Question is ⇒ Assertion (A): 2's complement arithmetic is preferred in digital computers Reason (R): The hardware required to obtain 2's complement is simple., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper.

Reason (R): The hardware required to obtain 2's complement is simple.

, Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper. '/>

Reason (R): The hardware required to obtain 2's complement is simple.


Q1.	Assertion (A): 2's complement arithmetic is preferred in digital computers Reason (R): The hardware required to obtain 2's complement is simple.
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Wrong Answer]
C.	A is true, R is false [Correct Answer]
D.	A is false, R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Modulated carrier power in FM
increases with modulating signal power
decreases with modulating signal power
is independent of the modulating signal power
none

⇒ An oscillator requires an amplifier
with negative feedback
with positive feedback
with either positive or negative feedback
none of the above

⇒ The electric field of an EM wave propagating in the z direction given
linearly polarized in z direction
elliptically polarized
left hand circularly polarized
right hand circularly polarized

⇒ In a vacuum tube, the transit time of electron between cathode and anode is important at
low frequencies
high frequencies
both (a) and (b)
frequencies which are neither very low nor very high

⇒ Number of cards read per minute by a card reader may be of the order of
20
1
10000
300

⇒ The number of programmable 16 bit registers of 6800 are
2
3
4
5

⇒ A trigonometric series has
single sided spectra
zero
sync function
undefined

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ In which mode of BJT operation are both junctions reverse biased?
Active
Saturation
Cut off
Reverse active

⇒ The constant magnitude of G(s) plane are
a family of straight horizontal lines
a family of straight inclined lines with positive slope
a family of straight inclined lines with negative slope
a family of circles

⇒ The circuit shown in figure conv
BCD to binary code
binary to excess-3 code
excess-3 to Gray code
gray to binary code

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ A zinc carbon cell is a primary cell.
TRUE
FALSE

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ What will be FSV in 2 bit BCD D/A converter is a weighted resistor type with E_R = 1V, R = 1 MΩ and R_f = 10KΩ
0.99 V
0.9 V
0.1 V
0

⇒ An 8-bit microprocessor has 16 bit address bus A₀ - A₁₅. The processor addresses a 1-K byte memory chip as shown. The address range for the chi
(F00F)_H TO (F40E)_H
(F000)_H TO (F3FF)_H
(F100)_H TO (F4FF)_H
(F700)_H TO (FAFF)_H

⇒ Examine the following statements

Pneumatic systems are fire proof.
Pneumatic systems are explosion proof.
Hydraulic systems are explosion proof.
Hydraulic systems are fire proof.

Which of the above statements are correct?
1 only
1 and 2 only
1 2, 3, 4
2, 3, 4 only

⇒ An RLC series circuit has R = 7.07 Ω, L = .707 H and C = 7.07 μF. At Half power frequencies the circuit impedance is likely to be
7.07 Ω
10 Ω
14.14 Ω
20 Ω

⇒ Given figure is the voltage transfer characteristi
an N MOS inverter with enhanced mode transistor as load
an N MOS inverter with depletion mode transistor as load
a CMOS inverter
BJT inverter

⇒ An SR flip flop can be built using NOR gates or NAND gates.
TRUE
FALSE

⇒ PID controlled system has
P and I actions in forward path and D action in feedback path
P and I actions in feedback path and actions in forward path
All the three (i.e., P, I and D) actions in forward path
All the three (i.e., P, I and D) actions in feedback path

⇒ PIN diode has
p⁺ and n layers separated by i layer
p⁺ and n⁺ layers separated by i layer
p^- and n^- layers separated by i layer
none of the above

⇒ In a Ballistic galvanometer
inertia is small and damping is also small
inertia is large and damping is critical
inertia is large and damping is small
both inertia and damping are large

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒ A series resonant circuit is fed by a voltage having rms value V. At resonance, the voltage across inductance V_L and voltage across capacitance V_C are related as
V_L > V_C
V_L < V_C
V_L = V_C
V_L = 0.5 V_C

⇒ The realization of the term Ks yields
a resistance of value K ohms
a capacitances of value K farads
an inductance of value k farads
either (b) or (c)

⇒ Data can be changed from spatial code to temporal code and vice-versa by using
ADC and DAC
shift Register
synchronous counter
timers

⇒ Two products are sold from a vending machine, which has two push buttons P₁ and P₂. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P₁ is pressed, '2' is displayed, signifying 'Rs.
3 NOT and 4 OR
2 NOT and 4 OR
1 NOT and 3 OR
2 NOT and 3 OR

⇒ In figure, the current through R is 1 A when V_A = 0 and V_B = 15V. If both V_A and V_B are increased by 15V each, current through R wil
0.0416666666666667
0.5 A
0.125
0.33 A

⇒ Since noise phase modulated FM wave, as the noise sideband frequency approaches the carrier frequency, the noise amplitude
is equalized
is increased
is decreased
remains constant