Question is ⇒ Noise can be reduced by increasing sampling rate, Options are ⇒ (A) TRUE, (B) FALSE, (C) can't say, (D) insufficient data, (E) , Leave your comments or Download question paper.

Question is ⇒ Noise can be reduced by increasing sampling rate, Options are ⇒ (A) TRUE, (B) FALSE, (C) can't say, (D) insufficient data, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Noise can be reduced by increasing sampling rate
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
C.	can't say [Wrong Answer]
D.	insufficient data [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is
29.8 m
2.98 m
2.1 m
0.21 m

⇒

Match the following:

	List I		List II
A.	FM	1.	slope-overload
B.	DM	2.	μ law
C.	PSK	3.	Envelope detector
D.	PCM	4.	Capture effect
		5.	Hilbert transform
		6.	Matched filter.

A-5, B-1, C-6, D-4
A-4, B-6, C-1, D-5
A-4, B-1, C-6, D-2
A-6, B-3, C-4, D-2

⇒ An A/D converter uses for reference purposes
DC voltage
a saw tooth generator
set of keys
a flip-flop

⇒ A single phase series converter is used for
high voltage output
high current output
high voltage and high current output
improving the circuit efficiency

⇒ Consider the following stateme
1 and 2
1 and 3
2 and 3
3 only

⇒ An 8 bit wide 4 word sequential memory has
Eight 4 bit shift registers
Eight 8 bit shift registers
Four 8 bit shift registers
Foui 4 bit shift registers

⇒ Modulation is also called detection.
TRUE
FALSE

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ In a simple on-off controller with differential gap, the magnitude of differential gap determines
the level of accuracy
the life of controller
both (a) and (b)
neither (a) nor (b)

⇒ Voltage series feedback (Also called series-shunt feedback) results in
increase in both I/P and O/P impedances
decrease in both I/P and O/P impedances
increase in I/P impedance and decrease in O/P impedance
decrease in I/P impedance and increase in O/P impedance

⇒ When sources of different frequencies feed a network the only method of solution is superposition theorem.
TRUE
FALSE

⇒ Which op-amp circuit uses a resistance in series with input and capacitor in feedback path?
Differentiating amplifier
Integrating amplifier
Logarithmic amplifier
Exponential amplifier

⇒ The output of a Mealy system is 1 if there has been a pattern of 11000, otherwise 0. The minimum state for this system is :
4
5
6
7

⇒ If figure, I = 2A if R = 20 Ω. When R = 10 Ω current I
0.0416666666666667
0.0833333333333333
2.5 A
0.125

⇒ The current gain of a transistor is the ratio of
emitter current to base current
emitter current to collector current
collector current to base current
collector current to emitter current

⇒ The main advantage of DM over PCM is
less bandwidth
less power
simple circuit
better S/N ratio

⇒ One ampere means the flow of
One coulomb each minute
One electron per second
One coulomb per second
One coulomb each hour

⇒ In broadside array
the principle direction radiation is perpendicular to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and perpendicular to the plane containing the array elements
the principle direction radiation is perpendicular to the array axis and parallel to the plane containing the array elements

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ Work function of oxide coated cathode is much lower than that of tungsten cathode.
TRUE
FALSE

⇒ In bridge circuit of figure, equivalent resistance between A and B
1 Ω
0.5 Ω
2 Ω
1.5 Ω

⇒ In a bipolar junction transistor a_dc = 0.98, I_CO= 2 μA and 1_B = 15 μA. The collector current I_C is
635 mA
735 mA
835 mA
935 mA

⇒ The condition AD - BC = 1 for two port network implies that the network is a
reciprocal
lumped element network
lossless network
unilateral element network

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ When avalanche breakdown occurs covalent bonds are not affected.
TRUE
FALSE

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code