Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): A good op-amp should have very large band width Reason (R): An ideal op-amp should have infinite input resistance and zero output resistance | |
A. | Both A and R are correct and R is correct explanation for A [Correct Answer] |
B. | Both A and R are correct but R is not correct explanation for A [Wrong Answer] |
C. | A is correct R is wrong [Wrong Answer] |
D. | A is wrong R is correct [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ The mean life time of carrier may range from 10^{-9} seconds to hundreds of μ-seconds.
TRUE
FALSE
⇒ For the discrete time system of the given fig
y_{k} - 0.5 y_{k}_{ - 1} - 0.25 y_{k}_{ - 2} = u_{k}
y_{k} + 0.5 y_{k}_{ - 1} - 0.25 y_{k}_{ - 2} = u_{k}
y_{k} - 0.5 y_{k}_{ - 1} + 0.25 y_{k}_{ - 2} = u_{k}
y_{k} + 0.5 y_{k}_{ - 1} + 0.25 y_{k}_{ - 2} = u_{k}
⇒ The radar cross-section of a target depends an
frequency
polarization of incident wave
aspect of target
all of the above
⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE
⇒ Harmonic distortion analyser
measures amplitude of each harmonic
measures rms value of fundamental frequency component
measures rms value of all harmonics except fundamental frequency
displays rms value of each harmonic on screen of CRO
⇒ Oscillator crystal is made of
silicon
germanium
diamond
quartz
⇒ The counter which require maximum number of FF for a given mod counter is
Ripple counter
BCD counter
Ring counter
Programmed counter
⇒ A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = f_{c}, the characteristic impedance will be
zero
∞
300 Ω
more than 300 Ω
⇒ In figure if C is replaced by short circuit then R_{B} wil
425 K
412 K
474 K
400 K
⇒ If Z is the number of zeros of 1 + G(s) H(s) in the right half s plane. N is the number of clockwise encircle elements of (-1 + jo) point. P is the number of poles of G(s) H(s) in right half s plane. The Nyquist stability criterion can be expressed as
Z = N + P
Z = P/N
Z = N - P
Z = PN
⇒ In a JFET, the drain current is maximum when
V_{GS} = 0
V_{GS} is not zero but is slightly negative
V_{GS} is negative
V_{GS} is negative and equal to V_{DS}
⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V
⇒ Using 2's complement, the largest positive and negative number which can be stored with 8 bits are
+128 and -127
+128 and -128
+127 and -128
+127 and -127
⇒ A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance
increases
decreases
remains constant
may increases or decreases
⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE
⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE
⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10
⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar
⇒
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong
⇒ Transfer functions of even complicated components can be found by frequency response tests.
TRUE
FALSE
⇒ An R-L series circuit has R = 5 Ω and L = .01 H. It is fed by ac 50 Hz supply. The rms current in the circuit is 5 A. The active power supplied by the source is
25 W
50 W
125 W
250 W
⇒
A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1
⇒ A monostable multivibrator has
no stable state
one stable state
two stable state
none of the above
⇒ In the network shown in figure, the voltage drops across R_{2} and R_{3} are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0is 9 A and directed away from node 0is 9 A but directed of current cannot be foundis impossible to be found}
⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB
⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other
⇒ Values of V_{T} at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV
⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE
⇒ The mean life time of carrier may range from 10^{-9} seconds to hundreds of μ-seconds.
TRUE
FALSE
⇒ For the discrete time system of the given fig
y_{k} - 0.5 y_{k}_{ - 1} - 0.25 y_{k}_{ - 2} = u_{k}
y_{k} + 0.5 y_{k}_{ - 1} - 0.25 y_{k}_{ - 2} = u_{k}
y_{k} - 0.5 y_{k}_{ - 1} + 0.25 y_{k}_{ - 2} = u_{k}
y_{k} + 0.5 y_{k}_{ - 1} + 0.25 y_{k}_{ - 2} = u_{k}
⇒ The radar cross-section of a target depends an
frequency
polarization of incident wave
aspect of target
all of the above
⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE
⇒ Harmonic distortion analyser
measures amplitude of each harmonic
measures rms value of fundamental frequency component
measures rms value of all harmonics except fundamental frequency
displays rms value of each harmonic on screen of CRO
⇒ Oscillator crystal is made of
silicon
germanium
diamond
quartz
⇒ The counter which require maximum number of FF for a given mod counter is
Ripple counter
BCD counter
Ring counter
Programmed counter
⇒ A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = f_{c}, the characteristic impedance will be
zero
∞
300 Ω
more than 300 Ω
⇒ In figure if C is replaced by short circuit then R_{B} wil
425 K
412 K
474 K
400 K
⇒ If Z is the number of zeros of 1 + G(s) H(s) in the right half s plane. N is the number of clockwise encircle elements of (-1 + jo) point. P is the number of poles of G(s) H(s) in right half s plane. The Nyquist stability criterion can be expressed as
Z = N + P
Z = P/N
Z = N - P
Z = PN
⇒ In a JFET, the drain current is maximum when
V_{GS} = 0
V_{GS} is not zero but is slightly negative
V_{GS} is negative
V_{GS} is negative and equal to V_{DS}
⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V
⇒ Using 2's complement, the largest positive and negative number which can be stored with 8 bits are
+128 and -127
+128 and -128
+127 and -128
+127 and -127
⇒ A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance
increases
decreases
remains constant
may increases or decreases
⇒ In home tape recorders the tape width is 2 inches.
TRUE
FALSE
⇒ Internet is a worldwide network of computers where most of the information is freely available.
TRUE
FALSE
⇒ For satellite communication, standard Earth stations have antenna diameters in the range of __________ metre.
27.5 to 30
10 to 15
30 to 50
5 to 10
⇒ Which of the following statement about JFET is true?
In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET
In its schematic symbol for JFET, the arrow always points to p-type material
In an n-channel JFET, the channel is the narrowest under zero gate bias condition
In JFET, gate source cut off voltage is numerically equal to the pinch off voltage
⇒
Assertion (A): Water waves are longitudinal but EM waves are transverse
Reason (R): In an EM wave electric field, magnetic field and propagation are mutually perpendicular.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar
⇒
Assertion (A): In root locus the breakaway and break in points either lie on real axis or occur in complex conjugate pairs.
Reason (R): All root locus asymptotes intersect on real axis.
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong
⇒ Transfer functions of even complicated components can be found by frequency response tests.
TRUE
FALSE
⇒ An R-L series circuit has R = 5 Ω and L = .01 H. It is fed by ac 50 Hz supply. The rms current in the circuit is 5 A. The active power supplied by the source is
25 W
50 W
125 W
250 W
⇒
Match the following:
List I | List II | ||
---|---|---|---|
A. | Servomotor | 1. | Error detector |
B. | Amplidyne | 2. | Transducer |
C. | Potentiometer | 3. | Actuator |
D. | Flapper valve | 4. | Power amplifier |
A-3, B-1, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-4, C-2, D-1
⇒ A monostable multivibrator has
no stable state
one stable state
two stable state
none of the above
⇒ In the network shown in figure, the voltage drops across R_{2} and R_{3} are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0is 9 A and directed away from node 0is 9 A but directed of current cannot be foundis impossible to be found}
⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB
⇒ The force in a magnetic field is given by F = qvB
F and q are perpendicular and v and B are perpendicular
F and q only are perpendicular to each other
F and v, F and B are mutually perpendicular to each other and v and B at any angle between them
All the four components are perpendicular to each other
⇒ Values of V_{T} at 20°C for an ideal P-N diode
25.27 mV
30.3 mV
23 mV
50 mV
⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE