Question is ⇒ Logic analyser is, Options are ⇒ (A) a multichannel oscilloscope, (B) similar to logic pulser, (C) similar to current tracer, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Logic analyser is, Options are ⇒ (A) a multichannel oscilloscope, (B) similar to logic pulser, (C) similar to current tracer, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Logic analyser is
A.	a multichannel oscilloscope [Correct Answer]
B.	similar to logic pulser [Wrong Answer]
C.	similar to current tracer [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an oscillator the total phase shift around the loop must be
180°
90°
270°
0°

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ A P-N junction diode dynamic conductance is directly proportional to
the applied voltage
the temperature
its current
thermal voltage

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ For a rectangular waveguide (a x b, a > b) to support only the TE₁₀ mode at wavelength which one of the following pairs of in equalities is to be satisfied?
b < λ < 2b; λ > 2a
b < λ < 2b; λ < 2a
a < λ < 2b; λ < 2a
a < λ < 2b; λ > 2a

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ The correct sequence of subsystems in an FM receiver is
Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier
RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier
RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier
Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator

⇒ When a lead acid cell discharges, the specific gravity of electrolyte increases.
TRUE
FALSE

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ In the absence of noise, if C is channel capacity in bits/s, δf is channel bandwidth in Hz and N is number of coding levels. Then
C = log₂ N
C = (δf) log₂ N
C = 2 (δf) log₂ N
C = 0.5 (δf) log₂ N

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ The advantage of pulse modulation is
the transmitted power can be concentrated into short bursts
the time intervals between pulses can be filled with sample values from other message
pulse wave may obtain appreciable D.C. and low frequency content
all of the above

⇒ PID controlled system has
P and I actions in forward path and D action in feedback path
P and I actions in feedback path and actions in forward path
All the three (i.e., P, I and D) actions in forward path
All the three (i.e., P, I and D) actions in feedback path

⇒ Consider a 565 PLL with R_T = 10 kΩ and C_T = 0.01 μF. What is the output frequency of the VCO?
10 kHz
5 kHz
2.5 kHz
1.25 kHz

⇒ In figure what is the base current if V_BE = 0
10 mA
9.3 mA
10 μA
9.3 μA

⇒ Lower chip area requirements of MOS is advantage in
low power circuits
high power circuits
repetitive operation circuits
large scale integration

⇒ A band limited signal is sampled at the Nyquist rate. The signal can be recovered by passing the samples through
an RC filter
an envelope detector
a PPL
an ideal low pass filter with the appropriate bandwidth

⇒ In using KCL it is necessary that current leaving a node is written as negative.
TRUE
FALSE

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)

⇒

Assertion (A): Two equal and opposite travelling waves result in a standing wave.

Reason (R): The ratio of maximum to minimum value of a standing wave is called SWR.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ Frequency shift keying is used mostly in
telegraphy
telephony
satellite communication
radio transmission

⇒ In Weston synchronoscope the fixed coils are connected across
bus bars
incoming alternator
lamp
either (a) or (b)

⇒ Which of the following statements is correct?
Convex lens has positive focal power and concave lens have negative focal power
Convex lens has negative focal power and concave lens have positive focal power
All lens have positive focal power
All lens have negative focal power

⇒ Which of the following statements is not correct for thermistors?
They have negative temperature coefficient of resistance
The sensing element is made of sintered ceramics, which are oxides of metals in the form of beads
The variation of resistance with temperature is linear
The resistance value at ambient temperature may range from 100 Ω to 100 kΩ

⇒ For a permanent magnetic material
the residual induction and coercive field should be large
the residual induction and coercive field should be small
area of hysteresis loop should be small
initial relative permeability should be high

⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic

⇒ The service area of a TV transmitter is a little beyond radio horizon.
TRUE
FALSE

⇒ The energy to cause thermionic emission is supplied by heating the cathode.
TRUE
FALSE

⇒ Consider the following advantages of phase array radar

simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning

Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only