Question is ⇒ PAM stands for, Options are ⇒ (A) Phase Angle Modulation, (B) Phase Amplitude Modulation, (C) Pulse Amplitude Modulation, (D) Pulse Angle Modulation, (E) , Leave your comments or Download question paper.

Question is ⇒ PAM stands for, Options are ⇒ (A) Phase Angle Modulation, (B) Phase Amplitude Modulation, (C) Pulse Amplitude Modulation, (D) Pulse Angle Modulation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	PAM stands for
A.	Phase Angle Modulation [Wrong Answer]
B.	Phase Amplitude Modulation [Wrong Answer]
C.	Pulse Amplitude Modulation [Correct Answer]
D.	Pulse Angle Modulation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In FM and AM the ratio of signal to noise ratio at the detector output least depends upon
bandwidth
transmission
carrier frequency
modulating frequency

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will
decrease
increase
remain the same
increase or decrease

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10⁶ rad/sec. The possible combination of R, L,
2.5Ω, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 pF
5 kΩ, 0.2 mH, 200 μF
5 kΩ, 0.1 mH, 0.4 μF

⇒ The electric intensity for free space is given by
ε₀d
σ/ε₀
σ.ε₀
d/ε₀

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ Calculate the wave number in waveguide having dimensions 4 x 2 cm at 3 GHz
6.28
62.8
8
0

⇒ In a full wave rectifier, the current in each of the diodes flows for
the complete cycle of the input signal
half cycle of the input signal
less than half cycle of the input signal
one-fourth cycle of the input signal

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ A 16 bit binary adder has
16 half adders
16 full adders
one half adders and 15 full adders
8 half adders and eight full adders

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ Intel 2004 is a
ROM
Volatile RAM
NV RAM
None of the above

⇒ Under low level injection assumption, the infected minority carrier current for an extrinsic semiconductor is essentially the
diffusion current
drift current
recombination current
induced current

⇒ When a vector has positive divergence, it indicates that the vector quantity has at that point and if the divergence is negative, it indicates __________ .
source, sink
sink, source
positive value, negative value
negative value, positive value

⇒ Lead becomes a superconductor at
9.1 K
7 K
5 K
3 K

⇒

Assertion (A): A capacitor with imperfect dielectric can be represented by a capacitance in parallel with resistance.

Reason (R): For imperfect dielectrics, dielectric constant has real and imaginary parts.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ TTL logic is preferred to DRL logic because
greater fan-out is possible
greater logic levels are possible
greater fan-in is possible
less power consumption is achieve

⇒ In a klystron amplifier the bunching effect
converts velocity modulation into current modulation of beam
converts current modulation into velocity modulation of beam
both (c) and (b)
neither (a) nor (b)

⇒ For a system with transfer funct
2.828
5.2915
5.088
cannot be determined

⇒ Incompatibility between memory and I/O device may be due to
timing according to which data transfer is to take place
electrical characteristics of the two devices
format of data transfer
all of the above

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge

⇒ Ebers Moll model is applicable to
bipolar Junction transistor
N MOS transistor
unipolar junction transistor
field effect transistor

⇒ The virtual height of an ionospheric layer is __________ true height
equal to
less than
higher than
no relation

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ In the op-amp circuit of figure, V_{010 V
-10 V
5 V
-5 V}

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ The inputs to logic gate are 0. The output is 1. The gate is
NAND or XOR
OR or XOR
AND or XOR
NOR or Ex-NOR