Question is ⇒ On modulating a carrier of frequency fc by an audio signal fs, the following components has result, Options are ⇒ (A) Amplitude modulation (DSB), (B) Single sideband modulation, (C) Frequency modulation only, (D) Amplitude modulation or frequency modulation, (E) , Leave your comments or Download question paper.

Question is ⇒ On modulating a carrier of frequency fc by an audio signal fs, the following components has result, Options are ⇒ (A) Amplitude modulation (DSB), (B) Single sideband modulation, (C) Frequency modulation only, (D) Amplitude modulation or frequency modulation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	On modulating a carrier of frequency f_c by an audio signal f_s, the following components has result
A.	Amplitude modulation (DSB) [Correct Answer]
B.	Single sideband modulation [Wrong Answer]
C.	Frequency modulation only [Wrong Answer]
D.	Amplitude modulation or frequency modulation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A series RLC circuit has a resonant frequency of 2000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
4000 Hz
2025 Hz
1975 Hz

⇒ For what positive value of K does the polynomial s⁴ + 8s³ + 24s² + 32s + K have roots with zero real parts?
10
20
40
80

⇒ In figure V is ideal voltmeter having infinite resistance. It will read __________ v
40
60
0
100

⇒

Assertion (A): The response of a network to an impluse is determined only by the parameters of the network.

Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s³

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A two winding transformer is feeding a single phase half wave rectifier circuit. The load is purely resistive. The rms value of transformer secondary current is I_s and rms value of load current in I_rms. Then
I_s = I_rms irrespective of the value of firing angle
I_s = 0.5 I_rms irrespective of the value of firing angle
I_s = I_rms if firing angle is less than 30°
I_s = I_rms if firing angle is more than 30°

⇒ In microwave system, waveguide twists
change the plane of polarization of a propagating wave
change the direction of a propagating wave
change the mode of a propagating wave
both (b) and (c)

⇒ In a circular waveguide the dominant mode is
TE₀₁
TE₁₁
TE₂₀
TE₂₁

⇒ The thermionic emission current is given by
Fermi-Dirac distribution
Maxwell's equation
Richardson Dushman equation
Langmuir Child law

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒ Which converter is used in HVDC transmission?
3 pulse
6 pulse
12 pulse
24 pulse

⇒ The input gate current of a FET is
a few amperes
a few milli amperes
a few micro amperes
negligible

⇒ Which of the following is not correct in respect of electrostatic instrument?
It is essentially a voltmeter
It is suitable for only high voltages
It has a uniform scale
It can be used for both ac and dc

⇒

Assertion (A): FET is a unipolar device.

Reason (R): BJT is bipolar device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statement regarding link loss for a satellite is wrong?
For fixed antenna, it is inversely proportional to f²
For fixed frequency, it is inversely proportional to the product of the antenna aperture areas
For a given satellite operating at a given frequency, it is inversely proportional to
Loss in down-link is negligible as compared to that in uplink

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒

Assertion (A): Structures are useful in DBMS.

Reason (R): Structures are very large numbers of applications besides DBMS.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ 4 bit 2's complement representation of a decimal number is 1000. The number is
8
0
-7
-8

⇒

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in bandwidth
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope overload error
C.	Finer quantization of signal	3.	Nyquist rate
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-4, B-3, C-2, D-1
A-4, B-2, C-1, D-3

⇒

Assertion (A): The forward resistance of a p-n diode is not constant.

Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The current in an RL series circuit is 1 - e^-t amperes. Then di/dt is
1 - e^-t
- e^-t
e^t
e^-2t

⇒ How is inversion achieved using EX-OR gate?
Giving input signal to the two input lines of the gate tied together
Giving input to one input line and logic one to the other line
Giving input to one input line and logic one to the other line
Inversion cannot be achieved using EX-OR gate

⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is
300 mW
330 mW
350 mW
380 mW

⇒ In the circuit of figure the function of resistor R and diode D
to limit the current and to protect LED against over voltage
to limit the voltage and to protect LED against over current
to limit the current and protect LED against reverse breakdown voltage.
none of the above.

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ In the given figure forward voltage wave has a magni
90 V
60 V
30 V
10 V

⇒ The temperature coefficient of copper is 0.00393 at 20° C. At 50° C the temperature coefficient is
0.0042
0.0035
0.0025
0.0015

⇒ Surge current rating of an SCR is
the maximum repetitive surge current in which the SCR can withstand
the maximum non-repetitive surge current in which the SCR can withstand
the maximum repetitive or non repetitive surge current in which the SCR can withstand
the maximum surge current in which the SCR can withstand if both surge current and steady current exist together

⇒ The logical expression Y = A + AB is equivalent to
Y = AB
Y = AB
Y = A + B
Y = A + B

⇒ An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is
30 m/s²
60 m/s²
90 m/s²
120 m/s²

⇒ When temperature is more than ferromagnetic curie temperature, the behaviour of a ferromagnetic material is similar to that of paramagnetic material.
TRUE
FALSE