Question is ⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of, Options are ⇒ (A) 10°C, (B) 25°C, (C) 50°C, (D) 75°C, (E) , Leave your comments or Download question paper.

Question is ⇒ Most of the transistor data sheets specify the power rating for an ambient temperature of, Options are ⇒ (A) 10°C, (B) 25°C, (C) 50°C, (D) 75°C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Most of the transistor data sheets specify the power rating for an ambient temperature of
A.	10°C [Wrong Answer]
B.	25°C [Correct Answer]
C.	50°C [Wrong Answer]
D.	75°C [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A discrete zero memory information source has 40 symbols and each symbol is equally likely. The minimum number of bits required to code the source with uniform length code and entropy of the source are
5 and 5.03
6 and 5.83
5 and 6.64
6 and 5.32

⇒ The function of a modulator is to
separate two frequencies
extract information from the carrier
amplify the audio frequency signal
impress the information on to a RF carrier

⇒ In the saturation region of CE output characteristics of n-p-n transistor, V_CE is about
0.5 V
15 V
- 0.5 V
- 15 V

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

⇒ The output impedance of an ideal op-amp is
zero
low
high
infinite

⇒ A Varactor diode has
a fixed capacitance
a fixed inductance
a voltage variable capacitance
a current variable inductance

⇒ If transmission path, in PCM, is very long then
repeater stations are used
pulse width may be increased
pulse amplitude is increased
pulse spacing is reduced

⇒ Consider the following stateme
1 and 2
2 and 3
3 and 4
4 and 5

⇒ Space wave may be a direct wave or wave reflected from earth.
TRUE
FALSE

⇒ Thyristors connected in series need static and dynamic stabilizing circuits.
TRUE
FALSE

⇒ In a CE amplifier drives a low load resistance directly the result will be
overloading of amplifier
underloading of amplifier
overloading or underloading of amplifier depending on circuit
none of the above

⇒ The wave propagation occurs without attenuation in case of a
conductor
semiconductor
perfect dielectric
none of the above

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is
1 kΩ
200 kΩ
100 kΩ
50 kΩ

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ The value of 2⁵ in octal system is
40
20
100
200

⇒ At room temperature the barrier potential in a silicon diode is
0.1 V
0.3 V
0.7 V
1 V

⇒ In which of the following 8085 instructions no condition flags are affected?
INX rp
INR r
SBI data
INR M

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ For the circuit shown in the figure, D has a transition from 0 to 1 after CLK changes from 1 to 0. Assume gate delays to be neglig
Q goes to 1 to the CLK transition and stays at 1
Q goes to 0 at the CLK transition and stays at 10
Q goes to 1 at the CLK transition and goes to 0 when D goes to 1
Q goes to 0 at the CLK transition and goes to 1 when D goes to 1

⇒ Consider the Schmitt trigger circuit shown below. A triangular wave which goes from - 12 V to 12 V is applied to the inverting input of the op-amp. Assume that the output of the op-amp moves from +15 V to -15 V. The voltage at the non-inverting switches bet
-12 V and +12 V
-7.5 V and +7.5 V
-5 V and +5 V
0 V and 5 V

⇒ The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has directivity of 100 is
15.92
31.84
2.18
3.184

⇒ The kinetic energy of photoelectrons emitted by a photo sensitive surface depends on
intensity of the incident radiation
wavelength of the incident radiation
surface conditions of the surface
angle of incidence of radiation

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is
0.25
0.5
0.75
1

⇒ Transverse electric (TE) waves have
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ In P-N junction, the region containing the uncompensated acceptor and donor ions is called
transition zone
depletion region
neutral region
active region

⇒ A directional microphone gives an output of 0.5 mV whereas an omnidirectional one gives an output of 0.5 μV in the same position for the same sound pressure. The directivity of the directional microphone is
120 dB
90 dB
60 dB
30 dB