Question is ⇒ Nichrome is used in, Options are ⇒ (A) heater coils, (B) underground cables, (C) overheated wires, (D) lamp filament, (E) , Leave your comments or Download question paper.

Question is ⇒ Nichrome is used in, Options are ⇒ (A) heater coils, (B) underground cables, (C) overheated wires, (D) lamp filament, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Nichrome is used in
A.	heater coils [Correct Answer]
B.	underground cables [Wrong Answer]
C.	overheated wires [Wrong Answer]
D.	lamp filament [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a differential amplifier, CMRR can be improved by using an increased
emitter resistance
collector resistance
power supply voltages
source resistance

⇒ In AM the amplitude of carrier components ... while in FM it
remains constant, does not remain constant
does not remain constant ... remains constant
remains constant... also remains constant
does not remain constant, also does not remain constant

⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of
10°C
25°C
50°C
75°C

⇒ If Z(s) has a pole at origin, the realization leads to
a resistance in series
an inductance in series
a capacitance in series
a resistance or capacitance in series

⇒ The external magnetic field in a magnetron is such that lines are
parallel to the axis of cathode
perpendicular to the axis of cathode
inclined to the axis of cathode
either (b) or (c)

⇒ The arrangement in the given figure is a hybid T. If 100 mW fed at port 1, the power reflected back at port
0
25 mW
50 mW
100 mW

⇒ An angle modulated signal is given by s(t) = cos 2p (2 x 10⁶t + 30 sin 150t + 40 cos 150t). The maximum frequency and phase deviations of s(t) are
10.5 kHz, 140p rad
6 kHz and 80p rad
10.5 kHz, 100p rad
7.5 kHz, 100p rad

⇒ Potentiometer method of dc voltage measurement is more accurate than direct measurement using a voltmeter because
it loads the circuit to maximum extent
it loads the circuit moderately
it does not load the circuit at all
it uses centre zero galvanometer instead of Voltmeters

⇒ A 'rat race' is a
hybrid junction for microwaves
a microwave oscillator
a microwave amplifier
a microwave antenna

⇒ An SCR is triggered at 80° in the positive half cycle, only. The rms anode current is 25 A. If the firing angle is changed to 160°, the rms current is likely to be
25 A
12.5 A
less than 25 A
less than 12.5 A

⇒ For a bit rate of 8 kbps, the best possible values of the transmitted frequencies in a coherent binary FSK system are
16 kHz and 20 kHz
20 kHz and 32 kHz
20 kHz and 40 kHz
32 kHz and 40 kHz

⇒ Which of the following correctly declares a pointer to an array of intergers in C?
int * P [20]
int * P
int (* P) [20]
int * (P [20])

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒ If γ = (S₀/N₀)/(S_i/N_m) where S₀ and S₁ are signal power output and signal power input and N₀ and N_m are noise power output and noise power input, the value of γ for SSB-SC and DSB-SC amplitude modulated system respectively are
1 and 1
1 and 2
2 and 1
0.5 and 0.5

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ The statement ! (b < 5) in C means
b = 5
b > 5
b > = 5
none of the above

⇒ Which of the following are linear ICs?
RF and IF amplifiers
Wide band amplifier
Audio amplifiers
All of the above

⇒ Consider the following circuits. Assume all gates to have finite propagation d
(1) only
(1) and (2) only
(2) (3) and (4) only
All (1) (2) (3) and (4)

⇒ What will be output for decimal input 82?
0.82 V
8 V
0.1 V
10 mV

⇒ The system of linear equations 4x + 2y = 1 , 2x + y = 6 has
a unique solution
no solution
an infinite number of solutions
exactly two distinct solutions

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ In a series RLC circuit the phase angle θ of impedance Z ∠θ is positive. The circuit will behave as
resistive circuit
RC circuit
RL circuit
either RL or RC circuit

⇒ Consider the following statements: The radar pulse must be flat topped to

allow accurate range measurement
allow good minimum range
prevent frequency changes in magnetron
make the returned echoes easier to distinguish from noise.

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
1, 2
1, 3, 4

⇒ The reflection coefficient on a 500 m long transmission line has a phase angle of - 150°. If the operating wavelength is 150 m, what will be the number of voltage maxima on the line?
0
3
6
7

⇒ A linear displacement digital transducer generally uses
straight binary code
BCD
gray code
hexadecimal code

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
Get doubled
Get tripled
Remains same
Become eight times

⇒ In a transistor I_E = 10 mA, I_CO = 0.5 μA and a = 0.995. Then I_CEO =
100 μA
25 μA
10.1 mA
10.5 mA

⇒ S is closed for a long time and steady state is reached. S is opened at t(0^-). The voltage marked V is V₀ at t = 0⁺ and V_f at t = ∞. Then value of V₀ and V_f are respecti
8, 8
0, 1
4, 0
4, 8

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW