Question is ⇒ Microwave signals transmitted towards the sky are, Options are ⇒ (A) strongly absorbed by the ionosphere, (B) strongly reflected by the ionosphere, (C) transmitted through the ionosphere, (D) unable to reach the ionosphere because of strong absorption in the lower atmosphere, (E) , Leave your comments or Download question paper.

Question is ⇒ Microwave signals transmitted towards the sky are, Options are ⇒ (A) strongly absorbed by the ionosphere, (B) strongly reflected by the ionosphere, (C) transmitted through the ionosphere, (D) unable to reach the ionosphere because of strong absorption in the lower atmosphere, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Microwave signals transmitted towards the sky are
A.	strongly absorbed by the ionosphere [Wrong Answer]
B.	strongly reflected by the ionosphere [Wrong Answer]
C.	transmitted through the ionosphere [Correct Answer]
D.	unable to reach the ionosphere because of strong absorption in the lower atmosphere [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ RAMs can be built with bipolar or CMOS transistor RAMs that are not possible with bipolar transistors are
SRAM
SRAM, DRAM
DRAM
PROM

⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit

⇒ In FM, as bandwidth increases
distortion increases
distortion decreases
distortion remains unaffected
all

⇒ The circuit given bel
Circuit is band stop with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is band pass with two edge frequency of 39.7875 Hz to 1592 Hz
Circuit is oscillator, oscillation at two frequencies 39.7875 Hz to 1592 Hz depending on R₃, R₄, R₅ and R₆
None of these

⇒ The noise figure of FET circuit is
independent of the quiescent point
dependent on the quiescent point only
dependent on the triggering mechanism
independent of all above

⇒ In a photo transistor the photocurrent is
emitter base junction
collector base junction
collector
either (a) or (b)

⇒

Assertion (A): Two terminal black boxes of R and C can be identified by plotting their static V-I characteristics.

Reason (R): The V-I characteristic of resistance is a straight line of slope R passing through origin.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ In which material do conduction and valence bands overlap
insulators
conductors
both conductor and semiconductor
semiconductors

⇒ An instrument of accuracy class 1 can have an error equal to
+ 1% of reading
± 1% of reading
± 1% of full scale deflection
+ 1% of full scale deflection

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ The damping coefficient for the given circuit is _______
42737
42739
2
1

⇒ DC tachogenerator can be used in
speed control system
position control system
both (a) and (b)
neither (a) nor (b)

⇒ The series element for a prototype high pass filter is
resistive
inductive
capacitive
combination of L and C

⇒

Assertion (A): A PROM is a user programmable ROM.

Reason (R): After programming PROM behaves like ROM.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ An 8085 microprocessor is operating at 2 MHz frequency and executes the following progr
12
13
14
15

⇒ The impedance inversion may be objected with
a short-circuited stub
an open-circuited stub
a half-wave line
a quarter-wave line

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the
magnitude of the loop gain
onset if non-linearity
magnitude of gain of the amplifier
feedback transmission factor

⇒ A capacitance transducer has two plates each of area 5 mm². The coil gap is 2 mm. Displacement sensitivity due to change in gap length is
11.1 pF/cm
44.2 pF/cm
52.3 pF/cm
66.3 pF/cm

⇒ Serial in-serial out shift register can be built using D flip flops.
TRUE
FALSE

⇒ For 2 port reciprocal network, o.c. output voltage divided by input current is equal to
B
z₁₂
1/y₁₂
h₁₂

⇒ Consider a 565 PLL with R_T = 10 kΩ and C_T = 0.01 μF. What is the output frequency of the VCO?
10 kHz
5 kHz
2.5 kHz
1.25 kHz

⇒ If a function Z(s) has a pole at infinity, then
the degrees of numerator and denominator are equal
the degree of numerator is one higher than that of denominator
the degree of denominator is one higher than that of numerator
the difference between the degrees of numerator and denominator is 0 or 1

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ An amplifier with loop gain Aβ will be more stable for value of Aβ as
0.95
0.7
1.2
1.5

⇒ A class B amplifier

is biased just at cutoff
has a high theoretical efficiency of 78.5% because its quiescent current is low
is biased at midpoint of load line

Of the above statements
2 and 3 are correct
1 alone is correct
1 and 2 are correct
2 alone is correct

⇒ A 3 kV circuit uses SCR of 800 V rating. If derating is 25%, the number of SCRs in series is
4
5
6
8

⇒ A radar receiver has a noise figure of 10 dB at 300 K having a bandwidth of 2.5 MHz. The minimum power it can receive is
3.45 x 10^-15 W
1.38 x 10^-15 W
7.5 x 10^-15 W
93.15 x 10^-15 W

⇒ Which of the following is the point of reference JFET?
Drain
Gate
Source
None of the above