Question is ⇒ Lowest noise can be expected in case of, Options are ⇒ (A) carbon composition resistors, (B) carbon film resistors, (C) tin oxide resistors, (D) metal film resistors, (E) , Leave your comments or Download question paper.

Question is ⇒ Lowest noise can be expected in case of, Options are ⇒ (A) carbon composition resistors, (B) carbon film resistors, (C) tin oxide resistors, (D) metal film resistors, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Lowest noise can be expected in case of
A.	carbon composition resistors [Wrong Answer]
B.	carbon film resistors [Wrong Answer]
C.	tin oxide resistors [Wrong Answer]
D.	metal film resistors [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than
500 V
400 V
375 V
250 V

⇒ The output v-i characteristics of enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value and a saturation region at high voltage
a saturation region at low voltage value and an ohmic region at high voltage

⇒ From an n channel JFET for V_DS constant and if V_GS is made more negative, pinch off would occur at
higher value of drain current
saturation value of drain current
zero drain current
gate current equal to drain current

⇒ The circuit below represents function X(A, B, C, D)
Σ(5, 8, 13, 14)
∏(0, 1, 2, 3, 4, 6, 7, 8, 10, 11, 12)
Σ(5, 9, 13, 14)
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 10, 11, 12, 15)

⇒ Program counter in a digital computer
counts the number of program run in the machine
counts the number of times a subroutine is called
counts the number of times the loops are executed
points the memory address of the current or the next instruction to be executed

⇒ Two coupled coils with self inductances of 4 mH and 16 mH are connected in series. The maximum possible value of inductance can be
36 mH
20 mH
28 mH
64 mH

⇒ An open wire transmission line having a characteristic impedance of 600 ohms is terminated by a resistive load of 900 Ω. The standing wave ratio will be
1.5
2.5
3.5
4.5

⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then array length will be
10 λ
100 λ
20 λ
5 λ

⇒ In figure, the switch is closed at t = 0 when current through inductor is 6 A, the rate of change of current through resistor is 6 A/s. The value of
1 H
2 H
3 H
4 H

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒ Some possible functions of AGC in a TV receiver are

To increase gain for weak signals
To decrease gain for strong signals
To change the contrast when we switch from one channel to other
To reduce flutter

Which of the above are correct?
1, 2, 3, 4
1, 2, 4
1, 2, 3
2, 3, 4

⇒ Voice signal band limited to 3.4 KHz is sampled and pulse code modulated using 64 quantization levels. Ten such signals are time division multiplexed using one 5-bit synchronizing word every alternate frame. The minimum channel bandwidth required for transmission of the TDM signal is
100 KHz
200 KHz
50 KHz
150 KHz

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒ In case of photo conductor for germanium when forbidden energy gap is 0.72 eV, the critical wavelength for intrinsic excitation will be
1.43 m
1.43 mm
1.73 mm
1.73 x 10¹² m

⇒ Consider a baseband binary PAM receiver shown below. The additive channel noise n(t) is whit with power spectral density S_N(f) = N₀/2 = 10^-20 W/Hz. The low-pass filter is ideal with unity gain and cutoff frequency 1 MHz. Let Y_k represent the random variable y(t_k0.5 x e^-3.5
0.5 x e^-5
0.5 x e^-7
0.5 x e^-10

⇒ If R, L, C are in parallel, the currents through L and C are equal in magnitude at resonance.
TRUE
FALSE

⇒ Whereas resonant antenna is bidirectional, non-resonant antenna is unidirectional.
TRUE
FALSE

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ Which of the following is used for generating time varying wave forms?
MOSFET
PIN diode
Tunnel diode
UJT

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ The direction in a Yagi Uda antenna
is longer than the radiating element
is shorter than the radiating element
can be longer or shorter than the radiating element
does not exist

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than
1 μF
1 nF
1 pF
0.1 pF

⇒ In deriving ac equivalent circuit for an amplifier circuit we short circuit
all resistors
all transistors
all inductors
all capacitors

⇒
Assertion (A): A slight change in pole-zero configuration can cause only minor changes in root locus configuration.
Reason (R): Asymptotes show the behaviour of root loci for |s| >> 1

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ When a high voltage reference is required it is advantageous to use two or more zener diodes in series to allow
higher voltage
higher dissipation
lower temperature coefficient
all of the above

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ The maximum number of characters for variable names in C is
4
8
12
16

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math