Question is ⇒ Ohmic range of metal film resistors is, Options are ⇒ (A) 1 to 100 ohms, (B) 10 to 1 K ohms, (C) 100 to 1 M ohms, (D) 100 to 100 M ohms, (E) , Leave your comments or Download question paper.

Question is ⇒ Ohmic range of metal film resistors is, Options are ⇒ (A) 1 to 100 ohms, (B) 10 to 1 K ohms, (C) 100 to 1 M ohms, (D) 100 to 100 M ohms, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Ohmic range of metal film resistors is
A.	1 to 100 ohms [Wrong Answer]
B.	10 to 1 K ohms [Wrong Answer]
C.	100 to 1 M ohms [Correct Answer]
D.	100 to 100 M ohms [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Harmonic distortion analyser
measures amplitude of each harmonic
measures rms value of fundamental frequency component
measures rms value of all harmonics except fundamental frequency
displays rms value of each harmonic on screen of CRO

⇒ What is the RF amplifier plate voltage when the audio-modulating voltage is +600
-600 V
Zero
600 V
1200 V

⇒ A 360 W carrier is simultaneously modulated by two audio wave with modulation percentage of 55 and 65 respectively. Total sideband power radiated will be
500 W
360 W
180 W
130 W

⇒

Assertion (A): Acceptor extrinsic semiconductor has higher conductivity than intrinsic semiconductor.

Reason (R): Addition of p-type impurity produces an allowable discrete energy level just above valence band.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a flip flop which input determines the state to which output will transistion?
Control input
Clock input
Both control and clock input
Either control or clock input

⇒

Assertion (A): A class C amplifier is a timed amplifier which needs a tank circuit as the load in the collector circuit of the transistor for its proper operation

Reason (R): In class C operation collector current flows for less than 180° of the ac cycle and thus flows in pulses

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ A better SNR can be obtained in a PCM by
increasing sampling rate above Nyquist rate
decreasing the code bits
reducing channel bandwidth
increasing Quantization levels

⇒ One limitation of constant k filters is that Z₀ is not constant in the pass band.
TRUE
FALSE

⇒

Assertion (A): PC-XT is a personal computer.

Reason (R): PC-XT uses a floppy drive and has a medium sized hard disc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following flip flops cannot be converted to D flip flop?
JK
SR
Master slave
None of the above

⇒

Match the following:

	List I (Properties)		List II (Relations)
A.	Linear but NOT time-invariant	1.	y(t) = t²x(t)
B.	Time-invariant but NOT linear	2.	y(t) = t \|x(t)\|
C.	Linear and time invariant	3.	y(t) = \|x(t)\|
		4.	y(t) = x(t - 5)

A-1, B-3, C-4
A-2, B-3, C-4
A-3, B-1, C-2
A-1, B-2, C-3

⇒ A 300 MHz plane EM wave is propagating in free space. The wave is incident normally on an infinite copper slap. The antenuation constant for the wave is (σ_copper = 5.8 x 10⁷ mho/ m)
262 x 10³
254 x 10³
352 x 10³
354 x 10³

⇒ The equivalent inductance measured between the terminals 1 and 2 for the circuit shown in the figur
L₁ + L₂ + M
L₁ + L₂ - M
L₁ + L₂ + 2M
L₁ + L₂ - 2M

⇒ When narrow current pulses drive a high Q resonant circuit the voltage across the circuit looks like
narrow pulses
half sine wave
almost sine wave
either (a) or (b)

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒

Assertion (A): An ac regulator uses natural commutation

Reason (R): An ac regulator can be used for static on load tap changing of transformer.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ In the synthesis of RLC network
the number of elements in Bott-Duffin synthesis and Brune's synthesis are always equal
the number of elements in Bott-Duffin synthesis is more than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis is less than that in Brune's synthesis
the number of elements in Bott-Duffin synthesis may be more or less than that in Brune's synthesis

⇒ Figure represen
Esaki diode
Triac
Varactor
Gunn diode

⇒ In a loss-less transmission line
R << ω L; G << ω C
R = ω L, G = ω C
R >> ω L; G >> ω C
none of the above

⇒ The response to sinusoidal excitation can be found by
setting s = jω in the network function
setting s = -jω in the network function
taking inverse transform of network function
none of the above

⇒ Which of the following element does not have three valence electrons?
Boron
Aluminium
Gallium
Phosphorus

⇒ (62)₁₀ in binary system is
110000
111100
111110
111111

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ For a paramagnetic material, susceptiblity increases with increasing temperature.
TRUE
FALSE