Question is ⇒ Minimum number of J-K flip-flop needed to construct a <i>BCD</i> counter is, Options are ⇒ (A) 2, (B) 3, (C) 4, (D) 5, (E) , Leave your comments or Download question paper.

Question is ⇒ Minimum number of J-K flip-flop needed to construct a <i>BCD</i> counter is, Options are ⇒ (A) 2, (B) 3, (C) 4, (D) 5, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Minimum number of J-K flip-flop needed to construct a BCD counter is
A.	2 [Wrong Answer]
B.	3 [Wrong Answer]
C.	4 [Correct Answer]
D.	5 [Wrong Answer]
View Answer 6 -7 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure, I_C &as
I₁
I_B
0.5 I₁
0.5 I_B

⇒ Consider the following statements as regards IF in radio receivers

If IF is too high, poor selectivity and poor adjacent channel rejection could result
If IF is high, tracking difficulties increase
A very low IF makes selectivity too sharp
As IF is decreased, image frequency rejection becomes better

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ A line has standing waves with a voltage maximum of 35 mV and minimum of 17.5 mV VSWR is
2
4
0.5
0.25

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ A CE amplifier has a high input signal. In the wave shape of emitter current
positive and negative half cycles will be symmetrical
positive half cycle will be elongated and negative half cycle will be compressed
positive half cycle will be compressed and negative half cycle will be elongated
the half cycles may be either elongated or compressed

⇒ The core of a solenoid is made of material of relative permeability μ_r. A small cavity area dA and length dl is cut in the core. If it is desired that flux density in the cavity should be equal to B₀
the fields inside and outside the cavity must be equal
the field inside the cavity must be made stronger than field outside the cavity
the field inside the cavity must be made weaker than the field outside the cavity
none of the above

⇒ Permeance is analogue to
reluctance
conductance
capacitance
resistance

⇒ Transconductance indicates the
control of output voltage by input voltage
control of output current by input voltage
control of input voltage by output current
control of input current by input voltage

⇒ Consider the following statements Timer 555 can be used as

monostable multivibrator
bistable multivibrator
astable multivibrator

Which of the above statements are correct?
1 and 2
1 and 3
2 and 3
1, 2, 3

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ A two-input OR gate is designed for positive logic. However, it is operated with negative logic. The resulting logic operation will then be
OR
AND
NOR
EX-OR

⇒ In Bode plots, frequency is plotted on log scale.
TRUE
FALSE

⇒ In a multiphase chopper, all choppers operate together.
TRUE
FALSE

⇒ An excitation is applied to a system at t = T, and its response is zero for -∞ < t < T, such a system is
non-causal system
Stable system
causal system
unstable system

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5

⇒ Insulation resistance of a cable is directly proportional to its length.
TRUE
FALSE

⇒ A difference amplifier using op-amp has closed loop gain = 50. If input is 2 V to each of inverting and non-inverting terminals, output is 5 mA. Then CMRR =
20000
2000
200
20

⇒ Which of the following circuits come under the class of sequential logic circuits?

Full adder
Full subtractor
Half adder
J-K flip-flop
Counter

Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒ The total number of leads in MOS controlled thyristor is
2
3
4
2 or 3

⇒ When slider of the potentiometer AB is in the position shown in figure, what resistance reading would be indicated by an ohmmeter connected between A an
zero
infinite
can't say
none of the above

⇒ In the wheatstone bridge in figure, each resistance is increased by 0.05%. The value of v₀ will
50 mV
5 mV
0.1 mV
zero

⇒ The collector voltage V_C of the circuit shown in the given figure aside is approxima
2 V
4.6 V
8 V
8.6 V

⇒ In a D-type latch EN = 1, D = 1, the O/P is
1
0
don't care
blocked

⇒ In the given figure shows the equivalent circuit of a magic tee. If all ports are mat
n_E = n_H = 2
n_E = n_H = 0.707
n_E = 2, n_H = 0.707
n_H = 0.707, n_H = 2

⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64

⇒ In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.
TRUE
FALSE

⇒ In the following limiter circuit, an input voltage V₁ = 10 sin 100pt applied. Assume that the diode drop is 0.7 V when it is forward biased. The zener breakdown voltage is 6
6.1 V, -0.7 V
0.7 V, -7.5 V
7.5 V, -0.7 V
7.5 V, -7.5 V