Question is ⇒ Measurement of radiation resistance by reflection method is suitable for, Options are ⇒ (A) parasitic element antennas, (B) low frequency vertical conductor antenna, (C) all type of antennas, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Measurement of radiation resistance by reflection method is suitable for, Options are ⇒ (A) parasitic element antennas, (B) low frequency vertical conductor antenna, (C) all type of antennas, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Measurement of radiation resistance by reflection method is suitable for
A.	parasitic element antennas [Correct Answer]
B.	low frequency vertical conductor antenna [Wrong Answer]
C.	all type of antennas [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ The dc output voltage of the circui
4.3 V
1.369 V
3.87 V
1.94 V

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒ The phase margin and damping ratio have no relation.
TRUE
FALSE

⇒ Colour code of carbon resistors has only two bands.
TRUE
FALSE

⇒ Inverse Fourier transform of '1' is
U(t)
δ(t)
0'
infinite

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒

Assertion (A): A graph can have many trees.

Reason (R): The number of tree branches is equal to number of nodes.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 3 bit synchronous counter uses FF with propagation delay time of 20 ns each. The maximum possible time required for change of state will be.
60 ns
40 ns
20 ns
None

⇒ Companding is used in PCM to
reduce bandwidth
increasing S/N ratio
get almost uniform S/N ratio
increase bandwidth

⇒ Which of the following is used in automatic control of street lights?
Thermistor
Photoconductor
Transistor
Varistor

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the velocity propagation will be
15.8303 km/s
15.830 km/s
1.583 km/s
0.1583 km/s

⇒ In classical analogue, torque is analogous to
current
voltage
charge
voltage gradient

⇒ A TR (transmitter receiver) tube has
low loss for low power signals and high
high loss for low power signals and low loss for high level signal
low loss for both low level and high level signals
high loss for both low level and high level signals

⇒ A minimum function has
poles and zeros on imaginary axis of s plane
no poles or zeros on imaginary axis of s plane
only poles but no zeros on imaginary axis of s plane
only zeros but no poles on imaginary axis of s plane

⇒ The most widely used diode rectifier circuit is
half wave
full wave with centre tapped transformer
bridge
either (a) or (b)

⇒ Antenna beamwidth is
measure of directivity
measure of angle
measure of radiation pattern
measure of power pattern

⇒ An op-amp uses
RC coupling
direct coupling
transformer coupling
either (b) or (c)

⇒ Consider the following statements about mutual inductances:

The value should remain constant under all conditions.
The mutual inductance should not vary with temperature.
The inductance should be independent of excitation.
They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are
2, 3, 4
1, 2, 3
1, 3, 4
1, 2, 4

⇒ A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
1 mV
2 mV
1.414 mV
4 mV

⇒

Hall coefficient R_H is directly proportional to the charge density
R_H depends upon type of the semiconductor material (n - type or p - type)
Hall co-efficient R_H is directly proportional to hall voltage V_H

From the above statements which are the false statements?
I only
II only
III only
all of the above

⇒ Each frequency in the modulating wave gives rise to four side bands.
TRUE
FALSE

⇒ A semiconverter feeding an RLE load operates in
first quadrant only
first and second quadrants
first and fourth quadrants
first and third quadrants

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ A pre-emphasis circuit
boosts base frequencies
pre amplifies the complete audio band
amplifies higher audio frequencies
converts FM into phase modulation

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ Wave A = 100 sin ωt and wave B = 100 cos ωt. Then
rms values of the two waves are equal
rms values of A is more than that of B
rms values of A is less than that of B
rms values of the two waves may or may not be equal

⇒ Dynamic range of hi-fi system is at least
150 dB
120 dB
80 dB
40 dB

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data

⇒ Iron has a body centred cubic structure.
TRUE
FALSE