Question is ⇒ MOS circuits as compared to bipolar circuits take, Options are ⇒ (A) more chip area, (B) less chip area, (C) same chip area, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ MOS circuits as compared to bipolar circuits take, Options are ⇒ (A) more chip area, (B) less chip area, (C) same chip area, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	MOS circuits as compared to bipolar circuits take
A.	more chip area [Wrong Answer]
B.	less chip area [Correct Answer]
C.	same chip area [Wrong Answer]
D.	none of these [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ Two thyristor of same rating and same specifications
will have equal turn on and turn off periods
will have equal turn on but unequal turn off periods
may have equal or unequal turn on and turn off periods
will have unequal turn on and turn off periods

⇒ In figure, Z₁ = 200∠60° Ω, Z₂ = 400∠ - 90° Ω, Z₃ = 300∠0°. Then Z₄ for bridge to be balanced
150∠30° Ω
400∠ - 90° Ω
300∠90° Ω
600∠ - 150° Ω

⇒ A voltage wave is v = 50 sin ωt. Its average value calculated over full one cycle is
zero
35.36 V
31.85 V
none of the above

⇒ CMOS is extensively used in
pocket calculators
digital wrist watches
satellites
all of the above

⇒ Load cell uses
piezoelectric crystal
capacitor
mutual inductance
strain gauge

⇒ Which of the following element has four valence electrons?
Silicon
Germanium
Both (a) and (b) above
None of the above

⇒ The ripple factor of a full wave rectifier is about 0.5
TRUE
FALSE

⇒ A resistance is measured by voltmeter-ammeter method. The voltmeter is 0-250V, ± 1% accuracy and ammeter is 0-5 A, ± 1 % accuracy. The readings of voltmeter and ammeter are 100 V and 2 A respectively. The error in the measured resistance can be
± 1%
± 2%
± 5%
± 10%

⇒ Advanced low power Schottky is a part of
ECL family
CMOS family
TTL family
none of the above

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ In the circuit of figure the current through 5 Ω resistance at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ The primary function of a clamper circuit is to
suppress variations in signal voltage
raise +ve half cycle to the signal
Lower -ve half cycle of the signal
introduce a dc level into an a.c. signal

⇒ In a circular waveguide with radius r, the dominant mode is
TM₀₁
TE₀₁
TM₁₁
TE₁₁

⇒ A single phase full wave regulator feeds R-L load. The best gating signal is
short duration pulses
long duration pulses
pulse train
either (a) or (b)

⇒ Which of the following is not a key word in C?
pop
for
if
union

⇒ The output of a full adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ Rank of the matr
3
2
1
4

⇒

Assertion (A): ∈₀ has the dimensions of farad per meter.

Reason (R): D = ∈₀∈_r E.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron
will be increased
will be decreased
will remain the same
either (a) or (b)

⇒ In the case of an amplifier, the normalised voltage gain is given
f_P >> f₀
f_P = f₀
f_P << f₀
f₀ = 2 f_P

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒

Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Fourier transform pair are
autocorrelation and power spectral density
autocorrelation and convoloution
convolution and power spectral density
autocorrelation and energy

⇒ As compared to dimensions of most feeds, the skin depth at microwave frequencies is
of the same magnitude
much larger
much smaller
either (b) or (c)

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ A volt ratio box should have low resistance.
TRUE
FALSE

⇒ The symbol in figure is
DIAC
P-N junction diode
Schottky diode
None of the above

⇒ Unlimited number of ICs 7490, 78492 and 7493 are available. Which of these could be used to build the dividse-by-60 circuit of fi
7490
7492
combination of 7490 and 7492
combination of 7492 and 7493

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer