Question is ⇒ Multicore cables generally use, Options are ⇒ (A) square conductors, (B) circular conductors, (C) rectangular conductors, (D) sector-shaped conductors, (E) none of the above, Leave your comments or Download question paper.

Question is ⇒ Multicore cables generally use, Options are ⇒ (A) square conductors, (B) circular conductors, (C) rectangular conductors, (D) sector-shaped conductors, (E) none of the above, Leave your comments or Download question paper. Previous question Next question


Q1.	Multicore cables generally use
A.	square conductors [Wrong Answer]
B.	circular conductors [Wrong Answer]
C.	rectangular conductors [Wrong Answer]
D.	sector-shaped conductors [Correct Answer]
E.	none of the above [Wrong Answer]
View Answer 25 -19 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Corona is likely to occur maximum in
transmission lines
distribution lines
domestic wiring
all of the above

⇒ ____ are the conductors, which connect the consumer's terminals to the distribution
Distributors
Service mains
Feeders
None of the above

⇒ Transmission lines link
generating station to receiving end station
receiving end station to distribution transformer
distribution transformer to consumer premises
service points to consumer premises

⇒ The usual spans with R.C.C. poles are
40-50 metres
60-100 metres
80-100 metres
300-500 metres

⇒ A 3-phase 4 wire system is commonly used on
primary transmission
secondary transmission
primary distribution
secondary distribution

⇒ The underground system cannot be operated above
440 V
11 kV
33 kV
66 kV

⇒ The top most conductor in a high transmission line is
earth conductor
R-phase conductor
Y-phase conductor
B-phase conductor

⇒ The power factor of industrial loads is generally
unity
lagging
leading
zero

⇒ The effect of wind pressure is more predominant on
supporting towers
neutral wires
transmission lines
insulators

⇒ The operating voltage of supertension cables is upto
3.3 kV
6.6 kV
11 kV
33 kV

⇒ A lightning arrester is usually located nearer to
transformer
isolator
busbar
circuit breaker

⇒ The surge resistance of cables is
20 ohms
50 ohms
200 ohms
300 ohms

⇒ Which of the following equipment is used to limit short-circuit current level in a substation ?
Isolator
Lightning switch
Coupling capacitor
Series reactor

⇒ Which of the following regulations is considered best ?
0.5
0.2
0.1
0.02

⇒ Low voltage cables are meant for use up to
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV

⇒ In the cables sheaths are used to
prevent the moisture from entering the cable
provide strength to the cable
provide proper insulation
none of the above

⇒ By using bundled conductors which of the following is reduced ?
Power loss due to corona
Capacitance of the circuit
Inductance of the circuit
None of the above

⇒ The effect of ice on transmission line conductors is to increase the
transmission losses
weight of the conductor
tendency for corona
resistance to flow of current

⇒ When a conductor carries more current on the surface as compared to core, it is due to
permeability variation
corona
skin effect
unsymmetrical fault

⇒ Electro-mechanical voltage regulators are generally used in
reactors
generators
transformers
all of the above

⇒ Distribution lines in India generally use
wooden poles
R.C.C. poles
steel towers
none of the above

⇒ The voltage drop, for constant voltage transmission is compensated by installing
inductors
capacitors
synchronous motors
all of above

⇒ The cause of damage to the lead sheath of a cable is
crystallisation of the lead through vibration
chemical action on the lead when buried in the earth
mechanical damage
all of the above

⇒ High voltage is primarily used, for long distance power transmission, to
reduce the time of transmission
reduce the transmission losses
make the system reliable
none of the above

⇒ The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the
Seeback effect
Ferranti effect
Raman effect
none of the above

⇒ The following system is not generally used
1-phase 3 wire
1-phase 4 wire
3-phase 3 wire
3-phase 4 wire

⇒ Conductors for high voltage transmission lines are suspended from towers to
increase clearance from ground
reduce clearance from ground
take care of extension in length during summer
reduce wind and snow loads

⇒ By which of the following methods string efficiency can be improved ?
Using a guard ring
Grading the insulator
Using long cross arm
Any of the above

⇒ Which of the following is a static exciter ?
Rectifier
Rotorol
Amplidyne
D.C. separately excited generator