Question is ⇒ Over which frequency range the effect of atmospheric noise is significant?, Options are ⇒ (A) Over 35 MHz, (B) Below 30 MHz, (C) Between 30 MHz and 100 MHz, (D) Between 100 MHz and 150 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ Over which frequency range the effect of atmospheric noise is significant?, Options are ⇒ (A) Over 35 MHz, (B) Below 30 MHz, (C) Between 30 MHz and 100 MHz, (D) Between 100 MHz and 150 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Over which frequency range the effect of atmospheric noise is significant?
A.	Over 35 MHz [Wrong Answer]
B.	Below 30 MHz [Wrong Answer]
C.	Between 30 MHz and 100 MHz [Wrong Answer]
D.	Between 100 MHz and 150 MHz [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t²
t
t
1/t

⇒ The colour code on a carbon resistor is green-blue-yellow. The tolerance is
± 5%
± 10%
± 20%
± 30%

⇒ FM transmitting and receiving equipment as compared to AM equipment is
costly
cheaper
almost equally costly
none of the above

⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
30 Ω
10 Ω
9 Ω
zero

⇒ The amplifier circuit shown below uses a silicon transistor. The capacitors C_c and C_E can be assumed to be short at signal frequency and the effect of output resistance r₀ can be ignored. If C_E is disconnected from the circuit, which one of the following statements is T
The input resistance R_i increases and the magnitude of voltage gain A_v decreases
The input resistance R_i decreases and the magnitude of voltage gain A_v decreases
Both input resistance R_i and the magnitude of voltage gain A_v decrease
Both input resistance R_i and the magnitude of voltage gain A_v increase

⇒ Consider the circuit shown below of 2 : 1 MUX is given by the function g = ac + bc
X ⊕ Y
XY + EXY
XE + XY
none of these

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ In which device does the extent of light controls the conduction
photovoltaic cell
photo electric relay
LED
photo sensitive device

⇒ If the Q of a single stage single tuned amplifier is doubled, the bandwidth will
remain the same
become half
become double
become four times

⇒ Industrial noise has the frequency range of
1 to 100 Hz
200 to 5000 Hz
above 200 MHz
1 to 600 MHz

⇒ The value of current read by ideal ammeter A in figure is __________ amp
0
3
2.5
5

⇒ Consider isotropic radiator radiating a power of 1 watt. At a distance of 1 metre, the power per unit area with equal
1 watt/m²
4p watt/m²
1/4p watt/m²
2p watt/m²

⇒ In a series R-L-C circuit, the voltage across inductance will be maximum
at resonance frequency
just before resonant frequency
just after resonant frequency
none of the above

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE

⇒ In a low level AM system, the modulated amplifiers stage must be
harmonic devices
non-linear devices
class C amplifier
linear devices

⇒ A higher directivity is specified by
high gain low BW (Beamwidth)
high gain high BW
low gain high BW
none of the above

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5

⇒ Narrow band FM signal can be represented as
A cos (2pf_ct) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_ct) + βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) + βA sin (2pf_mt) sin (2pf_ct)

⇒ What is an advantage of an electronic voltmeter over a non-electronic voltmeter?
Low power consumption
Low input impedance
The ability to measure wide ranges of voltages and resistance
Large portability

⇒
Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ End fire array has narrow bandwidth.
TRUE
FALSE

⇒ In the circuit of figure, the switch is closed at t = 0. At t = 0⁺ the current through
0.166666666666667
2.5 A
3.1 A
0

⇒ The relation between plate current and plate voltage of a vacuum diode is called
Richardson Dushman equation
Langmuir Child law
Ohm's law
Boltzmann's law

⇒
Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.
Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A vertical wire of 1 meter length carries a current of 1 A at 10 MHz. The total radiated power is nearly
0.13 W
0.88W
7.3 W
73 W

⇒ If A = 0101, then A' is
1010
1011
1001
110

⇒ Which of the following is not the main characteristic of a FET?
Drain resistance
Forward transconductance
Temperature stability
Amplification factor

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ A full wave rectifier circuit using centre tapped transformer, the input frequency 50 Hz. The frequency of output is
100 Hz
50 Hz
25 Hz
none of the above

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math