Q1. | M = (μ_{r} - 1)H. |

A. | TRUE [Correct Answer] |

B. | FALSE [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In single phase half wave regulator, the average current over one full cycle

is always positive

may be positive or negative

may be negative

is always negative

⇒ For Bode plot of (1 +

*j*ωT) has

slope of 20 dB/decade and phase angle + tan

^{-1}(ωT)

slope of - 20 dB/decade and phase angle + tan

^{-1}(ωT)

slope of 20 dB/decade and phase angle - tan

^{-1}(ωT)

slope of - 40 dB/decade and phase angle - tan

^{-1}(ωT)

⇒ The Boolean expression (A + B) (A + C) (B + C) simplifies to

(A + B) C

(A + B) C

(A + B) C

none of these

⇒ Antenna beamwidth is

measure of directivity

measure of angle

measure of radiation pattern

measure of power pattern

⇒ A chopper cannot be line commutated.

TRUE

FALSE

⇒

**Assertion (A):** As per Miller theorem a capacitance C from input to output appears as a much larger capacitance across input terminals

**Reason (R):** In a lag network the output voltage appears across capacitor

Both A and R are correct and R is correct explanation for A

Both A and R are correct but R is not correct explanation for A

A is correct R is wrong

A is wrong R is correct

⇒ A signal

*g*(

*t*) =

*A*then

*g*(

*t*) is a

energy signal

power signal

neither energy nor power signal

insufficient data

⇒

**Assertion (A):** The exponential form of Fourierserie

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is true, R is false

A is false, R is true

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.

TRUE

FALSE

⇒ The amplitude of a random signal uniformly distributed between - 5 V and 5 V. If the positive values of the signal are uniformly quantized with a step size of 0.05 V, and the negative values are uniformly quantized with a step size of 0.10 V, the resulting signal to quantization noise is approximately

46 dB

43.8 dB

42 dB

40 dB

⇒ In degenerate *p* type semiconductor material, the Fermi level,

is in the valence band

is in conduction band

is at the centre in between valence and conduction bands

is very near conduction band

⇒ The circuit show

voltage series feedback amplifier

transconductance amplifier

transresistance amplifier with open circuit mutual resistance R_{F}

transresistance amplifier with short circuit mutual resistance R_{F}

⇒ An energy signal has G(*f*) = 10. Its energy density spectrum is

10

100

50

20

⇒ Special circuits using neon tubes, contact relays and capacitors are used in many domestic appliances. The role of capacitor in figure i

reduce power loss

function as resistor when relay is on

delay the operation of the contact relay after switching on

open circuit the relay terminals

⇒ The given figure shows a pole zero diagram. The transfer function G(*j*1

0.5 ∠0

2.7 ∠- 31°

2 ∠45°

2 ∠- 67.4°

⇒

**Reason (R):** The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A

Both A and R are true and R is not the correct explanation of A

A is true but R is false

A is false but R is true

⇒ The primary function of lag compensator is to provide sufficient

gain margin

phase margin

both gain margin and phase margin

either (a) or (b)

⇒ If damping ratio is 0.5, the lines joining complex poles with origin are inclined to negative real axis at

± 90°

± 60°

± 45°

± 30°

⇒ A white noise

*X*(

*t*) with two-sided power spectral density 1 x 10

^{-10}W/Hz is input to a filter whose magnitude squared response is shown be

5 x 10

^{-7}W

1 x 10

^{-6}W

2 x 10

^{-6}W

5 x 10

^{-6}W

⇒ Consider the following

- Generation of SSB signals
- Design of minimum phase type filters
- Representation of band pass signals

1 only

1, 2 and 3

1, 2 only

1 and 3

⇒ Which of the following statement about JFET is true?

In a JFET, gate and source have opposite polarity with respect to drain irrespective of the type of FET

In its schematic symbol for JFET, the arrow always points to

*p*-type material

In an

*n*-channel JFET, the channel is the narrowest under zero gate bias condition

In JFET, gate source cut off voltage is numerically equal to the pinch off voltage

⇒ The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is

in phase component

quadrature component

zero

the envelope

⇒ The number of variables in a function is odd and the number of minterms with even number of 0's are same as the number of minterms with odd number at 1's, the expression formed can be represented in __________ as well as __________ form.

Ex - OR, NOR

Equivalence, Ex - OR

AND, Coincidence

OR, Ex - OR

⇒ For the system of the given figure |G(

*j*ω)| = 0 dB at &omeg

0

1 rad/sec.

∞

2.38 rad/sec.

⇒ In the case of the circuit shown in the figure V

_{io}= 10 mV dc maximum, the maximum possible output offset voltage V

_{oo}caused by the input offset voltage V

_{io}with respect to groun

60 mV dc

110 mV dc

130 mV dc

150 mV dc

⇒ In an

*n*-

*p*-

*n*transistor, the majority carriers in the base are

electrons

holes

both holes and electrons

either holes or electrons

⇒ Two wattmeter method is suitable only for balanced loads.

TRUE

FALSE

⇒ The total number of leads in reverse conducting thyristor is

2

3

1

4

⇒ Which of the following antennas is λ /4 length?

Dipole

Marconi

Monopole

Parabolic

⇒

Match the following:

List I (Bit Pattern) | List II (Register pairs) | ||
---|---|---|---|

A. | 00 | 1. | SP |

B. | 01 | 2. | B-C |

C. | 10 | 3. | D-E |

D. | 11 | 4. | H-L |

A-1, B-2, C-3, D-4

A-2, B-3, C-4, D-1

A-2, B-3, C-1, D-4

A-4, B-3, C-2, D-1