Question is ⇒ Noise can be measured by, Options are ⇒ (A) D.C. voltmeter, (B) A.C. voltmeter, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Noise can be measured by, Options are ⇒ (A) D.C. voltmeter, (B) A.C. voltmeter, (C) either of the above, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Noise can be measured by
A.	D.C. voltmeter [Wrong Answer]
B.	A.C. voltmeter [Correct Answer]
C.	either of the above [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ In direct addressing mode of 8085
All instructions are 3 bytes long
All instructions are 3 bytes long except IN instruction which is 2 bytes long
All instructions are 3 bytes long except IN and OUT instructions which are 2 bytes long
All instructions are 2 bytes long

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ Consider the following about 'return' statement in C

On executing the return statement, it immediately transfers the control back to the calling program.
There is no restriction on the number of 'return' statements present in a function.
The 'return' statement must be present at the end of called function.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒

Assertion (A): The Laplace transform of a ramp is 1/s².

Reason (R): The integral of a unit step function gives an impulse function.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For real and odd signals, the Fourier series coefficient a_k is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd

⇒ Vestigial sideband is most commonly used in
radio transmission
television transmission
telephony
all of the above

⇒ For measuring current at a high frequency we should use
moving iron instrument
electrostatic instrument
thermocouple instrument
moving coil instrument

⇒ Impedance inversion may be obtained with
half wave line
a short circuited stub
complex impedance Z connected in series with line
quarter wave line

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ A T.V. station works at 300 MHz and radiates 100 kW of power. This signal received at a distance of 200 km will be
a few μV/m due to attenuation by atmosphere
1-5 mV due to ionospheric reflection
nil since propagation is line of sight
nil because signal fades completely at 300 MHz

⇒ The poles of an RC function
are simple and lie or negative real axis
are simple and lie on ω axis
must be complex conjugate
may be anywhere on s plane

⇒ A UPS contains
rectifier
inverter
either rectifier or inverter
both rectifier and inverter

⇒ In colour TV receiver, varactor diode is used for
detection
rectification
tuning
both (a) and (b)

⇒

Match the following:

	List I		List II
A.	h_ie	1.	siemens
B.	h_oe	2.	no units
C.	h_fe	3.	ohms

A-1, B-2, C-3
A-3, B-1, C-2
A-2, B-1, C-3
A-3, B-2, C-1

⇒ A 3 x 8 decoder with two enable inputs is to be used to address 8 blocks of memory. What will be the size of each memory block when addressed from a sixteen bit bus with two MSBs used to enable the decoder?
2 K
4 K
16 K
64 K

⇒ Directivity of antenna is defined as
maximum directive gain
average directive gain
∞
0

⇒ A TV remote control works on the principle of
pulse code modulated ultra violet light
pulse code modulated infrared light
demodulation
either (a) or (b)

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ For a distortionless line, the parameters are related as
R/G = L/C
R/L = 1
R/G = C/L
RG = LC

⇒ A current wave is i = 100e^-60t The initial and final values of current are
100 and 50
100 and 0
0 and 100
100 and 100

⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit

⇒ The number of logic or arithmetic operations with ALU 1C 74181 can carry out is
4
8
16
32

⇒ For a voltage transfer function H(s), realizable by RLC network, the following statements are made

H(s) cannot have a pole at s = 0
H(s) cannot have a pole at s = ± j4
H(s) cannot have a pole at s = ∞
H(s) cannot have a pole at s = + 2

Of these statements
3 and 4 are correct
2 and 4 are correct
1 and 2 are correct
1 and 3 are correct

⇒ The common emitter short circuit current gain β of a transistor
is a monotonically increasing function of the collector current I_c
is a monotonically decreasing function of I_c
increasing with I_c, for low I_c, reaches a maximum and then decreases with further increase in I_c
is not a function of I_c

⇒ Which of these devices is used in relaxation oscillator?
UJT
SCR
DIAC
TRIAC