Question is ⇒ One of the function of the Sio<sub>2</sub> layer in an IC is to, Options are ⇒ (A) act as a dielectric for capacitors, (B) prevent shorting of elements by interconnections, (C) from cathodes for diodes, (D) afford protection from the radiations, (E) , Leave your comments or Download question paper.

Question is ⇒ One of the function of the Sio<sub>2</sub> layer in an IC is to, Options are ⇒ (A) act as a dielectric for capacitors, (B) prevent shorting of elements by interconnections, (C) from cathodes for diodes, (D) afford protection from the radiations, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One of the function of the Sio₂ layer in an IC is to
A.	act as a dielectric for capacitors [Wrong Answer]
B.	prevent shorting of elements by interconnections [Correct Answer]
C.	from cathodes for diodes [Wrong Answer]
D.	afford protection from the radiations [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Varactor diode is forward biased when it is used.
TRUE
FALSE

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒ Waves of frequencies higher than 30 MHz penetrate the atmosphere.
TRUE
FALSE

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒ (22)₄ + (101)₃ - (20)₅ = (x)₄ + (4)_x+1 where x > 4. The value of x is
6
4
12
8

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In drawing phasor diagrams, RMS values are used.
TRUE
FALSE

⇒ A TTL circuit with totem pole output has
high output impedance
low output impedance
very high output impedance
none of the above

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz. The wave impedance is
400.94 Ω
562.94 Ω
502.80 Ω
492.80 Ω

⇒

Assertion (A): A coaxial line is a non-radiating line.

Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a phase shifting transformer the currents in the two stator winding are in phase.
TRUE
FALSE

⇒ The function of shunt in an ammeter is to
by pass the current
increase sensitivity of meter
increase resistance of meter
all of the above

⇒ A single phase half wave rectifier circuit has a free wheeling diode. The free wheeling diode will conduct only if
load is purely resistive
load is purely inductive
load is combination of R and L
load is purely inductive or combination of R and L

⇒ Wire-wound resistors are unsuitable for use at high frequencies because they
are likely to melt under excessive eddy current heat
exhibit unwanted inductive and capacitive effects
create more electrical noise
consume more power

⇒ In a single phase full wave ac regulator using two thyristors only, the gate circuits of the two thyristors
must be isolated
may or may not be isolated
should be preferably, isolated
should not be isolated

⇒ A 16-megabit dynamic random access memory (DRAM) is an integrated circuit capable of storing __________ characters (bytes).
1048567
16 x 1024 x 10⁶
16 x 10⁶
2.1 x lo⁶

⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz

⇒ If x₁(t) = 2 sin pt + cos 4 pt and x₂(t) = sin 5 pt + 3 sin 13 pt then
x₁, x₂ both periodic
x₁ x₂ both not periodic
x₁ periodic, x₂ not periodic
x₁ is not periodic ; but x₂ is periodic

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒ Which of the following methods does not cause any reduction in instruction length?
Using program counter
Common source and destination address
Implicit source and destination address
Machine language programming

⇒ In a piezoelectric crystal, application of a mechanical stress would produce
plastic deformation of the crystal
magnetic Dipoles in the crystal
electric polarization in the crystal
shift in the Fermi level

⇒ As temperature increases
the forbidden energy gap in silicon and germanium increase
the forbidden energy gap in silicon and germanium decrease
the forbidden energy gap in silicon decreases while that in germanium decreases
the forbidden energy gap in silicon increases while that in germanium decreases

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ In given figure the switch was closed for a long time before opening at t = 0. The voltage V_x at t = 0^{+25 V
50 V
-50 V
0 V}

⇒ A coil resonates at 1 MHz with a resonating capacitance of 72 pF. At 500 pF, resonance is obtained with a resonating capacitor of 360 pF. The self capacitance of coil is
12 pF
24 pF
30 pF
72 pF

⇒ In a radio receiver, the local oscillator is always tuned to a frequency higher than the incoming frequency to
facilitate tracking
allow permit adequate frequency coverage without switching
facilitate image frequency rejection
all of the above

⇒ In a 3 phase semiconverter, the output voltage becomes discontinuous for
firing angle > 30°
firing angle > 60°
firing angle > 90°
firing angle > 120°

⇒ Consider the following

The first letter of a Java variable is lower case.
Each successive word in Java variable begins with a capital letter.
All other letters are lower case.
A Java variable can have a digit as first character.

Which of the above are correct?
All
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt