Question is ⇒ One of a loss-less transmission line having the characteristic impedance of 75 Ω and length of 1cm is short-circuit. At 3 GHz, the input impedance at the other end of the transmission line is, Options are ⇒ (A) 0, (B) resistive, (C) capacitance, (D) inductive, (E) , Leave your comments or Download question paper.

Question is ⇒ One of a loss-less transmission line having the characteristic impedance of 75 Ω and length of 1cm is short-circuit. At 3 GHz, the input impedance at the other end of the transmission line is, Options are ⇒ (A) 0, (B) resistive, (C) capacitance, (D) inductive, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One of a loss-less transmission line having the characteristic impedance of 75 Ω and length of 1cm is short-circuit. At 3 GHz, the input impedance at the other end of the transmission line is
A.	0 [Wrong Answer]
B.	resistive [Wrong Answer]
C.	capacitance [Wrong Answer]
D.	inductive [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following is used to change data from spatial code to temporal code?
Shift register
Counter
A/D converters
Combinational circuits

⇒

Assertion (A): If contents of F register in 8085 are 01010001, it means S = 0, Z = 1, AC= 1, P = 0 and CY = 1.

Reason (R): When an instruction is called from memory, the op. code of instruction is stored in instruction register.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a transistor leakage current mainly depends on
doping of base
size of emitter
rating of transistor
temperature

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ The circuit shown in figure
oscillate at 456 kHz
oscillate at 228 kHz
oscillate at microwave frequency
not oscillate

⇒ In p-n-p transistor the current I_E has two components viz. I_EP due to injection of holes from p-region to n-region and I_E due to injection of electrons from n-region to p-region. Then
I_Ep and I_En are almost equal
I_Ep >> I_En
I_En >> I_Ep
either (a) or (c)

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ The terminals of a power MOSFET are called
emitter, base, collector
source, gate, drain
source, base, drain
emitter, gate, drain

⇒ A radio frequency choke permits an easy flow of __________ current and at the same time it offers a very impedance to __________ currents.
A.C., low frequency
A.C., high frequency
D.C., low frequency
D.C. high frequency

⇒ A network has two branches in parallel. One branch contains impedance Z₁ and the other branch has impedance Z₂. If it is fed from an ac voltage V of frequency f, the current through Z₁ depends, on
V, Z₁, Z₂
V, Z₁
Z₁, Z₂
V, Z₁, f

⇒ The organisatioion of Intel memory chip 127256 is
32 K x 8
16 K x 8
32 K x 4
16 K x 4

⇒ A D-flip-flop is
dial type flip-flop
delay flip-flop
differential flip-flop
digital flip-flop

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒ Which of the following transducers is most suitable for monitoring continuous variations in very fine thickness of a material?
Diaphragm
Capacitor
L.V.D.T.
Piezoelectric crystal.

⇒ A 0 to 6 counter consist of 3 flip-flop and a combinational circuit of 2 input gates. The combinational circuit consist of
one AND gate
one OR gate
one AND and One OR
two AND gate

⇒ When a thyristor is conducting, the voltage drop across it
is absolutely constant
decreases with increase in load current
increases slightly with increase in load current
none of the above

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ When the i-v curve of a photodiode passes through origin the illumination is
maximum
minimum
zero
equal to rated value

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ Consider the following statements:

Acceptor level is formed very close to the conduction band.
The effective mass of the free electron is same as that of a hole.
The magnitude of the charge of a free electron is same as that of a hole.
Addition of donor impurities adds holes to the semiconductor.

Which of the above statements are correct?
1 and 3
2 and 3
2 and 4
3 and 4

⇒ Radiation pyrometer is used to measure temperature in the range of
-200 to 500° C
0 to 500° C
500 to 1200° C
1200 to 2500° C

⇒ A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is R_L and filter capacitance is C. For good output wave shape, the time constant R_LC should be at least equal to
10 ms
20 ms
50 ms
100 ms

⇒ A signal x₁(t) and x₂(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ The Fourier transform of f(t) = cos ω₀t is
p[δω₀ + δ(- ω₀)]
p[δ(ω - ω₀) + δ(ω + ω₀)]
p[δω₀ - δ(- ω₀)]
p[δ(ω - ω₀) - δ(ω + ω₀)]