Question is ⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has, Options are ⇒ (A) 16 bit registers and 32 bit data bus, (B) 16 bit registers and 16 bit data bus, (C) 32 bit registers and 32 bit data bus, (D) 32 bit register and 16 bit data bus, (E) , Leave your comments or Download question paper.

Question is ⇒ Microprocessor 386SX is a 16/32 bit microprocessor. It has, Options are ⇒ (A) 16 bit registers and 32 bit data bus, (B) 16 bit registers and 16 bit data bus, (C) 32 bit registers and 32 bit data bus, (D) 32 bit register and 16 bit data bus, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Microprocessor 386SX is a 16/32 bit microprocessor. It has
A.	16 bit registers and 32 bit data bus [Wrong Answer]
B.	16 bit registers and 16 bit data bus [Wrong Answer]
C.	32 bit registers and 32 bit data bus [Wrong Answer]
D.	32 bit register and 16 bit data bus [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In which material do conduction and valence bands overlap
insulators
conductors
both conductor and semiconductor
semiconductors

⇒ In communication systems the frequency range used for voice is
15 Hz to 150 Hz
30 Hz to 1000 Hz
100 Hz to 1500 Hz
300 Hz to 3800 Hz

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ If A = B = 1, the outputs P and Q in the given figure
P = Q = 0
P = 0, Q = 1
P = 1, Q = 0
P = Q = 1

⇒ Choose the correct option
tree does not contain any loop
tree contain all the nodes
tree is always open
all

⇒ The advantage of Weinbridge oscillator over the phase shift oscillator is that oscillator the frequency may be varied over a range of
0.0430555555555556
0.04375
0.0451388888888889
0.0486111111111111

⇒

Assertion (A): Slotted line is frequently used for microwave measurements.

Reason (R): The unknown impedance is mounted at the end of slotted line.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A semiconverter feeding an RLE load operates in
first quadrant only
first and second quadrants
first and fourth quadrants
first and third quadrants

⇒ In which amplifier circuit is gate conductance negligible?
JFET amplifier
MOSFET amplifier
Both JFET and MOSFET amplifier
None of the above

⇒ A shift register can be used for all of the following EXCEPT
ring counter
A/D conversion
series to parallel conversion
generation of delay

⇒ In a CE amplifier drives a low load resistance directly the result will be
overloading of amplifier
underloading of amplifier
overloading or underloading of amplifier depending on circuit
none of the above

⇒ Which of the following represents the decimal form of binary 0.0111?
0.16
0.22728
0.9375
0.7964

⇒ Which of the following is not a valid logical expression in Pascal?
A > = B
A < = B
A = < B
A < > B

⇒ The advantages of high density IC are
more circuits on chip
high operating speed
low power consumption
both (a) and (b)

⇒ Consider the following statements about PCM

PCM is not noise resistant
PCM requires complex encoding and quantizing circuitry
PCM requires large bandwidth

Which of the above are correct?
1 only
1, 2, 3
2, 3
1 and 3

⇒ Consider the following in C

An arithmetic operation between integer and an integer gives integer as the result.
An arithmetic operation between a real and a real constant gives real constant as the result.
An arithmetic operation between an integer constant and a real constant is not valid.

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Shifting digits from left to right and vice versa is needed in
storing numbers
arithmetic operations
counting
storing and counting

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when
surface potential is equal to Fermi potential
surface Potential is greater than Fermi potential
surface potential is - ve and equal to Fermi potential in magnitude
surface potential is + ve and equal to twice the Fermi potential

⇒ Parallel wire transmission line is an example of
lumped network
distributed
depend upon I/P signal strength
power I/P

⇒ RAM can be expanded to
increase word size
increase word number
either increase word size or increase word number
none of the above

⇒ An n type semiconductor is illuminated by a steady flux of photons with energy greater than the band gap energy. The change in conductivity Δσ obeys which relati
Δσ = 0
Δσ = e(σ_n + σ_p) Δ_n
Δσ = e(μ_nΔ_n - μ_pΔ_p)
Δσ = e μ_nΔ_n

⇒ Consider the following functions

It detects the AM video carrier IF so as to produce the video signal
It produces and separates out the inter carrier sound IF of 5.5 MHz
It amplifies the video signal
It amplifies the audio signal

The video detector in a colour TV performs which of the above functions
1, 2 and 3
1, 2, 3 and 4
1 and 2
1, 2 and 4

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ A metal loses electrons at room temperature.
TRUE
FALSE

⇒ BCD numbers are useful whenever
binary to hexadecimal conversion is desired
binary to BCD conversion is desired
decimal information is transferred into or out of a digital system
none of the above

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ Transient current in a loss free LC circuit when excited from an ac source is an __________ sine wave.
undamped
over damped
under damped
critically damped

⇒ The most widely used diode rectifier circuit is
half wave
full wave with centre tapped transformer
bridge
either (a) or (b)