Question is ⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is, Options are ⇒ (A) higher efficiency, (B) more linear operation, (C) more power output per transistor, (D) lesser requirement of modulating power, (E) , Leave your comments or Download question paper.

Question is ⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is, Options are ⇒ (A) higher efficiency, (B) more linear operation, (C) more power output per transistor, (D) lesser requirement of modulating power, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One of the advantages of base modulation over collector modulation in a class C transistor amplifier is
A.	higher efficiency [Wrong Answer]
B.	more linear operation [Wrong Answer]
C.	more power output per transistor [Wrong Answer]
D.	lesser requirement of modulating power [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ Read the following statements

The circuitry of ripple counter is more complex than that of synchronous counter.
The maximum frequency of operation of ripple counter depends on the modulus of the counter.
The maximum frequency of operation of synchronous counter does not depend on the modulus of the counter.

Which of the above statements are correct?
1 only
1, 2
1, 2, 3
2, 3

⇒ What are the ultimate purpose of minimizing logic expressions?

To get small size expression.
To reduce the number of variables in the given expression.
To implement the function of the logic expression with least hardware.
To reduce the expression for making it feasible for hardware implementation.

Select the correct answer from the codes given below:
1 only
2 and 3
3 only
3 and 4

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance

⇒ In an n channel MOSFET, the substrate is connected
to negative terminal of battery
to positive terminal of battery
to either positive or negative terminal of battery
none of the above

⇒ A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is
16
1.6
3.2
60

⇒ The L/C has the dimension of
time
capacitance
velocity
resistance

⇒ Read the following statements as regards register pairs in microprocessor 8085

B represents B, C pair with B as high order register and C as low order register.
D represents D, E pair with D as high order register and E as low order register.
H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?
All
1 and 3
1 and 2
2 and 3 only

⇒ A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = f_c, the characteristic impedance will be
zero
∞
300 Ω
more than 300 Ω

⇒ The number of computer viruses is some thousands.
TRUE
FALSE

⇒ The amplifier used in miller voltage sweep should have a gain of
-∞
1
+∞
-1

⇒ In a radio detector
stabilization against signal strength variation is provided
linearity is worse than in a phase discriminator
the circuit is the same as in discriminator except that diodes are reversed
output is twice that obtainable from a similar phase discriminator

⇒ The series 54 H/74 H denotes
Standard TTL
High speed TTL
Low Power TTL
High Power TTL

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ A magnetron requires an external magnetic field with flux lines parallel to axis of cathode
TRUE
FALSE

⇒ In controlled heating circuits, thyristors act as
rectifier
inverter
ac regulator
chopper

⇒ Which of the following has highest conductivity?
Silver
Aluminium
Tungsten
Platinum

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ The DTFT of x(n) = δ(n) will be
1
0
∞
not defined

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is
2.5
60
10⁴
10⁶

⇒ ISDN stands for
Integrated Services Digital Network
Inter Services Digital Network
Inter Subscriber Digital Network
integrated Subscriber Digital Network

⇒ What is the purpose of peak clipper circuits in radio transmitters?
To prevent overmodulation
To reduce bandwidth
To increase bandwidth
To regulate oscillator I/P voltage

⇒ In fabricating silicon BJT in ICs by the epitaxial process, the number of diffusions used is usually
2
3
4
6

⇒ BFO stands for
Beat Frequency Oscillator
Broad Frequency Oscillator
Blocking Frequency Oscillator
Ballistic Frequency Oscillator

⇒ In common base configuration, the input characteristics of bipolar junction transistor are drawn between
V_EB and I_E
V_CB and I_C
I_C and V_CE
I_E and V_CE