Question is ⇒ Loop antennas are mostly employed for direction finding (DF) purposes because they are small and hence portable., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Loop antennas are mostly employed for direction finding (DF) purposes because they are small and hence portable., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Loop antennas are mostly employed for direction finding (DF) purposes because they are small and hence portable.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): An ac amplifier uses coupling capacitors at input and output

Reason (R): The capacitive reactance varies inversely with frequency. It is infinite for dc

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Microprocessors were introduced in the year
1951
1961
1971
1981

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency

⇒ If a line is open circuited Z_in = Z₀ tanh (gl).
TRUE
FALSE

⇒ - 56 is not a valid real constant in Fortran.
TRUE
FALSE

⇒ When measuring phase angle between two waves using a CRO, the time base generator is connected to
X plate
Y plate
both X and Y plate
neither X nor Y plates

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒ In a communication receiver, a squelch circuit is normally inserted
before detector
after detector
before mixer
after power amplifier

⇒ In a P-N-P transistor, electrons flow
into the transistor at the collector only
into the transistor at the base and the collector leads
out of the transistor at base and collector leads
out of the transistor at base, collector as well as emitter leads

⇒ Figure shows a parallel resonant circuit having resonance frequency of 15 MHZ. At this frequ
its impedance is minimum
its impedance is maximum
its impedance is infinite
its impedance is zero

⇒ In SSB generation, the most commonly used filter is
low pass
RC
LC
mechanical

⇒ The V_s is give
8 V
13 V
1 V
4 V

⇒ As temperature increases, the temperature coefficient of metals increases.
TRUE
FALSE

⇒ In a series regulated power supply circuit, the voltage gain A_v, of the 'pass' transistor satisfies the condition
A_v → ∞
1 << A_v < ∞
A_v ≈ 1
A_v << 1

⇒ To increase Q factor of a coil, the wire should be
long
thin
thick
long and thin

⇒ In the following astable multivibrator circuit, which properties of v₀(t) depends on R_{2Only the frequency
Only the amplitude
Both the amplitude
Neither the amplitude nor the frequency}

⇒ The stack pointer holds the address of the desired memory location.
TRUE
FALSE

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ The main drawback in the performance of shunt peaked wide band amplifier is
two low gain at low frequency
poor phase response
reduce frequency at middle frequency
that the maximum gain of the stage is small

⇒ Class A amplifiers are preferred when
minimum distortion is required
maximum voltage gain is required
output signal is desired in phase with input signal
signal having A.C. superimposed on D.C. are to be amplified

⇒ In a JFET
gate source cut off voltage is equal to V_DS
gate source cut off voltage is equal to pinch off voltage
gate source cut off voltage is twice the pinch off voltage
gate source cut off voltage is equal to negative pinch off voltage

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ A system with transfer function H(z) has impulse response h(.) defined as h(2) = 1, h(3) = -1 and h(k) = 0 otherwise. Consider the following statem
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, and S2 is a reason for S1
Both S1 and S2 are true, but S2 is not a reason for S1

⇒ In 8085 microprocessor, in order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instruction are needed?
EI only
SIM only
EI and SIM both
None

⇒ Consider the following stateme
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ Which of the following subtraction operations do not result in F₁₆?

(BA)₁₆ - (AB)_{161 and 2
1 and 3
2 and 3
1, 2 and 3}

⇒ In figure, the capacitor is charged to 1 V. At t = 0 the switch is closed so that i = e^-t. When i = 0.37 A, the voltage across capacito
1 V
0.63 V
0.37 V
0.185 V

⇒ For a type 1 system and unit parabolic input, the steady state error is
0
∞
1
1/K_v

⇒ The carrier frequency will be if L = 50 µH and C = 1 nF.
512
612 kHz
712 kHz
812 kHz

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R