Question is ⇒ Method of images is applicable to which fields?, Options are ⇒ (A) Electrostatic fields only, (B) Electrodynamic fields only, (C) Neither electrostatic fields nor electro-dynamic fields, (D) Both electrostatic fields and electro-dynamic fields, (E) , Leave your comments or Download question paper.

Question is ⇒ Method of images is applicable to which fields?, Options are ⇒ (A) Electrostatic fields only, (B) Electrodynamic fields only, (C) Neither electrostatic fields nor electro-dynamic fields, (D) Both electrostatic fields and electro-dynamic fields, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Method of images is applicable to which fields?
A.	Electrostatic fields only [Correct Answer]
B.	Electrodynamic fields only [Wrong Answer]
C.	Neither electrostatic fields nor electro-dynamic fields [Wrong Answer]
D.	Both electrostatic fields and electro-dynamic fields [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following exhibits negative resistance in a portion of its characteristics?
Tunnel diode
Zener diode
JFET
MOSFET and tunnel diode

⇒ Karnaugh map is used to
minimise the number of flip flops in a digital circuit
minimise the number of gates only in a digital circuit
minimise the number of gates and fan in a digital circuit
design gates

⇒ If f₁ (t) and f₂ (f) are two functions of time and a and b are constants, then
L [af₁(t) + bf₂(t)] = aF₁(s) + bF₂(s)
L [af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)
L [af₁(t) + bf₂(t)] =[aF₁(s)]/[bF₂(s]
None of the above

⇒ A voltage doubler circuit is fed by a voltage V_m sin ωt. The output voltage will be nearly 2 V_m only if
load resistance is small
load resistance is large
load resistance is neither small nor large
either (a) or (c)

⇒ Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulse
100 kHz
1000 kHz
10 kHz
1 kHz

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R₁
condenser C₂
condenser C₁
inductor L

⇒ If A = 16 ∠64°, (A)^0.5 is
4∠64°
4∠8°
4∠128°
4∠32°

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒ A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is
2.5
60
10⁴
10⁶

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?
12333
14666
16384
16655

⇒ In a series RC circuit Z = (R² + ω²C²)^0.5.
TRUE
FALSE

⇒ The word enhancement mode is associated with
tunnel diode
MOSFET
JFET
photo diode

⇒ In the fabrication of n-p-n transistor in an IC, the buried layer on the P-type substrate is
P⁺ -doped
n⁺ -doped
used to reduce the parasitic capacitance
located in the emitter region

⇒ It is found that a ship to ship communication suffers from fading. This can be avoided by using
space diversity
frequency diversity
broad band antenna
directional antenna

⇒ Present day HVDC converters are all
3 pulse converters
6 pulse converters
12 pulse converters
either 6 pulse or 12 converters

⇒ The resistance of resistance strain gauge is about
5 Ω
50 Ω
120 Ω
0.5 Ω

⇒ To couple a coaxial line to a parallel wire line, it is best to use a
balun
slotted line
quarter wave transformer
directional coupler

⇒ For a good public address system the sound intensity at the farthest point should be at least
20 dB over threshold of hearing
40 dB over threshold of hearing
80 dB over threshold of hearing
120 dB over threshold of hearing

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ R, L and C are in parallel. The circuit is switched on to a constant current source I at t = 0. At t = ∞ the current through inductance is I.
TRUE
FALSE

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ Which one condition is true to check the periodically for discrete time signal (where K is any integer, N is period, f₀ is frequency of signal)
f₀ = K/N
f₀ = K + N
f₀ = KN
f₀ = N/K

⇒ A current wave is i = 100e^-60t The initial and final values of current are
100 and 50
100 and 0
0 and 100
100 and 100

⇒ Electromagnetic waves transport
energy only
momentum only
energy as well as momentum
neither energy nor momentum

⇒ At a particular time it is observed that the frequencies of F layer at Delhi is 3 MHz the maximum electron density is
11 x 10¹⁰
1.1 x 10¹⁰
0.11 x 10¹⁰
11 x 10¹²

⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron

⇒ A voltage v = 5 + 50 sin ωt/ + 5 sin 5 &omegat is applied to a pure capacitor of capacitance 1 ωF. If f/= 314 rad/sec, current is
1 + 0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 cos 314 t + 0.00785 cos 1570 t
0.0157 sin 314 t + 0.00785 sin 1570 t
0.0157 sin (314 t / + 45°) + 0.00785 sin (1570 t + 45°)

⇒ The emitter follower is widely used in electronic instrument because
its voltage gain is less than unity
its voltage gain is very high
its O/P Impedance is low and input impedance is high
its O/P Impedance is high and I/P impedance is low