Question is ⇒ Assertion (A): A tuned amplifier uses a parallel tuned circuitReason (R): A tuned amplifier is used to amplify a narrowband frequencies, Options are ⇒ (A) Both A and R are correct and R is correct explanation for A, (B) Both A and R are correct but R is not correct explanation for A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): A tuned amplifier uses a parallel tuned circuitReason (R): A tuned amplifier is used to amplify a narrowband frequencies, Options are ⇒ (A) Both A and R are correct and R is correct explanation for A, (B) Both A and R are correct but R is not correct explanation for A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): A tuned amplifier uses a parallel tuned circuit Reason (R): A tuned amplifier is used to amplify a narrowband frequencies
A.	Both A and R are correct and R is correct explanation for A [Correct Answer]
B.	Both A and R are correct but R is not correct explanation for A [Wrong Answer]
C.	A is correct R is wrong [Wrong Answer]
D.	A is wrong R is correct [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ It is required to measure a low magnitude high frequency current. The proper instrument is
moving iron
dynamometer
thermocouple
induction

⇒ The sum of two or more arbitrary sinusoidal is
always periodic
periodic under certain conditions
never periodic
periodic only if all the sinusoidals are identical in frequency and phase

⇒ A low noise device is most important
at front end of equipment
in the last stage of equipment
in the middle stages of equipment
both (b) and (c)

⇒ Mark the false statement:
since wave-shape of a digital signal is unimportant, linear amplifiers are not required
the precise amplitude of a digital signal is also unimportant provided two voltage levels (0 and 1) are quite different
the leading and trailing edges of a digital signal need not be sharp
actual digital waves have rise and fall times of the order of a few nano seconds

⇒ In figure the trace on the CRO wil
half rectifier wave
clamped wave
no trace at all
either (a) or (b)

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒ AECF1₁₆ + 15ACD₁₆ = __________ .
C47BB₁₆
C47BE₁₆
A234F₁₆
A1111₁₆

⇒ Consider the following rectifier circuits :

half-wave rectifier without filter
full-wave rectifier without filter
full-wave rectifier with series inductance filter
full-wave rectifier with capacitance filter.

The sequence of these rectifier circuits in decreasing order of their ripple factor is
1, 2, 3, 4
3, 4, 1, 2
1, 4, 3, 2
3, 2, 1, 4

⇒ Commercial ECL gates use two ground lines and one negative supply to
reduce power consumption
increase fan out
reduce loading effect
eliminate the effect of power line glitches on the biasing circuit

⇒ The current due to thermionic emission is proportional to
T
T²
T³
T⁴

⇒ Consider the sequence x[n] = [- 4 - j5 1 + J2 4]
[- 4 - J2.5 J2 4 - J2.5]
[- J2.5 1 J2.5]
[- J5 J2 0]
[- x 1 4]

⇒

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒

Assertion (A): Feedback control systems offer more accurate control than open loop systems.

Reason (R): The feedback path establishes a link for comparison of input and output and subsequent error correction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Match the following:

	List I		List II
A.	LED	1.	Heavy Doping
B.	Avalanche Photodiode	2.	Coherent Radiation
C.	Tunnel diode	3.	Spontaneous Emission
D.	LASER	4.	Current gain

A-2, B-4, C-3
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-2, B-1, C-4, D-3

⇒ Which one of the following is correct? Energy of a power signal is
finite
zero
infinite
between 1 and 2

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The input resistance of the detector is
114 kW
336 kW
384 kW
455 kW

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
200 μC
400 μC
50 μC
25 μC

⇒ Find the odd one out
sweep voltage generator
multivibrators
sine wave oscillators
blocking oscillators

⇒ A variable resistance R and capacitive reactance X_C are connected in series. As R is varied, the locus of Z is
a straight line parallel to Y axis in 4th quadrant
a straight line parallel to X axis in 4th quadrant
a straight line parallel to Y axis in second quadrant
a straight line parallel to Y axis in first quadrant

⇒ Permeability is analogous to
conductivity
resistivity
retentivity
coercivity

⇒ The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.
5
240
2
2880

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒ A counter has a modulus of 10. The number of flip flops is
10
5
4
3

⇒ The efficiency of using a binary system for selection of 1 out of 13 equally probable events is
1
about 92%
about 83%
about 71%

⇒

Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.

Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the real expression in Pascal language XZ and MP + K
XZ + Y and MP + K
(MP + K + X) / Y
Y / (MP + K)

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment