Question is ⇒ MUF is highest in periods of greatest sunspot activity., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ MUF is highest in periods of greatest sunspot activity., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	MUF is highest in periods of greatest sunspot activity.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If other parameter are constant, transmission loss at 5 GHz as compared to that at 0.5 GHz is
20 dB more
20 dB less
700 dB more
100 dB less

⇒ Conductivity σ, mobility μ and Hall coefficient K_H are related as
μ = σK_H
σ = μK_H
K_H = μσ
K_H =(μσ)^1.1

⇒ Between which points does UJT exhibit negative resistance characteristics
between peak and valley points
before peak point
after peak point
after valley point

⇒ Which of the following is λ/2 length?
Marconi
Hertz
Parabolic
Yagi-uda

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒ Wagner earthing device eliminates
all stray capacitance in the circuit
stray capacitances between components
stray capacitance between detector terminal and ground
mutual coupling between components

⇒ Which of the following operation are performed on linear queues?

Testing a linear queue for underflow
Enqueue operation
Dequeue operation
Testing a linear queue for overflow.

Select the correct answer using the codes given below the lists
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2, 3 and 4

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°

⇒ The attenuation in waveguides near the cut off frequency is
very low
very high
medium
zero

⇒ The number of bits in EBCDIC is
12
10
8
6

⇒ The image frequency of a superheterodyne receiver is
created within the receiver itself
not rejected by IF tuned circuits
independent of the frequency of tuning
due to insufficient adjacent channel rejection

⇒ In a CE amplifier connection, the emitter is at ground potential for
AC quantities
DC quantities
all quantities
none of the quantities

⇒ In a single phase full wave ac regulator the rms value of load current is 20 A load is purely resistive. Then
average thyristor current will be less than 20 A but rms thyristor current will be more than 20 A
both the average and rms thyristor currents will be less than 20 A
both the average and rms thyristor currents will be more than 20 A
rms thyristor current will be 20 A and average thyristor current will be 10 A

⇒ A load Z_L = R_L + jX_L is to be matched using an ideal transformer to generator of internal impedance Z_S = R_S + jX_S. The ratio of transformer required is __________ .
|Z_S|/|Z_L|
R_L/R_S
R_L/Z_S
|Z_L|/R_S

⇒ Which of the following statements is not correct?
Propagation delay is the time required for a gate to change its state
Noise immunity is the amount of noise which can be applied to the input of a gate without causing the gate to change state
Fan-in of a gate is always equal to fan-out of the same gate
Operating speed is the maximum frequency at which digital data can be applied to a gate

⇒ Antenna used for direction finding is
long dipole
parabolic
rhombic
helical

⇒ The open collector gates in the given figure are tied together. The output
A + B + C + D
A + B + C + D
(A + B) (C + D)
AB + CD

⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above

⇒ Kelvin's double bridge is used to measure low resistances because
it has high sensitivity
there is no thermoelectric emf
resistance variation due to temperature
effect of contact and lead resistances is eliminated

⇒

Assertion (A): In a serial in-serial out shift register, access is available only to the left most or right most flip flops

Reason (R): If the output of a shift register is feedback to serial input it can be used as a ring counter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a parallel inverter
the commutating capacitor C is across the primary of transformer and the load is across the secondary
the commutating capacitor and load are connected across the secondary of transformer
the commutating capacitor C and load are connected in series and the combination is across the secondary of transformer
none of the above

⇒ The portion of the atmosphere closest to ground is called ionosphere.
TRUE
FALSE

⇒ -8 is equal to signed binary number
10001000
1000
10000000
11000000

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ For the two port of figure, z_{1126/7 Ω
10/3 Ω
6 Ω
2 Ω}

⇒

Assertion (A): Alkali metals are used as emitters in phototubes.

Reason (R): Alkali metals have low work functions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In oscillator circuits the energy feedback to its input terminal from output is
always in phase with the input signal
90° out of phase with the input signal
180° out of phase with the input signal
270° out of phase with the input signal

⇒ A PC can be upgraded to a multimedia PC by adding CD ROM drive, sound card etc.
TRUE
FALSE

⇒ A single phase semiconverter is feeding a highly inductive load and has freewheeling diode across the load. The waveshapes of output voltage and output current
are similar
are not similar
may be similar or dissimilar
are similar only if firing angle is zero