Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Laplace transform method enables us to find the response in |

A. | steady state [Wrong Answer] |

B. | transient state [Wrong Answer] |

C. | both steady and transient state [Correct Answer] |

D. | transient state provided forcing functions do not exist [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is

0.0416666666666667

1.25 A

0.25

6.25 A

⇒ An unmodulated voltage 10

*V*effective is applied to a dioxide detector in which load resistance is 4 x 10

^{-5}ohms. A micrometer shows that the rectified DC current in this resistance is 30

*A*. The efficiency of detection is

0.34

0.555

0.688

0.847

⇒ A PIN diode can be used

as a shunt mounted switch

as a series mounted switch

both as series or shunt mounted switch

non of the above

⇒ A periodic voltage

*v*(

*t*) = 1 + 4 sin ω

*t*+ 2 cos ω

*t*is applied across a 1 ohm resistance. The power dissipated is

1 W

11 W

21 W

24.5 W

⇒ If

*f*(

_{h}*t*) is the Hilbert transform of

*f*(

*t*), and

*f*(

*t*) is a real valued signal, the pre-envelope of

*f*(

*t*) is

*f*(

*t*) -

*jf*(

_{h}*t*)

*f*(

*t*) +

*jf*(

_{h}*t*)

*f*(

_{h}*t*) +

*jf*(

*t*)

*f*(

_{h}*t*) -

*jf*(

*t*)

⇒ In Pascal an array declaration provides information to the Pascal processor to enable it to

identify the variable as an array name

reserve memory locations to store all the components of array

check the values computed for subscripts expressions during program execution with the specified lower and upper limits of subscripts

all of the above

⇒ Which of the following can be used as a buffer amplifier?

CE

CC

CB

Both (a) and (c)

⇒ Consider the following statements about Rhombic antenna

- It is non resonant
- It is a broad band antenna
- It is ideally suited for HF transmission

1, 2, 3

1, 3 only

2, 3 only

1 only

⇒ If two networks are connected in series of individual Z parameter as Z

_{a}and Z

_{b}then equivalent Z is

[Z] = [Z

_{a}] + [Z

_{b}]

[Z] = [Z

_{a}] [Z

_{b}]

[Z] = [Z

_{a}]/[Z

_{b}]

[Z] = [Z

_{a}] - [Z

_{b}]

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be

0.05 MHz

1 MHz

2 MHz

4 MHz

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order

10

^{-3}amp

10

^{-6}amp

10

^{-9}amp

10

^{-12}amp

⇒ In the absence of noise, if C is channel capacity in bits/s, δ

*f*is channel bandwidth in Hz and N is number of coding levels. Then

C = log

_{2}N

C = (δ

*f*) log

_{2}N

C = 2 (δ

*f*) log

_{2}N

C = 0.5 (δ

*f*) log

_{2}N

⇒ Natural commutation can be used in :

DC circuits only

AC circuits only

both AC and DC circuits

none of the above

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.

cut off, saturation

saturation, active

saturation, cut off

active saturation

⇒ In figure the phase

will be 90° at ω = 0 and 0° at ω = ∞

will be 0° at ω = 0 and 90° at ω = ∞

will be 45° at ω = 0 and 0° at ω = ∞

will be 45° at ω = 0 and 90° at ω = ∞

⇒ Which is correct for a driving point function?

If the real part of a pole or zero is zero, that pole must be simple

If the real part of a pole or zero is zero, that pole or zero must be simple

If the real part of a zero is zero, that pole or zero must be simple

If the real part of a zero is zero that zero must be simple

⇒ ALU carries out

arithmetic operations

logic operations

both arithmetic and logic operations

none of the above

⇒ Consider the following DO statement in FORTRAN 77

6

1

8

⇒ The integral of unit step function is a ramp of slope unity.

TRUE

FALSE

⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as

an open-circuit

a short-circuit

a pure resistance

all of the above

⇒ If a class C power amplifier has an input signal with frequency of 200 kHz and the width of collector current pulses of 0.1 ms, then the duty cycle of the amplifier will be

0.01

0.02

0.1

0.2

⇒ The IF amplifier in a superheterodyne receiver is

single-stage single-timed amplifier

two stage of single tuned amplifier

double tuned amplifier

class-C amplifier

⇒ Decimal number 9 in gray code =

1100

1101

110

1111

⇒ The binary number 101100.110 in octal number will be

152.6

154.6

145.6

174.6

⇒ An

*npn*transistor has a Beta cutoff frequency

*f*

_{β}of 1 MHz, and a common emitter short circuit low frequency current gain β

_{0}of 200. It unity gain frequency

*f*

_{T}and the alpha cut off frequency

*f*

_{a2}respectively are

200 MHz, 201 MHz

200 MHz, 199 MHz

199 MHz, 200 MHz

201 MHz, 200 MHz

⇒ In a class C operation

V

_{CC}is much larger than V

_{CE(sat)}

V

_{CC}is much smaller than V

_{CE(sat)}

V

_{CC}and V

_{CE(sat)}are nearly equal

none of the above

⇒ The number of storage classes in C is

2

3

4

6

⇒ To plot frequency spectrum we draw two graphs

*viz*|F

*| versus frequency and φ*

_{n}*versus frequency.*

_{n}TRUE

FALSE

⇒ A capacitor can be represented by a capacitance and resistance in parallel. For a good capacitor, this parallel resistance should be

negligible

low

high

very high

⇒ In a lead acid battery

the numbers of positive and negative plates are equal

the number of positive plates may be equal to or more than the number of negative plates

the number of positive plates is more than the number of negative plates

the number of negative plates is more than the number of positive plates