Question is ⇒ Neutralization is used in RF amplifiers to, Options are ⇒ (A) stop oscillation, (B) increase bandwidth, (C) improve selectivity, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Neutralization is used in RF amplifiers to, Options are ⇒ (A) stop oscillation, (B) increase bandwidth, (C) improve selectivity, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Neutralization is used in RF amplifiers to
A.	stop oscillation [Correct Answer]
B.	increase bandwidth [Wrong Answer]
C.	improve selectivity [Wrong Answer]
D.	all of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following are donor impurities?

Gold
Phosphorus
Boron
Antimony
Arsenic
Induim

Select the correct answer using the following codes
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
2, 4, 5

⇒ The simplified logic expression for the circuit of the given figur
Y = A
Y = AB
Y = A + B
Y + A + B

⇒ Which one of the following rules determines the mapping of s-plane to z-plane?
Right half of the s-plane maps into outside of the unit circle in z-plane
Left half of the s-plane maps into outside of the unit circle.
Imaginary axis in s-plane maps in to the circumference of the unit circle.
All of the above

⇒ In figure, the current through R is 1 A when V_A = 0 and V_B = 15V. If both V_A and V_B are increased by 15V each, current through R wil
0.0416666666666667
0.5 A
0.125
0.33 A

⇒ A balun transformer gives an impedance transformation of
0.167361111111111
0.0840277777777778
0.0444444444444444
0.0430555555555556

⇒ If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycl
42737
42738
42741
42747

⇒ If e = 110 sin (ωt + p/3) and i = 5 sin (ωt - p/3), the impedance of the circuit is
22 Ω
16 Ω
30.8 Ω
11 Ω

⇒ It is difficult to write a program in a machine language.
TRUE
FALSE

⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple

⇒ In the circuit of figure, v₁ = v₂ = 10 V.
I₁ = I₂
I₁ > I₂
I₂ > I₁
I₁ = 0

⇒ A carry look ahead adder is frequently used for addition because
it costs less
it is faster
it is more accurate
is uses fewer gates

⇒ ALU carries out
arithmetic operations
logic operations
both arithmetic and logic operations
none of the above

⇒ A sinusoidal voltage amplitude modulates a carrier of peak value 5 kV. Each side band has an amplitude of 500 V. The modulation index is
0.1
0.2
0.4
0.8

⇒ The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback (β) would be
0.4
0.05
0.2
0.8

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ Equipotential surfaces about a point charge are in which one of the following forms?
Sphere
Planes
Cylinders
Cubes

⇒ A TE₁₀ rectangular waveguide is to be designed for operation over 25-35 GHz and the band centre is 1.5 times the cutoff frequency. The dimension of broadside is
15 mm
10 mm
9 mm
7.5 mm

⇒ The filter in figure, uses ideal op-amp. I
low pass filter
high pass filter
band pass filter
band stop filter

⇒ In the circuit of figure, the power consumed in resistance R is measured when one source is acting at one time. These values are 18 W, 50 W and 98 W. When all source act together the maximum and minimum power ca
98 W and 18 W
166 W and 18 W
450 W and 2 W
166 W and 2 W

⇒ In a microprocessor the clock signal
is always generated internally
is always supplied externally
may be generated internally or supplied externally
is mostly supplied externally

⇒ In the analogy between electric and magnetic circuits, flux is analogous to
current
voltage
rate of charge of current
rate of charge of voltage

⇒ CE mode input V-I characteristic can be shown by a plot of
V_BE versus i_B for constant values of V_CE
V_CB versus i_C for constant values of I_E
V_CE versus i_E for constant values of V_EB
V_CE versus i_E for constant values of V_CE

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A D' Arsonval galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ PAL system was proposed first in
USA
Japan
England
Germany

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ Poynting vector is associated with
flux in magnetic field
power flow in electrostatic field
current in electrostatic field
charge in electrostatic field

⇒ In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on
load resistance
input impedance of first stage
input impedance of second stage
all of the above

⇒ The primary constants of a transmission line are
R and L
R, L and C
R and C
R, L, G and C

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group