Question is ⇒ Kirchoff's laws are applicable to, Options are ⇒ (A) steady state conditions only, (B) transient conditions only, (C) both steady state and transient condition, (D) both steady state and transient condition but with some constraints, (E) , Leave your comments or Download question paper.

Question is ⇒ Kirchoff's laws are applicable to, Options are ⇒ (A) steady state conditions only, (B) transient conditions only, (C) both steady state and transient condition, (D) both steady state and transient condition but with some constraints, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Kirchoff's laws are applicable to
A.	steady state conditions only [Wrong Answer]
B.	transient conditions only [Wrong Answer]
C.	both steady state and transient condition [Correct Answer]
D.	both steady state and transient condition but with some constraints [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ammeter has a resistance of 50 ohms and a shunt of 0.01 Ω. The deflection is θ. If the shunt resistance is increased to 0.02 Ω, the deflection will be.
θ
2θ
0.5θ
0.25θ

⇒ An 8085 microprocessor is operating at 2 MHz frequency and executes the following progr
12
13
14
15

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒ A stepper motor is essentially
a synchronous motor
induction motor
dc motor
either (b) or (c)

⇒ Which of the following finds application in pocket calculators?
TTL
CMOS
ECL
Both (a) and (c)

⇒ The effective value of the waveform in the given figur
5
2.5
2.5
5.0

⇒ In a 7 segment LED display, the minimum number of segments is activated when the input decimal number is
0
1
2
3

⇒ At absolute temperature
the forbidden energy gap in germanium is higher than that in silicon
the forbidden energy gap in germanium and silicon are equal
the forbidden energy gap in silicon is higher than that in germanium
none of the above

⇒ Two sinusoidal signals of same amplitude and frequencies 10 kHz and 10.1 kHz are added together. The combined signal is given to an ideal frequency detector. The output of the detector is
0.1 kHz sinusoidal
10.1 kHz sinusoidal
a linear function
a constant

⇒ For dc the current through coupling capacitor in CE amplifier circuit is
very high
high
low
zero

⇒ Which one of the following power amplifier has the maximum efficiency?
Class A
Class B
Class AB
Class C

⇒ A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is
10 sin (200t + 90°)
10 sin (200t - 90°)
10 sin(1000t + 90°)
10 sin (1000t - 90°)

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3

⇒ The complete video signal consists of
video signal and synchronising pulses
video signal, synchronising pulses and blanking pulses
video signal corresponding to picture information only
video signal and blanking pulses

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ In CE amplifier circuit, voltage gain is directly proportional to
β
collector supply voltage
base resistance
none of the above

⇒ The shot circuit admittance matrix of a two port network is
non-reciprocal and passive
non-reciprocal and active
reciprocal and passive
reciprocal and active

⇒ The electrical power to a megger is provided by
battery
inverter
permanent magnet dc generator
ac generator

⇒ A microwave connector should have high SWR.
TRUE
FALSE

⇒ In voltage amplifiers, the load resistance
should be a small as possible
should be as large as possible
must be equal to output impedance
must be half of output impedance

⇒ When a semiconductor bar is heated at one end, a voltage across the bar is developed. If the heated is positive the semiconductor is
P-type
n-type
intrinsic
highly degenerate

⇒ Two sinusoidal signals of equal amplitude and frequency are applied to X and Y plate of CRO respectively. The observed Lissajous pattern is a straight line. The phase shift between signals is
zero
90°
either zero or 180°
either 90° or 270°

⇒ The Fourier series of a real periodic function has only

Cosine terms if it is even
Sine terms if it is even
Cosine terms if it is odd
Sine terms if it is odd

Which of the above statements are correct?
(1) and (4)
(1) and (2)
(2) and (4)
(2) and (3)

⇒ In order to obtain triangular pulses at the output of the circuit in the figure, the input should
grounded
a square wave
Triangular wave
Trigger

⇒

Assertion (A): An artificial transmission line can be used as a pulse generator.

Reason (R): A pulse function is used very frequently in network analysis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ A FET is to be operated as voltage variable resistor. For this drain to source voltage V_DS should be,
74
= V_P
< V_P
> V_P

⇒ A trigonometric function is synonyms to
orthogonal function
triangular function
singular function
none of the above

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒

Match the following:

	List I (F.T and F.S)		List II (Properties)
A.	Fourier Series	1.	Discrete, Periodic
B.	Fourier Transform	2.	Continuous, Periodic
C.	Discrete Time Fourier	3.	Discrete aperiodic
D.	Discrete Fourier Transform	4.	Continuous, aperiodic

A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1
A-1, B-4, C-2, D-3