Question is ⇒ Magnetic deflection is inversely proportional to, Options are ⇒ (A) voltage, (B) (voltage)0.5, (C) (voltage)1.5, (D) (voltage)2, (E) , Leave your comments or Download question paper.

Question is ⇒ Magnetic deflection is inversely proportional to, Options are ⇒ (A) voltage, (B) (voltage)0.5, (C) (voltage)1.5, (D) (voltage)2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Magnetic deflection is inversely proportional to
A.	voltage [Wrong Answer]
B.	(voltage)^0.5 [Correct Answer]
C.	(voltage)^1.5 [Wrong Answer]
D.	(voltage)² [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is not a non-linear element?
Transistor
Heater coil
Diode
Electric arc with unlike electrodes

⇒ The energy of highest value of Autocorrelation of a function 100 cos 50 pt is
50
10
200
zero

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ The output, V-I characteristics of an Enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value followed by a saturation region at higher voltages
an ohmic region at large voltage values preceded by a saturation region at lower voltages

⇒ A pulse transformer uses
ferrite core
air core
iron core
copper core

⇒ In a colour TV receiver, PAL Dematrix consists of
chroma detector to separate the three primary colours
delay line and PAL matrix to give U and V signals
delay line and PAL matrix to give RGB colours
none of the above

⇒ If k denotes Boltzmann's constant, the rms value of thermal noise voltage is proportional to
k²
k
k
(k)^1/3

⇒ The values of 2⁵ in octal system is
40
20
400
200

⇒ The minimum number of 2 input NAND gates required to implement Boolean function A B C is A, B, C are available is
2
3
5
6

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒ Laplacian of a scalar function V is
gradient of V
gradient of the gradient of V
divergence of V
divergence of the gradient of V

⇒ In auxiliary commutated chopper, the charging and discharging time of capacitor
are constant
depend on load current
may be constant or may depend on load current
none of the above

⇒ In a purely resistive circuit the instantaneous power varies from zero to maximum twice in each cycle.
TRUE
FALSE

⇒ The circuit of figure is ca
current mirror
voltage mirror
impedance inversion
phase splitting

⇒ Each kilometer of travel in electromagnetic radiation means a time delay of
330 μs
33 μs
3.3 μs
0.33 μs

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of
Only statement 1 is true
Only statement 2 is true
Both the statement are true
Both the statements are false

⇒ Which are the popular IF frequencies for microwave and radar receivers operating on frequencies in the range 1 to 10 GHz
30, 60 and 70 kHz
3, 6 and 7 kHz
30, 60 and 70 MHz
3, 6 and 7 GHz

⇒ When transistor is used as a switch __________ is defined as the interval which elapses between the transition of input waveform and the time when to transition to 90% of I_c(sat).
storage time
fall time
turn-on time
turn-off time

⇒ Z transform is a non-linear operation.
TRUE
FALSE

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ In the 8421 BCD code, the decimal number 125, is written as
1111101
0001 0010 0101
7 D
none of these

⇒

Assertion (A): For an underdamped system with damping ratio ξ, the maximum overshoot is e-ξp/(1-ξ²)^0.5

Reason (R): Peak time of a second order under damped system = p/ω_d where ω_d is frequency of damped oscillations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ In 8086 a word OA 50 FH is stored in 02 and 03 memory locations. Then
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 02
OFH is stored at location 03 and 0 A 5 at location 02 and address of word in 02
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 03
OFH is stored at location 03 and 0 A 5 at location 02 and address of word is 03

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2

⇒ In van der walls crystals, there exists a high degree of stability of the outer electron shell.
TRUE
FALSE

⇒ As regards ferromagnetic Curie temperature Q_f and paramagnetic curie temperature θ
Q_f > θ
θ > Q_f
θ equal to or less than Q_f
θ may be equal to less than or more Q_f

⇒ The initial contents of the 4 bit serial in parallel out right shift, shift register shown in figure is 0110. After three clock pulses are applied, the contents of the shift register wil
0
101
1010
1111

⇒ In load commutated chopper, the commutating element
is capacitor
is capacitor and inductor
is capacitor, inductor and auxiliary thyristor
any of the above depending on load