Question is ⇒ Linear transistor circuits always operate in, Options are ⇒ (A) saturation region, (B) cut off region, (C) active region, (D) passive region, (E) , Leave your comments or Download question paper.

Question is ⇒ Linear transistor circuits always operate in, Options are ⇒ (A) saturation region, (B) cut off region, (C) active region, (D) passive region, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Linear transistor circuits always operate in
A.	saturation region [Wrong Answer]
B.	cut off region [Wrong Answer]
C.	active region [Correct Answer]
D.	passive region [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Pilot-carrier transmission is one in which
only one sideband is transmitted
one sideband and carrier are transmitted
only two sidebands are transmitted
two sidebands as well as a trace of carrier are transmitted

⇒

Assertion (A): Derivative control action is also called rate control and has an anticipatory character.

Reason (R): Derivative control amplifies noise signals.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ Two port network is said to be symmetrical if
Δ_h = 1
Z₁₁ = Z₂
A = Δ
all

⇒ In the given figure the time taken by the wave to make one round tri
10 ns
20 ns
30 ns
40 ns

⇒ Four messages band limited to W, W, 2W and 3W respectively are to be multiplex using Time Division Multiplexing (TDM). The minimum bandwidth required for transmission of this TDM signal is
W
3W
6W
7W

⇒ For the K map of the given figure the simplified Boolean expressio
ACD + ABD + BCD
ACD + BCD
ACD + ABD
none of the above

⇒ It is possible to use a freewheeling diode in
single phase half wave controlled rectifier as well as in single phase full wave controlled rectifier (M - 2 connection)
single phase half wave controlled rectifier but not in single phase full wave controlled rectifier (M - 2 connection)
single phase full wave controlled rectifier (M - 2 connection) but not in single phase half wave controlled rectifier
all controlled rectifier circuits

⇒ Noise generated in a resistor is also known as
partition noise
white noise
thermal noise
shot noise

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ Which of the following are included in the architecture of computer?

Addressing mode, design of CPU
Instruction set, data format
Secondary memory, operating system

Select the correct answer using the codes given below:
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ Which of the following is a passive component?
Semiconductor devices
Vacuum tube devices
Capacitors
All of the above

⇒ 0.1011₂ = __________ .
0.6875₁₀
0.6800₁₀
0.0100₁₀
0.5000₁₀

⇒ The first geostationary satellite launched in 1965 was called
ANIK
EARLY BIRD (Intelsat-I)
WESTAR
MOLNIYA

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒

Assertion (A): At room temperature the fermi level in p type semiconductor lies nearer to the valence band and in n type semiconductor it lies nearer to the conduction band.

Reason (R): At room temperature, the p type semiconductor is rich in holes and n type semiconductor is rich in electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

⇒ In figure, D₁ turns on
v_i is more than V₁
v_i is less than V₁
v_i is between V₁ and V₂
none of the above

⇒ The derating factor for a BJT transistor is about
0.5 mW/°C
2.5 mW/°C
10 mW/°C
25 mW/°C

⇒ How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?
3 dB
4 dB
5 dB
6 dB

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ For a two- port reciprocal network, the output open circuit voltage divided by the input current is equal to
B
Z₁₂
1/y₁₂
h₁₂

⇒ An ac bridge uses galvanometer as detector.
TRUE
FALSE

⇒ The colour code of a carbon resistance is yellow-violet-orange silver. The value of resistance is
57000 Ω ± 5%
47000 Ω ± 10%
47000 Ω ± 5%
57000 Ω ± 5%

⇒ Which circuit has its output signal from, the emitter?
Common base
Common emitter
Emitter follower
None of the above

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4