Question is ⇒ Nodal analysis is applicable to __________ ., Options are ⇒ (A) planar network, (B) planar and Non-planar both, (C) circuit containing only voltage source, (D) non planer, (E) , Leave your comments or Download question paper.

Question is ⇒ Nodal analysis is applicable to __________ ., Options are ⇒ (A) planar network, (B) planar and Non-planar both, (C) circuit containing only voltage source, (D) non planer, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Nodal analysis is applicable to __________ .
A.	planar network [Wrong Answer]
B.	planar and Non-planar both [Correct Answer]
C.	circuit containing only voltage source [Wrong Answer]
D.	non planer [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The system with given pole-zero diagra
casual
non-casual
both sided
not-possible

⇒ Which one of the following is true for EM wave propagation through rectangular waveguide of cross-section 2a x a
critical wavelength for TE₁₀ mode is the same as that for TE₀₂ mode
critical wavelength for TE₁₀ mode is one half of that for TE₁₀ mode
critical wavelength for TE₁₀ mode is the same as that for TM₁₀ mode
critical wavelength for TE₁₀ mode is double that for TE₀₁mode

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?
CT
PT
Distribution transformer
Power transformer

⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
Frequency Division Multiple Access (FDMA)
Time Division Multiple Access (TDMA)
Code Division Multiple Access (CDMA)
All of the above

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Snubber circuit has an RC series circuit in parallel with SCR

Reason (R): Voltage across a capacitor can not change instantaneously.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
length of the circuit
whether supply frequency is 25 Hz or 50 Hz
amount of load on the circuit
cross-section of the circuit wires

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ The number of p-n junctions in a semiconductor diode are
0
1
2
1 or 2

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts

⇒ The channel required for FM telemetry is
same as required for AM telemetry
smaller than that required by AM telemetry
100 times that required for AM telemetry
10 times that required for AM telemetry

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
50 Ω
200 Ω
12.5 Ω
0 Ω

⇒ An induction wattmeter can be used for
dc only
50 Hz ac only
both ac and dc
high frequency ac only

⇒ The impurity commonly used for realizing the base region of a n-p-n transistor is
gallium
indium
boron
phosphorus

⇒ If an inductance L is connected in one arm of bridge and resistance R₁, R₂, R₃ in other three arms
the bridge cannot be balanced
the bridge can be balanced
the bridge is balanced for some specified value of frequency
the bridge is balanced for some specific values of R₁, R₂, R₃

⇒ Which of the following transformers has low primary current?
Current transformer
Potential transformer
Distribution transformer
Both (a) and (b)

⇒ If figure, power dissipated in 30Ω resistance will be maximum when value of
30 Ω
16 Ω
9 Ω
zero

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ Which of the following h parameters is an admittance?
h_ie
h_re
h_fe
h_oe

⇒ The inverse response of a system h(n) = aⁿ∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1

⇒

Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.

Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The output data lines of microprocessor and memories are usually tristated because
more than one device can transmit information over the data bus by enabling only one device at a time
more than one device can transmit information over the data bus at the same time
the data lines can be multiplexed for both I/P and O/P
it increases the speed of data transfers over the data bus

⇒ Which of the following amplifiers has highest output impedance?
CE
CB
CC
Push pull

⇒ A moving coil instrument has a resistance of 0.6 Ω and full scale deflection at 0.1 A. To convert it into an ammeter of 0-15 A range, the resistance of shunt should be
0.6 Ω
0.06 Ω
0.1 Ω
0.004 Ω

⇒ A copper specimen has resistivity equal to 1.8 x 10^-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^-8 Ω-m
2 x 10^-8 Ω-m
3 x 10^-8 Ω-m
6 x 10^-8 Ω-m

⇒ The antenna current of an AM broad cast transmitter, modulated to a depth of 40% by an audio sine wave is 11 amperes. It increased to 12 ampere as a result of simultaneous modulation by another sine wave. The modulation index due to this second sine wave is :
0.4
0.757
0.643
0.8

⇒ Directivity means
maximum directive gain
zero directive gain
minimum directive gain
none of the above

⇒ 8255 A is a
programmable peripheral interface
I/O device
memory chip
none of the above

⇒ IC 7485 cannot be cascaded.
TRUE
FALSE