Correct Answer]
C.	A is true R is false [Wrong Answer]
D.	A is false R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ Which of the following is the fastest switching device?
JFET
BJT
MOSFET
Triode

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ In a virgin specimen of iron, the direction of spontaneous magnetisation varies from domain to domain.
TRUE
FALSE

⇒ The resistance values of a PIN diode under positive bias and negative bias respectively are about
a few ohms and a kilo ohms
about 100 ohms and 1000 ohms
about 0.1 ohm and 100 ohms
about 1000 ohms and 10000 ohms

⇒ In a transistor push pull amplifier
there is no dc present in the output
there are no even harmonics in the output
both (a) and (b)
neither (a) nor (b)

⇒ The carrier frequency will be if L = 50 µH and C = 1 nF.
512
612 kHz
712 kHz
812 kHz

⇒ From which instant is the turn off time of a thyristor defined
when anode voltage becomes zero
when anode current becomes zero
when both anode voltage and current become zero
none of the above

⇒ Which of the following couplings may cause unwanted clamping?
Resistive
Inductive
Capacitive
Both (a) or (b)

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ In which of the following 8085 instructions is the 8 bit number in accumulator adjusted to form two four bit BCD numbers
DAD rp
DAA
DCX rp
ADC M

⇒ Pico-farad is equal to
10^-6 farad
10^-12 farad
10^-3 farad
10^-9 farad

⇒ Cells are connected in series to increase
current-rating
both voltage and current rating
the life of cell
voltage rating

⇒ The most suitable method for detecting a modulated signal g(t) = (3 to 6 cos 2pf_mt) cos 2pf_ct is
envelope detector
synchronous detector
ratio detector
both a and b

⇒

Match the following:

	List I (F.T and F.S)		List II (Properties)
A.	Fourier Series	1.	Discrete, Periodic
B.	Fourier Transform	2.	Continuous, Periodic
C.	Discrete Time Fourier	3.	Discrete aperiodic
D.	Discrete Fourier Transform	4.	Continuous, aperiodic

A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1
A-1, B-4, C-2, D-3

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒

Assertion (A): Moving iron instrument can be used on ac or dc.

Reason (R): In a moving iron instrument deflecting torque is proportional to square of current.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In a JK master slave flip flop
master is clocked when clock is low
slave is clocked when clock is high
master is clocked when clock is high and slave is clocked when clock is low
master is clocked when clock is low and slave is clocked when clock is high

⇒ Which of the following is invalid in Basic?
A ** B + - C
A ** B - C
A * B - C
A * B - C ** D

⇒ Resistivity of rubber is about
10² Ω-m
10^-2 Ω-m
5 x 10⁸ Ω m
5 x 10¹² Ω-m

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ A push pull amplifier is a
power amplifier
voltage amplifier
current amplifier
both power and current amplifier

⇒ In root locus analysis the breakaway and break in points
lie on the real axis
either lie on the real axis or occur in complex conjugate pairs
always occur in complex conjugate pairs
none of the above

⇒ A 4 bit modulo 16 ripple counter uses JK flip-flops. If the propagation delay of each FF is 50 ns. The max. clock frequency that can be used is equal to
20 MHz
10 MHz
5 MHz
4 MHz

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ The decimal equivalent of ABC₁₆ is
348
2583
2748
33

⇒ Find equivalent capacitance if each capacitance is
5/12 F
12/5 F
6/5 F
5/6 F

⇒ For stable network the real parts of poles and zeros of driving point functions must be
negative
negative or zero
zero
positive

⇒ A JFET is a
unipolar device
bipolar device
tripolar device
none of the above

⇒ The number of programmable 16 bit registers of 6800 are
2
3
4
5