Question is ⇒ One of the major applications of JFET is in, Options are ⇒ (A) switching, (B) constant current-source, (C) constant voltage-source, (D) electron flow regulation, (E) , Leave your comments or Download question paper.

Question is ⇒ One of the major applications of JFET is in, Options are ⇒ (A) switching, (B) constant current-source, (C) constant voltage-source, (D) electron flow regulation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One of the major applications of JFET is in
A.	switching [Correct Answer]
B.	constant current-source [Wrong Answer]
C.	constant voltage-source [Wrong Answer]
D.	electron flow regulation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the value of C₂ and C₃ are doubled, the oscillation frequency will be
quadrupled
doubled
unchanged
halved

⇒ The magnetic field due to current I equals
I/2 pr
I/4 pr
I²/2 pr
I²/4 pr

⇒ A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.
A.C., low frequency
A.C., high frequency
D.C., low frequency
D.C. high frequency

⇒

Assertion (A): In imperfect capacitors, the current does not lead the applied ac voltage by 90°.

Reason (R): When subjected to ac fields, the dielectric constant can be expressed as ∈^'_r - j∈^"_r.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which colour picture tube uses slotted aperture mask?
Trinitron
Shadow mask tube
PIL
None of the above

⇒ An electron in the conduction band
has higher energy than the electron in the valence band
has lower energy than the electron in the valence band
loses its charge easily
jumps to the top of the crystal

⇒ Two current sources each of rms value 10 A have frequencies 40 Hz and 50 Hz respectively. They are connected in series, the expression for resultant wave is
i = 10 sin 40 t + 10 sin 50 t
i = 14.14 sin 40 t + 14.14 sin 50 t
i = 14.14 sin 80 pt + 14.14 sin 100 pt
i = 20 sin 80 pt + 20 sin 100 pt

⇒ What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode?
The duration of output waveform is less than 180°
Output voltage is less than input voltage
Output voltage is more than input voltage
Both (a) and (b)

⇒ In a 741 OP-amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to
applied load
internal compensation
impedance of the source
power dissipation in the chip

⇒ Primary advantage of a crystal oscillator is that
it can oscillate at any frequency
it gives a high O/P voltage
its frequency of oscillation remains almost constant
it operates on a very low dc supply voltage

⇒ The resistance of resistance strain gauge is about
5 Ω
50 Ω
120 Ω
0.5 Ω

⇒ Among the digital IC families - ECL, TTL, and CMOS
ECL has the least propagation delay
TTL has largest fan out
CMOS has the lowest noise margin
TTL has the lowest power consumption

⇒ Tracking of extra terrestrial objects requires
high transmitting power
very sensitive receiver
fully steerable antenna
all of the above

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In force current analogue, mechanical mobility is analogous to
impedance Z
admittance Y
reactance X
conductance G

⇒ The current flow in a semiconductor is due to
holes
electrons
holes and electrons
holes, electrons and ions

⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)

⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_c is the cut off frequency)
3 f_c
3 f_c
2 f_c
2 f_c

⇒ For the K map of the given figure the simplified Boolean expressio
AC + A B
A BC + A B C + A B C + AB C
AC + A B + AC
A C + A B + AB

⇒ SSB can be generated by
filter method
phase cancellation method
good attenuation characteristics
all of the above

⇒ In figure The minimum and maximum load currents
0 and 60 mA
0 and 120 mA
10 mA and 60 mA
10 mA and 120 mA

⇒ In an optional fiber the refractive index of cladding material should be
nearly 1
very low
less than that of core
more than that of core

⇒ A bridge type single phase cycloconverter changes the frequency f to f/3. Then one half wave of output contains
3 full waves of input
3 half waves of input
6 full waves of input
6 half waves of input

⇒ The output of a battery eliminator is about
110 V DC
110 V AC
45 V DC
6 V DC

⇒ Noise temperature of Sun is more than __________ °K.
1000
5000
100000
500

⇒ For the K map of the given figure the simplified Boolean expressio
ACD + ABD + BCD
ACD + BCD
ACD + ABD
none of the above

⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
divide by 5 circuit
divide by 2 circuit
divide by 5 circuit followed by divide by 2 circuit
BCD counter

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE