Question is ⇒ Mark out the WRONG statem, Options are ⇒ (A) Needs very high-speed burst modems, (B) Faces no problems caused by intermodulation of carriers so that transponder can be used at its full power, (C) Needs high-speed manipulation of bit streams, (D) Is less flexible so that channels of widely different capacities cannot used and intermixed, (E) , Leave your comments or Download question paper.

Question is ⇒ Mark out the WRONG statem, Options are ⇒ (A) Needs very high-speed burst modems, (B) Faces no problems caused by intermodulation of carriers so that transponder can be used at its full power, (C) Needs high-speed manipulation of bit streams, (D) Is less flexible so that channels of widely different capacities cannot used and intermixed, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Mark out the WRONG statem
A.	Needs very high-speed burst modems [Wrong Answer]
B.	Faces no problems caused by intermodulation of carriers so that transponder can be used at its full power [Wrong Answer]
C.	Needs high-speed manipulation of bit streams [Wrong Answer]
D.	Is less flexible so that channels of widely different capacities cannot used and intermixed [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 256 x 4 EPROM has
8 address pins and 4 data pins
8 address pins and 8 data pins
4 address pins and 8 data pins
4 address pins and 4 data pins

⇒ Which of the following devices is a 'hot-electron' diode?
Thermionic tube diode
Schottky-Barrier diode
Thomson-Deletion diode
Thermal electron diode

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ As temperature increases the forbidden gap in silicon increases.
TRUE
FALSE

⇒ Consider an angle modulated si
10W
18W
20W
28W

⇒ When a p-n junction is forward biased, the current remains zero till the applied voltage overcomes the barrier potential.
TRUE
FALSE

⇒ In 8085 microprocessor, what is the length of status Word?
6 bits
8 bits
12 bits
16 bits

⇒ Household tape recorders use
separate motor for each operation
only one motor for all operations
one motor for capstan and another for take up reel
a total of 3 motors

⇒ A buffer amplifier is
a double-tuned amplifier
a high gain D.C. amplifier
a cathode follower stage
none of the above

⇒ The ratio of active power to apparent power is known as __________ factor.
power
load
form
demand

⇒ The current wave of figure, is passed through a 3 H inductor during the period 0 to 2 sec
is 3 V
is 6 V
increases from 0 at t = 0 to 6 V at t = 2 seconds
increases from 0 at t = 0 to 6 V at t = 2 seconds and then decreases

⇒ Computer virus can hide itself in a diskette but not in a hard disk.
TRUE
FALSE

⇒ In a series inverter
the commutating elements L and C are in parallel
the commutating elements L and C are in series with load
the commutating L and C may be in series or parallel with the load
none of the above

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ A microprocessor with a 16-bit address bus is used in a linear memory selection configuration (i.e., Address bus lines are directly used as chip selects of memory chips) with 4 memory chips. The maximum addressable memory space is
64 K
16 K
8 K
4 K

⇒

Assertion (A): Power drain of CMOS increases with operating frequency

Reason (R): All unused CMOS inputs should be tied either to a fixed voltage level (0 or V_DD) or to another input.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ Choose the correct option, if b (branch), n (nodes), l (links)
b = n + l - 1
no. of twig = n - 1
b = n - l + 1
b, a

⇒ A 14 pin AND gate IC has __________ AND gates.
8
6
4
2

⇒ The gate lead, in a thyristor is welded to :
p layer to which anode is connected
n layer nearest to the anode terminal
p layer nearest to the cathode terminal
outside n layer

⇒ If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if f_m = 500 Hz, Δf = 2.25
6 kHz
12 kHz
27 kHz
54 kHz

⇒ A typical value of insertion loss of SAW filter is
15 dB
2 dB
40 dB
60 dB

⇒ The number of select lines in ALU 1C 74181 is
2
4
8
16

⇒ The number of noise sources in a BJT are
3
2
1
4

⇒ Which binary addition is incorrect?
1101.1 + 1011.1 = 11001.0
101101 + 1101101 + 1100011
0.0011 + 0.1110 + 1.0001
1100.001 + 1011.011 = 10111.100

⇒ 11101₂ x 10001₂ =
111101101
111101100
11110
1100110

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ The number of valence electrons in trivalent impurity is
5
4
3
1

⇒ The baud rate is
not equal to signalling rate
always equal to bit transfer rate
equal to twice the bandwidth of an ideal channel
equal to half the bandwidth of ideal channel