Question is ⇒ Kirchoff's laws are applicable to, Options are ⇒ (A) dc only, (B) ac sinusoidal wave only, (C) dc and ac sinusoidal waves, (D) all wave shapes, (E) , Leave your comments or Download question paper.

Question is ⇒ Kirchoff's laws are applicable to, Options are ⇒ (A) dc only, (B) ac sinusoidal wave only, (C) dc and ac sinusoidal waves, (D) all wave shapes, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Kirchoff's laws are applicable to
A.	dc only [Wrong Answer]
B.	ac sinusoidal wave only [Wrong Answer]
C.	dc and ac sinusoidal waves [Wrong Answer]
D.	all wave shapes [Correct Answer]
View Answer 3 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Instruction cycle is the time required to complete the execution of an instruction.
TRUE
FALSE

⇒ Figure shows the self bias circuit for CE amplifier and its equivalent circuit. V_BB and R_B respectively
10 V and 4 k ohm
5 V and 4 k ohm
2 V and 4 k ohm
2 V and 10 k ohm

⇒ If the temperature of an extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density is doubled
the minority carrier density is doubled
the minority carrier density becomes 4 times the original value
both the majority and minority carrier densities double

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ The dominant mode in a rectangular wave-guide is
TE₀₁
TM₀₁
TE₁₀
TM₁₁

⇒ The fabrication of microstrip line is done by
photo etching
printed circuit technique
oxidation
cladding

⇒ Y = A + A B is the same as
Y = AB
Y = A + B
Y = A + B
Y = A + B

⇒ Higher value of ripple factor indicates
poor rectification
ideal rectification
r.m.s. value to peak value
none of the above

⇒ A 16:1 multiplexer has 4 select input lines.
TRUE
FALSE

⇒ Higher order active filters are used for variable
bandwidth
gain in the pass band
impedance
roll off rate

⇒ Which has the lowest propagation delay time?
ECL
TTL
CMOS
PMOS

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The number of branches of root locus plot is equal to
the number of roots of characteristic equation
double the number of roots of characteristic equation
the number of roots of characteristic equation minus one
the number of roots of characteristic equation plus one

⇒ The initial contents of ACC and CY in 8085 are

CY = 1
ACC = 10000001

After instruction RAL is executed once the contents of CY and ACC respectively will be
1 and 00000011
0 and 00000011
1 and 00000001
0 and 00000001

⇒ The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

Program counter
Processor register
Certain status conditions

Select the correct answer using the codes given below :
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ In an FM system, when the AF is 500 Hz and the AF voltage is 2.4 V, the deviation is 4.8 kHz. If the AF voltage is now increased to 7.2 V, the new deviation will be
4.8 kHz
9.6 kHz
14.4 kHz
28.8 kHz

⇒

Assertion (A): Logical group of instructions contains instructions for logic operations.

Reason (R): Data transfer group instruction is basically a copying instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Low frequency boost can be easily compensated by
attenuating the frequencies from 0 to 1.25 MHz
using an appropriate de-emphasis circuit in the receiver
using an appropriate pre-emphasis circuit in the transmitter
none

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ The materials which become polarized on the application of mechanical stress are called piezoelectric.
TRUE
FALSE

⇒ Which of the following buses does not exist in 8085?
Data bus
Address bus
Control bus
Exchange bus

⇒

Match the following:

	Microwave Measuring Instruments		Measurements Effected
A.	Bolometer	1.	Reflection coefficients
B.	VSWR meter	2.	Half power beam widths
C.	Cavity wave meter	3.	Microwave power
D.	Pattern recorder	4.	Microwave frequency

A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2

⇒ Wired AND connection can be used in TTL with totem pole output.
TRUE
FALSE

⇒ The inverse Laplace transform of 1/(s - a)² is
e^at
t e^at
t² e^at
e^at/t

⇒ The difference between sequential and combinational circuits is
Combinational circuits store bits
Combinational circuits have memory
Sequential circuits store bits
Sequential circuits have memory

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ The FM broadcast band is from
550 to 1600 kHz
88 to 108 kHz
88 to 108 MHz
1600 kHz to 59.75 MHz

⇒ The voltage of single phase supply to residential consumers in India is
400 V
230 V
2.2 kV
11 kV

⇒ Which of the following is a circularly polarized antenna?
Horn
Dipole
Helical
Pyramidal

⇒ Television signals are propagated as ground waves.
TRUE
FALSE