Question is ⇒ Multiple member of antennas are arranged in arrays in order to enhance what property?, Options are ⇒ (A) Both directivity and bandwidth, (B) Only directivity, (C) Only bandwidth, (D) Neither directivity nor bandwidth, (E) , Leave your comments or Download question paper.

Question is ⇒ Multiple member of antennas are arranged in arrays in order to enhance what property?, Options are ⇒ (A) Both directivity and bandwidth, (B) Only directivity, (C) Only bandwidth, (D) Neither directivity nor bandwidth, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Multiple member of antennas are arranged in arrays in order to enhance what property?
A.	Both directivity and bandwidth [Wrong Answer]
B.	Only directivity [Correct Answer]
C.	Only bandwidth [Wrong Answer]
D.	Neither directivity nor bandwidth [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒ Homodyne detection means
coherent detection
non-coherent detection
asynchronous detection
none of the above

⇒

Match the following:

	List I (Power device)		List II (Max. frequency)
A.	Power Bipolar	1.	MHz
B.	Power MOSFET	2.	100 kHz
C.	SCR	3.	10 kHz
D.	Insulated gate bipolar transistor	4.	1 kHz

A-2, B-1, C-3, D-4
A-3, B-4, C-2, D-1
A-3, B-1, C-4, D-2
A-4, B-1, C-3, D-2

⇒ The PIV of a bridge rectifier is less than that of full wave rectifier with centre tapped transformer.
TRUE
FALSE

⇒ The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is
2.67 kWh
3 kWh
2.5 kWh
3.5 kWh

⇒ The mobility of e^- for Ge and Si respectively is
1.66, 2.5
2.5, 1.66
2.7, 2.33
2.33, 2.7

⇒ What is the characteristic impedance at 10 MHz?
547.7 Ω
54.7 Ω
5.47 Ω
.547 Ω

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ In a microwave power measurement using bolometer, the principle of working is variation of
inductance with absorption of power
resistance with absorption of power
capacitance with absorption of power
cavity dimension with heat generated by power

⇒ Which of the following statements is incorrect?
Ideal voltage source is one whose internal resistance is zero
Ideal voltage source is one whose internal conductance is zero
Ideal voltage source is one whose generated voltage is equal to the available terminal voltage
Ideal current source is one whose internal conductance is zero

⇒

Assertion (A): In CE connection of n-p-n transistor. V_CE is positive.

Reason (R): In BJT, the base collector junction is reverse biased.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The input to negative clamper has a peak value of V_p. Then in the output the positive and negative peaks are nearly
0 and -2 V respectively
V_p and -V_p respectively
2 V_p and 0 respectively
none of the above

⇒

Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following is not a general purpose peripheral?
I/O port
Programmable interrupt controller
Programmable CRT controller
Programmable interval timer

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ The specific gravity of tungsten is 13.8 and its atomic weight is 184.0 Assume that there are two free elements per atom. Then the Fermi level or characteristic energy for the crystal in eV will be
8.95 eV
-8.95 eV
7.326 eV
-7.326 eV

⇒ The magnitudes of OC and SC input impedances of a transmission line an 100 Ω and 25 Ω. The characteristic impedance is
25 Ω
50 Ω
75 Ω
100 Ω

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒

Assertion (A): Intrinsic resistivity of silicon is lower than that of germanium.

Reason (R): Magnitude of free electron concentration in germanium is more than that of silicon.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following stage is not present in AM receiver as compared to FM receiver?
AM amplifier
Demodulator
Amplitude limiter
AF amplitude

⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64

⇒ Which junction transistor is preferred for high input and low output impedances?
Common emitter
Common base
Common collector
Any of the above

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒ A material has conductivity of 10^-2 mho/m and a relative permittivity of 4. The frequency at which conduction current in the medium is equal to displacement current is
45 MHz
90 MHz
450 MHz
900 MHz

⇒ A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is
0.0083
0.01
0.0181
none of the above

⇒ CE mode input V-I characteristic can be shown by a plot of
V_BE versus i_B for constant values of V_CE
V_CB versus i_C for constant values of I_E
V_CE versus i_E for constant values of V_EB
V_CE versus i_E for constant values of V_CE

⇒ 7BF₁₆ = __________ ₂
0111 1011 1110
0111 1011 1111
0111 1011 0111
0111 1011 0011

⇒ A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about
50 dB
53 dB
100 dB
200 dB

⇒ Fourier transform of non periodic DT signal is
aperiodic
Periodic
both a and b
None of these