Question is ⇒ Magnetic flux density has the dimensions, Options are ⇒ (A) MI-1T-2, (B) M-1I-2T-2, (C) ML-3T-2, (D) MI-1T-3, (E) , Leave your comments or Download question paper.

Question is ⇒ Magnetic flux density has the dimensions, Options are ⇒ (A) MI-1T-2, (B) M-1I-2T-2, (C) ML-3T-2, (D) MI-1T-3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Magnetic flux density has the dimensions
A.	MI^-1T^-2 [Correct Answer]
B.	M^-1I^-2T^-2 [Wrong Answer]
C.	ML^-3T^-2 [Wrong Answer]
D.	MI^-1T^-3 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a semi-conductor diode, the barrier offers opposition to
holes in P-region only
free electrons in N-region only
majority carriers in both regions
majority as well as minority carriers in both regions

⇒ An I/O processor controls the flow of information between
cache memory and I/O devices
main memory and I/O devices
two I/O devices
cache and main memory

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be
26 kHz
260 kHz
26 MHz
260 MHz

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Distances near the skip distance should be used for sky-wave propagation
to avoid the Faraday effect
to avoid tilting
to prevent sky-wave and upper ray interference
so as to exceed the critical frequency

⇒ Which of the following expressions is true for apparent power in an A.C. circuit?
VI cos Φ
V_av x I_av
V_r.m.s x I_r.m.s
V_peak x I_peak

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ Consider the cascade structure of two filte
1 and 3
only 2
2 and 3
only 3

⇒ Virus is a
computer hardware problem
an operating system
a computer program
a computer language

⇒ In which condition does BJT behave like a closed switch?
Cut off
Saturation
Forward active
Reverse active

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct

⇒ The 8085 instruction 'PUSH PSW' belongs to the group
data transfer
arithmetic
logic
none of the above

⇒ In a coaxial cable, braided copper is used for
conductor
shield
dielectric
jacket

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ Which of the following op-amp circuits has zero resistance in the feedback path?
Inverting amplifier
Summing amplifier
Source follower
Integrating amplifier

⇒ The current gain of a transistor is the ratio of
emitter current to base current
emitter current to collector current
collector current to base current
collector current to emitter current

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ A 200 turn coil has a self inductance of 10 mH. If the number of turns is doubled, all other quantities remaining the same, the self inductance will be
2.5 mH
5 mH
20 mH
40 mH

⇒ For the transport lag G(jω) = e^-jωT, the phase angle
is constant
varies linearly with frequency
varies linearly with low frequencies only
values as per square law

⇒ In the circuit of figure, the value of r_e is (neglecting v_{be100 Ω
75 Ω
50 Ω
25 Ω}

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ Which one of the following statements regarding compandor is FALSE?
It compresses the higher-amplitude parts of a signal before modulation and expands them back to normal again after demodulation.
It gives preferential treatment to the weaker parts of the signal
For weaker signals it gives a poor ratio of signal strength to quantizing error
Weaker signals, traverse more quantum steps than they would do otherwise and so quantizing error is reduced.

⇒ In which of the following 8085 instructions is the CY flag complemented?
CMA
CMC
STC
RRC

⇒ A cordless telephone using separate frequencies for transmission in base and portable units is known as
duplex arrangement
half duplex arrangement
either (a) or (b)
neither (a) nor (b)

⇒ Which of the following will increase the antenna radiation efficiency?
Use of larger section of conductor
Providing insulation on conductor
Top loading of antenna
Any of the above

⇒ In pulse transmitter the ratio of time on to time off is called
efficiency
duty cycle
base
bandwidth

⇒ A material has conductivity of 10^-2 mho/m and a relative permittivity of 4. The frequency at which conduction current in the medium is equal to displacement current is
45 MHz
90 MHz
450 MHz
900 MHz