Question is ⇒ Loudness control gives, Options are ⇒ (A) high boost to bass and little boost to treble, (B) equal boost to bass and treble, (C) less boost to bass and more boost to treble, (D) less boost to both bass and treble, (E) , Leave your comments or Download question paper.

Question is ⇒ Loudness control gives, Options are ⇒ (A) high boost to bass and little boost to treble, (B) equal boost to bass and treble, (C) less boost to bass and more boost to treble, (D) less boost to both bass and treble, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Loudness control gives
A.	high boost to bass and little boost to treble [Correct Answer]
B.	equal boost to bass and treble [Wrong Answer]
C.	less boost to bass and more boost to treble [Wrong Answer]
D.	less boost to both bass and treble [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When the phase velocity of an EM wave depends on frequency in any medium, the phenomenon is called
scattering
polarization
absorption
dispersion

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ A sinusoidal voltage has peak to peak value of 100 V. The rms value is
50 V
70.7 V
35.35 V
141.41 V

⇒ In a cascade amplifier, the intermediate stages are always in
CC configuration
CB configuration
CE configuration
any of the above

⇒ A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
TRUE
FALSE

⇒ The circuit of figur
positive clipper
negative clipper
combination clipper
either (a) or (b)

⇒ The skin depth of copper is found to be 66 mm at 1 MHz at a certain temperature. At the same temperature and at 2 MHz, the skin depth would be approximately
47 μm
33 μm
92 μm
1.22 μm

⇒ For an unstable system the gain margin is indicative of how much the gain should be decreased to make the system stable.
TRUE
FALSE

⇒ Two 2 port circuits are connected cascaded. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ 5 skilled workers can build a wall in 20 days; 8 semi-skilled worker can build a wall in 25days; 10 unskilled workers can build a wall in 30 days, If a team has 2 killed, 6 semi-skilled and 5 unskilled workers, how long will it take to build the wall?
20 days
18 days
16 days
15 days

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ In given figure the switch was closed for a long time before opening at t = 0. The voltage V_x at t = 0^{+25 V
50 V
-50 V
0 V}

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ It is required to measure angular position. Out of the transducers

Circular potentiometer
LVDT
E pick up
Synchro

The proper devices are
1, 2, 3, 4
2 and 3
1, 2, 4
1 and 4

⇒ If x^k = a^k and k &g
TRUE
FALSE

⇒ Magnetisation of a material is the magnetic dipole moment per m³.
TRUE
FALSE

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒ In a CD, the depth and width of each pit is
0.5 μm each
0.5 μm and 1 mm respectively
1 μm and 0.5 mm respectively
1 μm each

⇒ A low noise device is most important
at front end of equipment
in the last stage of equipment
in the middle stages of equipment
both (b) and (c)

⇒ A computer program is used to read N and print the sum 1² + 2² + 3² +.....+ N². If N = 10, the print out will show the number
100
10
385
285

⇒ Pulse modulation is used in
radio navigation
automatic landing equipment
data communications
all of the above

⇒ It is desired to couple a coaxial line to a two parallel wire line. It is best to use
quarter wave transformer
balun
slotted line
directional coupler

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ In which amplifier circuit is gate conductance negligible?
JFET amplifier
MOSFET amplifier
Both JFET and MOSFET amplifier
None of the above

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ Inverters find applications in
HVDC transmission
UPS
variable speed ac drives
all of the above