Question is ⇒ ∇<sup>2</sup> is, Options are ⇒ (A) vector, (B) scalar, (C) depend on direction, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ ∇<sup>2</sup> is, Options are ⇒ (A) vector, (B) scalar, (C) depend on direction, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	∇² is
A.	vector [Wrong Answer]
B.	scalar [Correct Answer]
C.	depend on direction [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm

⇒ Which of the following is an active device?
Transformer
Silicon controlled rectifier
Electric bulb
Loudspeaker

⇒ ALU 1C 74181 can accept two words each having
2 bits
4 bits
8 bits
16 bits

⇒ In shot noise
the current rises around mean value
the current rises to peak value, decreases to zero and then again rises
the current may become negative
the current is always less than the mean value

⇒ A ripple counter has 4 bits and uses flip flops with propagation delay time of 25 ns. The maximum possible time for change of state will be
25 ns
50 ns
75 ns
100 ns

⇒ Which of the following is incorrect?
11101 + 10 = 11111
(8)₈ + (2)₈ = (11)₈
(8)₁₆ + (7)₁₆ = E
All of them are incorrect

⇒ For AM receivers the standard IF frequency is
106 kHz
455 kHz
1.07 MHz
10.7 MHz

⇒ In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited
in phase
in phase opposition
90° out of phase with each other
45° out of phase with each other

⇒

Assertion (A): The output of an 8 bit ADC is 80 H if input is 2.5 V

Reason (R): ADC has an output range of 00 to FF H if input range is - 5 to + 5 V

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ Double integration of a unit step function would lead to
an impulse
a parabola
a ramp
a doublet

⇒ In force current analogy, displacement x is analogous to
charge
magnetic flux linkage
electrostatic energy
voltage

⇒ In ferromagnetic materials, the orientation between neighbouring permanent dipoles is parallel.
TRUE
FALSE

⇒ In figure, the charge on 0.8 μF capacito
100 μC
50 μC
40 μC
20 μC

⇒ Which device can detect the presence of both forward and backward waves in a waveguide?
Filter
Detector
Directional coupler
Magic T

⇒

Assertion (A): A 4 input variable logic circuit can be implemented using a 8 : 1 multiplexer.

Reason (R): When a multiplexer is used as a logic function generator, the logic design is simple.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ In the given figure reflection coefficient at loa
0.6
-0.6
0.4
-0.4

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ X and Y are two random variables and Z = X + Y . Letmz, m_z, m_x, m_y represent mean of Z, X and Y. Then
m_z = m_x + m_y
m_z ≤ m_x + m_y
m_z< m_x + m_y
m_z > m_x + m_y

⇒ In 2's complement addition, the carry generated in the last stage is
added to LSB
neglected
added to bit next to MSB
added to the bit next to LSB

⇒ A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about
127 V
120 V
110 V
100 V

⇒ The value of the integral of the function g(x, y) = 4x³ + 10y⁴ along the straight line segment from the point (0, 0) to the point (1, 2) in the x-y plane is
33
35
40
56

⇒ The product of which of the following gives the figure of merit of a logic family?
Gain and bandwidth
Propagation delay time and power dissipation
Fan-out and propagation delay time
Noise margin and power dissipation

⇒ Read the following statement

Multi-processing operation permits highly efficient parallel processing at several levels.
Multi processing involves use of several processing units jointly on a common program and severally on different programs.
In multi-processing the assignment of facilities to tasks, loading of programs and monitoring of I/O activity is taken care of by operating system.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ A three state switch has three outputs. These are
low, low and high
low, high, high
low. floating, low
low, high, floating

⇒ The dc voltage on plate modulated class C amplifier is 8 kV. If the peak modulating voltage is 4 kV, the peak RF voltage delivered to load is
32 kV
12 kV
0.5 kV
24 kV