Question is ⇒ Maximum power from a source having internal resistance Ri is delivered to a resistive load RL, if, Options are ⇒ (A) Ri > RL, (B) Ri < RL, (C) Ri = RL2, (D) Ri = RL, (E) , Leave your comments or Download question paper.

Question is ⇒ Maximum power from a source having internal resistance Ri is delivered to a resistive load RL, if, Options are ⇒ (A) Ri > RL, (B) Ri < RL, (C) Ri = RL2, (D) Ri = RL, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Maximum power from a source having internal resistance R_i is delivered to a resistive load R_L, if
A.	R_i > R_L [Wrong Answer]
B.	R_i < R_L [Wrong Answer]
C.	R_i = R_L² [Wrong Answer]
D.	R_i = R_L [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The entries in the first column of Routh array of a fourth order are 5, 2, - 0.1, 2, 1. The number of poles in the right half plane are
1
2
3
4

⇒ A class C amplifier has input frequency of 200 kHz. If width of collector pulses is 0.1 μs, duty cycle is
0.01
0.02
0.1
0.2

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ Pagemaker is an application software for DTP.
TRUE
FALSE

⇒ The Boolean expression for the circuit of the given fi
A {F + (B + C) (D + E)}
A [F + (B + C) (DE)]
A + F + (B + C) (D + E)]
A [F + (BC) (DE)]

⇒ Two D flip-flop as shown below are to be connected as a synchronous counter that goes through the following Q₁Q₀ sequ
Q₁ and Q₀
Q₀ and Q₁
Q₁ Q₀ and Q₁ Q₀
Q₁ Q₀ and Q₁ Q₀

⇒ Transistor are free from which type of noise?
Resistance noise
Partition noise
Flicker noise
Shot noise

⇒ Radiation pyrometer is used to measure temperature in the range of
-200 to 500° C
0 to 500° C
500 to 1200° C
1200 to 2500° C

⇒

Assertion (A): Positive feedback is not used in any circuit.

Reason (R): Positive feedback leads to instability.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ The distance between target and radar is reduced to half. Power received increases by
42751
42739
4 times
16 times

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18

⇒ The concentration of minority carriers in an extrinsic semiconductor under equilibrium is
directly proportional to the doping concentration
inversely proportional to doping concentration
directly proportional to intrinsic concentration
inversely proportional to the intrinsic concentration

⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C

⇒ Electric dipole moment is usually expressed in debye units. Here, 1 debye unit equals
3.33 x 10^-30 C-m
3.33 x 10^-30 C-m²
3.30 x 10^-10 C-m
3.33 x 10^-10 C-m²

⇒ In 8085 microprocessor, what is the memory address stored on the stack, when the program is interrup
0210 H
0.211 H
0118 H
020 FH

⇒ The signal in 8086 are in minimum mode when
MN / Mx pin is tied to V_cc
MN / Mx pin is grounded
MN / MX pin is left open
none of the above

⇒ Bode magnitude plot is drawn between
magnitude of network function and ω
dB magnitude and log ω
dB magnitude and ω
log_e (magnitude) and log ω

⇒ A microprocessor is generally
single chip SSI
single chip MSI
single chip LSI
any of the above

⇒ In figure, i(t) is a unit step current. The steady state value of v(t
2 V
3 V
6 V
9 V

⇒ If R(t) is autocorrelation of a waveform v(t) and R(0) is autocorrelation for t = 0, then
R(0) > R(t)
R(0) ≥ R(t)
R(0) < R(t)
R(0) ≤ R(t)

⇒ High intermediate frequency in a superheterodyne receiver
higher than
lower than
equal to
not comparable to

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
0.375 V
15 V
4.5 V
10 V

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ In a Vidicon camera tube
grid G₁ accelerates electrons
grid G₂ accelerates electrons and grid G₃, slows down electrons
grid G₃ accelerates electrons and grid G₂ slows down electrons
both grids G₂ and G₃ accelerate electrons

⇒ A hexadecimal odometer displays F52F. The next reading will be
E 52 F
E 52 E
E 53 F
F 53 O

⇒

Assertion (A): A video monitor does not need RF tuner and IF amplifier

Reason (R): The picture tube in TV is basically a CRT.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): When excited by a unit step voltage, an inductor behaves as open circuit at t = 0.

Reason (R): Inductance has the property of inertia.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true