Question is ⇒ Lower chip area requirements of MOS is advantage in, Options are ⇒ (A) low power circuits, (B) high power circuits, (C) repetitive operation circuits, (D) large scale integration, (E) , Leave your comments or Download question paper.

Question is ⇒ Lower chip area requirements of MOS is advantage in, Options are ⇒ (A) low power circuits, (B) high power circuits, (C) repetitive operation circuits, (D) large scale integration, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Lower chip area requirements of MOS is advantage in
A.	low power circuits [Wrong Answer]
B.	high power circuits [Wrong Answer]
C.	repetitive operation circuits [Wrong Answer]
D.	large scale integration [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
10 mm
20 mm
30 mm
40 mm

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct

⇒ The function shown in the given Figure can be writte
sum of two sinusoidal functions
sum of two sinusoidal functions one originating at t = 0 and the other at t = 1
difference of two sinusoidal functions one originating at t = 0 and the other at t = 1
none of the above

⇒ A disadvantage of microstrip line as the connections of compared to strip line is that former
do not lend themselves to printed circuit
are more likely to radiate
are bulky
are more expensive and complex

⇒ A capacitor can be represented by a capacitance and resistance in parallel. For a good capacitor, this parallel resistance should be
negligible
low
high
very high

⇒ A circular sphere mile is the area of cross-section of a wire
having a diameter equal to 1 miles
having a radius equal to 1 miles
having a circumference equal to 1 miles
none of the above

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Slotted line can be used for measurement of high frequencies
TRUE
FALSE

⇒ A dc series motor is coupled to a load whose torque is proportional to speed. It is fed by a single phase ac supply through a full converter. When speed is 500 rpm, firing angle is 45°. It is desired to raise the speed. It will be necessary to
decrease the firing angle
increase the firing angle
either decrease or increase the firing angle depending on the required speed
decrease the load torque

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒

Assertion (A): A fixed bias BJT circuit exhibits better performance as compared to a self bias BJT circuit.

Reason (R): A fixed bias BJT circuit used less components as compared to a self bias BJT circuit.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
100 V
88 V
50 V
25 V

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ An atom of a rare gas is placed is an electric field E. Then
the nucleus will be shifted in the direction of E by an amount which is proportional to E.
the nucleus will not be shifted.
the nucleus will be shifted in the direction of E by an amount which is independent of E.
the nucleus will be shifted in a direction opposite to that of E.

⇒ In a good voltage amplifier, its input impedance
must be high compared to the resistance of the source
must be low compared to the resistance of the source
must be equal to the resistance of the source
must be half the resistance of the source

⇒ Which of the following can provide a digital signal?
Slow change in the value of a resister
Sine wave
Square wave
Gradual turning of a potentiometer

⇒ Consider z transform of a signal as given b
IIR
FIR
Depends on value of n
Cannot determined

⇒ In a circuit containing a complex impedance, maximum power transfer takes place when load is
pure resistance
equal to the complex impedance
conjugate complex of the circuit impedance
none of the above

⇒ A rectangular waveguide is a
rectangular conducting wire to propagate electromagnetic waves
hollow rectangular walled room carrying electromagnetic wave
hollow rectangular conducting tube through which electromagnetic waves can be propagated
tube antenna to transmit and receive electromagnetic waves

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ Integral control action
removes offset
may lead to oscillatory response
both (a) and (b)
neither (a) nor (b)

⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is
[0, - 2 + 2j, 2, - 2 - 2j]
[2, 2 + 2j, 6, 2 - 2j]
[6, 1 - 3j, 2, 1 + 3]
[6, - 1 + 3j, 0, - 1 - 3j]

⇒ Consider the following BJT circ
2.46 kΩ
2.88 kΩ
200 Ω
18.48 Ω

⇒ In binary data transmission DPSK is preferred to PSK because
a coherent carrier is not required to the generated at the receiver
for a given energy per bit, the probability for zero is less
the 180° phase shifts of the carrier
more protection is provided against impulse noise

⇒ In a 3 phase full converter the average load current is 150 A. The average thyristor current is
150 A
75A
50 A
25 A

⇒ For an P-N-P transistor in normal operation its junction are biased as
emitter base : reverse, collector base : forward
emitter base : forward, collector base : reverse
emitter base : forward, collector base : forward
emitter base : reverse, collector base : reverse

⇒ In the circuit shown in the figure, the current supplied by the sinusoidal current source
28 A
0.166666666666667
20 A
not determinable from the data given

⇒ When microwave signals follow the curvature of the earth, this is known as
the Faraday effect
ducting
tropospheric scatter
ionospheric reflection

⇒ In a decimal digital computer, the number 127 is stored
1111111
0001 00100111
10001
11000111