Question is ⇒ Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor., Options are ⇒ (A) Both A and R are correct and R is correct explanation for A, (B) Both A and R are correct but R is not correct explanation for A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components.Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor., Options are ⇒ (A) Both A and R are correct and R is correct explanation for A, (B) Both A and R are correct but R is not correct explanation for A, (C) A is correct R is wrong, (D) A is wrong R is correct, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation is in parameters of active device and other components. Reason (R): A large negative feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to feedback factor.
A.	Both A and R are correct and R is correct explanation for A [Correct Answer]
B.	Both A and R are correct but R is not correct explanation for A [Wrong Answer]
C.	A is correct R is wrong [Wrong Answer]
D.	A is wrong R is correct [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If Nyquist plot has a encirclement of (-1 + jo) point, the system is stable if
there are no poles of G(s) H(s) in right-half plane
there is one pole of G(s) H(s) in right-half plane
there is no zeros of G(s) H(s) in right-half plane
none of the above

⇒ The maximum permissible distance between two samples of a 2 kHz signal is
1000 μ sec
500 μ sec
250 μ sec
2000 sec

⇒ The number of registers and flags in 8086 are
13 and 5 respectively
9 and 5 respectively
13 and 9 respectively
9 and 9 respectively

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors

⇒ If sound intensity is 8 W/m², the dB level of this sound is about
5 dB
50 dB
129 dB
1290 dB

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ The minimum height of outer atmosphere is
100 km
150 km
200 km
400 km

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒ If 1 kVA transformer is used for all of the following rectifiers, the d.c. power availability will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ In Jone chopper, the commutating element
is a capacitor
is a capacitor and an inductor
is a capacitor and an auto transformer
none of the above

⇒ The colour code on a carbon resistor is yellow-violet-orange. The value of resistance is
17000 Ω
27000 Ω
37000 Ω
47000 Ω

⇒ A transistor has two p-n junctions. The batteries should be connected such that
both junctions are forward biased
both junctions are reverse biased
one junction is forward biased and the other is reverse biased
none of the above

⇒ Which one of the following circuits is most suitable as an oscillator at a frequency of 100Hz?
Hartley oscillator
Colpitts oscillator
Crystal oscillator
Twin-T oscillator

⇒ The passband of the tuned circuits of a radio receiver should be equal to
20 kHz
455 kHz
1455 kHz
more than 455 kHz

⇒ What would be the rms value of a sine wave having the same peak value as that of the above mentioned periodic wave?
42.2 V
19 V
38.2 V
none

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ In 8085, high level on INTR line can be recognised only if
TRAP and RST lines are high
TRAP and RST lines are not high
TRAP line is high but not RST line
RST line is high but not TRAP line

⇒ An ungrounded antenna near the ground
is horizontally polarized
acts as an antenna array
acts as a single antenna of twice the height
is not likely to need an earth mat

⇒ The reactance of coupling capacitors, for DC quantities, is
zero
low
infinite
zero or low

⇒ Which of the following statement is correct?
Pre-emphasis circuits are used in AM transmitters
FM reception is noise free as compared to AM
A limiter state is also used in AM receivers
Discriminator is used for the detection of AM signals

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ The box on the external left of the title bar of menu is called control menu box.
TRUE
FALSE

⇒ In a system using QASK and 4 bits to form a symbol, the required bandwidth is
same as BPSK
half of that in BPSK
one-fourth of that in BPSK
none of the above

⇒ In 8085 microprocessor, what is the length of A-register?
6 bits
8 bits
12 bits
16 bits

⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement 13
16
9
14

⇒ 2's complement of (-24) =
11101000
1001000
1111111
111111

⇒ Hall coefficient is reciprocal of charge density.
TRUE
FALSE

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ For a second order system the damping factor is varied from 0 to 1. The locus of poles is
a straight line on imaginary axis
a straight line on real axis
a semi circle
a circle

⇒ Which of the following polynomials is not Hurwitz?
P₁ = s⁸ + 2s⁶ + 4s⁴
P₂ = s⁶ - 3s⁴ + 2s² + 1
P₃ = s⁴ + 3s³ + 3s² + 2s + 1
P₄ = s⁷ + 2s⁶ 2s⁴ + 4s³ + 8s² + 8s + 4