Question is ⇒ Load ZL for maximum power transfe, Options are ⇒ (A) R, (B) R + jωL, (C) R - jωL, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ Load ZL for maximum power transfe, Options are ⇒ (A) R, (B) R + jωL, (C) R - jωL, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Load Z_L for maximum power transfe
A.	R [Wrong Answer]
B.	R + jωL [Wrong Answer]
C.	R - jωL [Correct Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A fully charged mobile phone with a 12 V battery is good for a 20 minute talktime. Assume that, during the talk time, the battery delivers a constant current of 2 A and its voltage drops linearly from 12 V to 10 V as shown in the figure. How much energy does the battery deliver during this talk t
220 J
12 kJ
13.2 kJ
14.4 kJ

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ The normal operation of JFET is
constant voltage region
constant current region
both constant voltage and constant current regions
either constant voltage or constant current region

⇒ Maximum rectification efficiency for a half wave rectifier is
1
0.88
0.5
0.406

⇒
Match the following:
List I List II
A. Flash converter ADC 1. requires conversion time of a few μs
B. Dual slope ADC 2. requires DAC
C. Successive approximation ADC 3. minimizes the effect of power supply interference
4. requires complex hardware
5. is a tracking ADC

A-2, B-3, C-4
A-4, B-3, C-2
A-5, B-4, C-3
A-1, B-2, C-5

⇒ What is the characteristic impedance at 10 MHz?
547.7 Ω
54.7 Ω
5.47 Ω
.547 Ω

⇒ Which of the following is the fastest switching device?
JFET
BJT
MOSFET
Triode

⇒ Two voltages are -5 V and -10 V. In positive logic
-5 V is 1 and -10 V is 0
-10 V is 1 and -5 V is 0
-5 V is 1 in some circuits and 0 in others
-10 V is 1 in some circuits and 0 in others

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ The reverse saturation current of a diode does not depend on temperature.
TRUE
FALSE

⇒
Assertion (A): Electron concentration n, hole concentration p and charge concentration n_i are related by n_i² = np.
Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Choose the correct statement
The reflection coefficient (r) of a transmission line is greater than 1
r varies from 0 to ∞
r is less than or equal to 1
r varies from - ∞ to + ∞

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒
Assertion (A): The frequency of light used for photoelectric emission is high.
Reason (R): As per Einstein's equation 0.5 mv² < hf - U_w.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
15.9 radians/km
31.8 radians/km
63.6 radians/km
105.4 radians/km

⇒ Assuming a minimum angle of elevation of 5°, a geosynchronous satellite remains in line-of-sight for __________ percentage of Earth's surface.
30.3
42.4
50
25

⇒ Which of the follow
Voltage series feedback and decrease I/P impedance.
Voltage shunt feedback and decrease I/P impedance.
Voltage series feedback and increase I/P impedance.
Voltage shunt feedback and increase I/P impedance.

⇒
Assertion (A): Inverse Laplace transform can be found from P(s) by inversion integral.
Reason (R): The function f(t) is assumed to be zero for t < 0.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the CMOS circuit shown, where the gate voltage V_G of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC_0x(W/L), is 1mA. V^{-2Both the MOSFET are in saturation region
Both the MOSFET are in triode region
n-MOSFET is in triode and p-MOSFET is in saturation region
n-MOSFET is in saturation and p-MOSFET is in triode region}

⇒ In a oscillator, a sine wave generator starts at t = 0. It consist of
Pure sine wave
Pure cosine wave
Unity for t > 0
2∪(t) - 1

⇒ Sampling frequency
100 Hz
200 Hz
400 Hz
none of these

⇒ A line has an attenuation of 0.054 Np/m. The attenuation in decibels is
4.7 dB/m
0.47 dB/m
0.54 dB/m
5.4 dB/m

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ Consider the following statements about root locus
The intersection of root locus branches with the imaginary axis can be determined by the use of Routh criterion
Segments of real axis having an odd number of real axis open loop poles plus zeros to their right are not parts of root locus
The number of root locus branches terminating on infinity is always zero
Which of the above statements are correct?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only

⇒ Fourier analysis indicate that a square wave can be represented as
a fundamental sine wave and odd harmonics
a fundamental sine wave and even harmonics
a fundamental sine wave and harmonics
fundamental and subharmonic sine waves

⇒ In 8085 microprocessor, a RIM instruction is used to
disable the interrupts 7.5, 6.5, 5.5
enable the interrupts 7.5, 6.5, 5.5
read in the serial input data
none of the above

⇒
Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.
Reason (R): The aspect ratio is 4 : 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The symbol shown in figure represen
P-channel MOSFET
UJT with N-type base
N-channel DEMOSFET with internal zener protection
P-channel DEMOSFET with internal zener protection

⇒ Using 4-bit numbers (n = 4) if k = 0011₂, how is k expressed in 2's complement?
1011₂
1101₂
1100₂
0101₂

	List I		List II
A.	Flash converter ADC	1.	requires conversion time of a few μs
B.	Dual slope ADC	2.	requires DAC
C.	Successive approximation ADC	3.	minimizes the effect of power supply interference
		4.	requires complex hardware
		5.	is a tracking ADC

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math