Question is ⇒ Karnaugh map is used to, Options are ⇒ (A) minimise the number of flip flops in a digital circuit, (B) minimise the number of gates only in a digital circuit, (C) minimise the number of gates and fan in a digital circuit, (D) design gates, (E) , Leave your comments or Download question paper.

Question is ⇒ Karnaugh map is used to, Options are ⇒ (A) minimise the number of flip flops in a digital circuit, (B) minimise the number of gates only in a digital circuit, (C) minimise the number of gates and fan in a digital circuit, (D) design gates, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Karnaugh map is used to
A.	minimise the number of flip flops in a digital circuit [Wrong Answer]
B.	minimise the number of gates only in a digital circuit [Correct Answer]
C.	minimise the number of gates and fan in a digital circuit [Wrong Answer]
D.	design gates [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A step voltages is applied to RLC series circuit having R = 2 Ω, L = 1 H and C = 1 F. The transient current response will be
over damped
critically damped
under damped
any of the above depending the magnitude of voltage

⇒ For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.
TRUE
FALSE

⇒ The fluctuation in the received signal strength at the receiver of a random variation in the received signal is known as
fluctuation
fading
absorption
cycling

⇒ e^-3^t is a
energy signal
power signal
Both (a) and (b)
none

⇒ In ac bridge measurements, 'Wagner ground' means
a special RC connection to eliminate stray magnetic effects
a special RC connection to eliminate stray capacitance effects
an unwanted and unintended ground connection
a large metal plate buried in ground connected to one corner of bridge

⇒ In the given figure the reflected voltage wave after first reflectio
18 V
-18 V
30 V
-30 V

⇒

Assertion (A): A half wavelength line can be used as a 1 : 1 transformer.

Reason (R): The input impedance of a half wavelength line is equal to load impedance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is invalid in Basic?
A ** B - C
5.2 ** 4.3
5.2 ** (- 4.3)
(- 5.2) ** (4.3)

⇒ Which of the following antenna is best guided by a waveguide?
Biconical
Horn
Helical
Dish

⇒ Discrete transistors T₁ and T₂ having maximum collector current rating of 0.75 amp are connected in parallel as shown in the figure, this combination is treated as a single transistor to carry a total current of 1 ampere, when biased with self bias circuit. When the circuit is switched on, T₁ draws 0.55 amps and T₂ draws 0.45 amps. If the supply is kept on continuously, ultimately it is very likely
Both T₁, and T₂ get damaged
Both T₁, and T₂ will be safe.
T₁ Will get damaged and T₂ will be safe
T₂ will get damaged and T₁, will be safe.

⇒ The circuit shown in figure
low pass filter
high pass filter
band pass filter
band stop filter

⇒ Large scale integration refers to
more than 50 gates on the same chip
more than 80 gates on the same chip
more than 100 gates on the same chip
none of the above

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ Which of the following is best suited for parity checking and parity generation?
AND, OR, NOT gates
XOR, Exclusive NOR gate
NAND gates
NOR gates

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ 10's complement of 16₁₀ is
83₁₀
84₁₀
38₁₀
48₁₀

⇒ The properties of FETs closely resemble those of a
thermionic valve
P-N-P transistor
N-P-N transistor
UJT

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In figure, S is closed at t = 0. At t = t₁, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080

⇒ Voltage 1 + 2 sin ωt is applied to the circuit shown be
0 volt
2 volts
-2 volts
-3 volts

⇒ In VCR, the chrominance signal's frequency is
up converted during recording and down converted during playback
down converted during recording and up converted during playback
not changed during recording and playback
any of the above depending on VCR system

⇒ In a self bias circuit for CE amplifier the collector supply voltage is made twice. The collector current will
decrease
increase
remain the same
increase or decrease

⇒

Assertion (A): In an automobile the amount of fuel admitted to the engine is adjusted as per the difference between desired and actual speed.

Reason (R): The control signal is the amount of fuel to be admitted to the engine.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Spontaneous polarization occurs in ferroelectric materials.
TRUE
FALSE

⇒

Assertion (A): TTL uses multiple emitter transistor.

Reason (R): Multiple emitter transistors with about 60 emitters have been developed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In broadside array
the principle direction radiation is perpendicular to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and also to the plane containing the array elements
the principle direction radiation is parallel to the array axis and perpendicular to the plane containing the array elements
the principle direction radiation is perpendicular to the array axis and parallel to the plane containing the array elements

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2 and 3 only
3 and 4 only